泡沫陶瓷填料旋转填充床微观混合性能

张文洁; 初广文; 罗勇; 向阳; 邹海魁; 陈建峰

doi:10.3969/j.issn.0438-1157.2014.08.018

您当前的位置：

首页 >

文章列表页 >

泡沫陶瓷填料旋转填充床微观混合性能

流体力学与传递现象 | 更新时间：2025-12-10

- 泡沫陶瓷填料旋转填充床微观混合性能
- Micromixing in rotating packed bed with ceramic foam packing
- 化工学报 2014年第8期页码：2976-2980
- 作者机构：
  
  北京化工大学教育部超重力工程研究中心,北京,100029
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.08.018
  中图分类号： Q027.3TQ051.1
- 网络首发：2014-08-05，
  
  纸质出版：2014-08-05
- 稿件说明：
移动端阅览
张文洁, 初广文, 罗勇, 等. 泡沫陶瓷填料旋转填充床微观混合性能[J]. 化工学报, 2014,(8):2976-2980.

ZHANG Wenjie, CHU Guangwen, LUO Yong, et al. Micromixing in rotating packed bed with ceramic foam packing[J]. CIESC Journal, 2014, (8): 2976-2980.
张文洁, 初广文, 罗勇, 等. 泡沫陶瓷填料旋转填充床微观混合性能[J]. 化工学报, 2014,(8):2976-2980. DOI： 10.3969/j.issn.0438-1157.2014.08.018.

ZHANG Wenjie, CHU Guangwen, LUO Yong, et al. Micromixing in rotating packed bed with ceramic foam packing[J]. CIESC Journal, 2014, (8): 2976-2980. DOI： 10.3969/j.issn.0438-1157.2014.08.018.

摘要

采用碘化物-碘酸盐平行竞争反应为工作体系，以离集指数（XS）表征微观混合性能，实验考察了物料体积流量、H+浓度、旋转填充床转速、物料体积流量比等对两种不同孔径的新型整体泡沫陶瓷填料旋转填充床的微观混合性能的影响。结果表明，孔径较小的泡沫陶瓷填料更利于微观混合；H+浓度、进料体积流量比的增加会导致XS增加；而旋转填充床转速、进料流量的增大都可使XS下降。在实验研究的基础上，利用团聚模型计算泡沫陶瓷填料旋转填充床微观混合时间（tm），得到tm范围为0.385～8.55 ms。与传统不锈钢丝网填料对比，泡沫陶瓷填料tm最小值（0.385 ms）低于不锈钢丝网填料的tm最小值（1.6 ms），表明泡沫陶瓷填料的微观混合性能优于传统不锈钢丝网填料。

Abstract

Two kinds of ceramic foam packing with different apertures were used in a rotating packed bed (RPB). Micromixing efficiency in the RPB was experimentally studied by a parallel competing iodide-iodate reaction system

and segregation index (XS) was used to represent the efficiency. Effects of volumetric flow rate

concentration of H+

rotational speed

and volumetric flow ratio on the micromixing efficiency were investigated. Experimental results show that the ceramic foam packing with smaller aperture is better for micromixing. As concentration of H+ and volumetric flow ratio increase

XS increases

while it decreases with the increase of rotational speed and fluid flow rate. The micromixing time tm is calculated using incorporation model based on experimental results and the range of tm of ceramic foam packing is from 0.385 ms to 8.55 ms. Compared with traditional stainless steel mesh packing

the minimum value of tm of ceramic foam packing (0.385 ms) is much less than that of stainless steel mesh packing (1.6 ms). It means that ceramic foam packing presents better micromixing performance.

关键词

Keywords

references

浏览量

314

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

装填不同填料的管式反应器的微观混合性能

基于磁力搅拌的微型CSTR流动特征及微观混合性能

新疆高钙煤混烧对灰中含钙矿物熔融特性影响

外热式回转窑颗粒运动传热实验研究

硫基光催化剂在高效光催化制氢中研究进展