In this paper

pilot test was carried out on a 30 t·d-1 desalination device with multi-effect and operated at low temperature by evaporation of seawater

which was designed and constructed in the earlier phase of a project.Using the results obtained

the relationships between various key parameters

including motive steam

operating maximum temperature

temperature difference

spray density

extraction method of non-condensing gas

flow of steam ejector

gained output ratio

and product conductivity

were analyzed.Based on these test results

the conclusions drawn are as follows:(1)device stability

productivity of water and GOR are strongly affected by the fluctuation of motive steam pressure;(2)temperature difference by optimal design of heat transfer is about 3℃

and the spray density between 240 L·(m·h)-1 and 300 L·(m·h)-1 in desalination;(3)Water productivity increases by 3.64% when vacuum pump is operated from parallel mode changing to series mode;(4)application of thermal vapor compressor(TVC)can increase water productivity and gained output ratio(GOR)

at the same time can reduce system energy consumption.If the deviation between real running conditions and design value of the parameters was ≥20%

the injecting ratio will be reduced.The results obtained in this paper can be as a knowledge accumulation and design basis for design of large-scale

low-temperature

multi-effect seawater desalination devices.