多喷嘴带相差射流冲击传热的数值模拟

耿丽萍; 许庆功; 郑传波; 周静伟

doi:10.3969/j.issn.0438-1157.2014.z1.039

您当前的位置：

首页 >

文章列表页 >

多喷嘴带相差射流冲击传热的数值模拟

流体力学与传递现象 | 更新时间：2025-12-10

- 多喷嘴带相差射流冲击传热的数值模拟
- Numerical simulations of impinging heat transfer characteristics for multi-pulsating jets with phase difference
- 化工学报 2014年第S1期页码：240-244
- 作者机构：
  
  1. 中国计量学院热能工程系,浙江,杭州,310018
  2. 洛阳理工学院计算机与信息工程系,河南,洛阳,471023
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.z1.039
  中图分类号： K124
- 网络首发：2014-05-30，
  
  纸质出版：2014-05-30
- 稿件说明：
移动端阅览
耿丽萍, 许庆功, 郑传波, 等. 多喷嘴带相差射流冲击传热的数值模拟[J]. 化工学报, 2014,(S1):240-244.

GENG Liping, XU Qinggong, ZHENG Chuanbo, et al. Numerical simulations of impinging heat transfer characteristics for multi-pulsating jets with phase difference[J]. CIESC Journal, 2014, (S1): 240-244.
耿丽萍, 许庆功, 郑传波, 等. 多喷嘴带相差射流冲击传热的数值模拟[J]. 化工学报, 2014,(S1):240-244. DOI： 10.3969/j.issn.0438-1157.2014.z1.039.

GENG Liping, XU Qinggong, ZHENG Chuanbo, et al. Numerical simulations of impinging heat transfer characteristics for multi-pulsating jets with phase difference[J]. CIESC Journal, 2014, (S1): 240-244. DOI： 10.3969/j.issn.0438-1157.2014.z1.039.

摘要

采用数值模拟的方法对带相差的多喷嘴射流冲击传热进行数值模拟，分别得到不同相差和不同射流频率条件下的冲击传热效果。结果显示，在不同的射流喷射模式下，按相差顺序增加方式（B型）喷出的射流传热效果最好，两喷嘴间的相差为0°～180°之间时，传热板的传热效果随着相差角度的增加，传热效果得到增强，且在相差为120°时，整个传热板传热效果最均匀；在频率为0～10Hz时，频率越大，整个传热板传热越均匀，但频率的影响小于相差及喷射模式的影响。

Abstract

A series of numerical simulations for multi-pulsating jets with phase difference are carried out in order to obtain impinging heat transfer characteristics. The results are compared with changed phase difference in jet modes and values and pulse frequency. Jet modes include the symmetrically increasing phase difference (mode A)

the gradually increasing phase difference (mode B) and alternative phase difference (mode C). It can be found that mode B with gradually increasing phase mode has the best heat transfer characteristics within this research scope. When the phase difference lies between 0°-180°

the heat transfer characteristics become stronger with the increase of phase difference. When the phase difference is 120°

the heat transfer characteristics are best-distributed on the whole plate. Such well-distribution of heat transfer is also influenced by frequency. And the heat transfer characteristics are better-distributed when the frequency increase in the range of 0-10Hz. However

the influence of frequency is less than those of phase difference in jet modes and values.

关键词

Keywords

references

浏览量

317

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

涡产生器翼高对管翅式换热器流动与传热的影响

最小?损优化方法在椭圆换热管内的应用

LNG输送管道耦合传热的数值模拟

新型独立B型液化天然气船围护系统及蒸发率计算

带有突扩比的新型流道结构对海水激活电池性能的影响