高温除尘碳化硅膜的制备及其抗腐蚀特性

李冬燕; 魏巍; 韩峰

doi:10.11949/j.issn.0438-1157.20180960

您当前的位置：

首页 >

文章列表页 >

高温除尘碳化硅膜的制备及其抗腐蚀特性

材料化学工程与纳米技术 | 更新时间：2020-06-24

- 高温除尘碳化硅膜的制备及其抗腐蚀特性
- Preparation and corrosion resistance of SiC membrane using for dust removal in high temperature
- 化工学报 2019年70卷第1期页码：336-344
- 作者机构：
  
  1.南京科技职业学院化工与材料学院，江苏南京 210048
  2.南京膜材料产业技术研究院有限公司，江苏南京 211100
- 作者简介：
  
  李冬燕（1979—），女，副教授，ldy790319@163.com
- 基金信息：
  
  国家重点研发计划项目(2016YFC0204000);江苏高校青蓝工程项目;南京科技职业学院科研项目(NHKY-2016-01)
- DOI：10.11949/j.issn.0438-1157.20180960
  中图分类号： TQ 174.6
- 收稿：2018-08-27，
  
  修回：2018-10-25，
  
  纸质出版：2019-01-05
- 稿件说明：
移动端阅览
李冬燕, 魏巍, 韩峰. 高温除尘碳化硅膜的制备及其抗腐蚀特性[J]. 化工学报, 2019, 70(1): 336-344

LI Dongyan, WEI Wei, HAN Feng. Preparation and corrosion resistance of SiC membrane using for dust removal in high temperature[J]. CIESC Journal, 2019, 70(1): 336-344
李冬燕, 魏巍, 韩峰. 高温除尘碳化硅膜的制备及其抗腐蚀特性[J]. 化工学报, 2019, 70(1): 336-344 DOI： 10.11949/j.issn.0438-1157.20180960.

LI Dongyan, WEI Wei, HAN Feng. Preparation and corrosion resistance of SiC membrane using for dust removal in high temperature[J]. CIESC Journal, 2019, 70(1): 336-344 DOI： 10.11949/j.issn.0438-1157.20180960.

摘要

采用喷涂法在碳化硅（SiC）支撑体上覆膜，根据碳化硅材料的氧化特性，设计了有氧烧结和氩气烧结随温度转换的组合烧结制度，并通过优化保温时间降低碳化硅陶瓷膜烧结成本。研究结果表明，新的烧结制度能有效地控制有氧烧结阶段产生的二氧化硅（SiO

）量，并促进其与烧结助剂氧化锆（ZrO

）等在气氛烧结阶段的反应，反应生成的锆英石相和添加莫来石相共同形成SiC颗粒连接颈部。制备的碳化硅陶瓷膜平均孔径为3.03 μm，气体通量为175 m

∙m

-2

∙h

-1

∙kPa

-1

。且在100℃的0.25 mol∙L

-1

的H

溶液和0.25 mol∙L

-1

的NaOH溶液中腐蚀6 h后，膜层表面形貌无明显变化，具有较强的抗腐蚀性能。

Abstract

Spray-coating was used to prepared silicon carbide (SiC) membranes on the surface of SiC supports

then the coated samples were sintered by switching sintering atmospheres (aerobic to argon) over different temperature ranges according to the oxidation characteristics of SiC

and the sintering cost of SiC ceramic membranes was reduced by optimizing the soaking time. The results revealed that the new sintering procedures can effectively control the oxidation of SiC in the aerobic sintering stage

and promoted its oxidation product silica （SiO

） reaction with the sintering aids such as zirconia (ZrO

) in the argon sintering stage. The average pore size of the prepared SiC ceramic membrane was 3.03 μm and the gas permeation was 175 m

·m

-2

·h

-1

·kPa

-1

. After etching for 6 h in 0.25 mol·L

-1

solution and 0.25 mol·L

-1

NaOH solution at 100℃

the surface morphology of the film has no obvious change and has strong corrosion resistance.

关键词

Keywords

references

Heidenreich S . Hot gas filtration—a review [J]. Fuel , 2013 , 104 : 83 - 94 .

Ding S Q , Zhu S M , Zeng Y P , et al . Fabrication of mullite-bonded porous silicon carbide ceramics by in situ reaction bonding [J]. J. Eur. Ceram. Soc ., 2007 , 27 : 2095 - 2102 .

Bai J G , Yang X H , Shi Y G , et al . Fabrication of directional SiC porous ceramics using Fe 2 O 3 as pore-forming agent [J]. Mater. Lett ., 2012 , 78 : 192 - 194 .

Han F. , Zhong Z X , Yang Y , et al . High gas permeability of SiC porous ceramics reinforced by mullite fibers [J]. J. Eur. Ceram. Soc ., 2016 , 36 : 3909 - 3917 .

Zhao L , Li X L , Sun W Q , et al . Experimental study on bag filtration enhanced by magnetic aggregation of fine particles from hot metal casting process [J]. Powder Technol ., 2018 , 327 : 255 - 267 .

Wang Q N , Bai Y Y , Xie J F , et al . Multi-scale polyimide/carbon fibers hybrid filters for hot gas filtration [J]. Mater. Sci. Forum ., 2015 , 814 : 464 - 469 .

Lupion M , Navarrete B , Alonso F B , et al . Hot gas filters for coal-based power generation systems: operating experiences [J]. Fuel , 2013 , 108 : 24 - 30 .

Sleboda T , Kane J , Wright R N , et al . The effect of thermomechanical processing on the properties of Fe-40 at.%Al alloy [J]. Mater. Sci. Eng. A , 2004 , 368 : 332 – 336 .

Fan X B , He Z B , Lin P , et al . Microstructure, texture and hardness of Al-Cu-Li alloy sheet during hot gas forming with integrated heat treatment [J]. Mater. Des ., 2016 , 94 : 449 - 456 .

Li J F , Lin H , Li J B . Factors that influence the flexural strength of SiC-based porous ceramics used for hot gas filter support [J]. J. Eur. Ceram. Soc ., 2011 , 31 : 825 - 831 .

Liu S F , Zeng Y P , Jiang D L . Fabrication and characterization of cordierite-bonded porous SiC ceramics [J]. Ceram. Int ., 2009 , 35 : 597 - 602 .

Ding S , Zeng Y P , Jiang D . In - situ reaction bonding of porous SiC ceramics [J]. Mater. Charact ., 2008 , 59 : 140 - 143 .

Li J F , Lin H , Li J B . Factors that influence the flexural strength of SiC-based porous ceramics used for hot gas filter support [J]. J. Eur. Ceram. Soc ., 2011 , 31 : 825 - 831 .

Wang M C , Dong X , Tao X , et al . Joining of various engineering ceramics and composites by a modified preceramic polymer for high-temperature application [J]. J. Eur. Ceram. Soc ., 2015 , 35 : 4083 - 4398 .

Ciora R J , Fayyaz B , Liu P K T , et al . Preparation and reactive applications of nanoporous silicon carbide membranes [J]. Chem. Eng. Sci ., 2004 , 59 : 4957 - 4965 .

Wach R A , Sugimoto M , Yoshikawa M . Formation of silicone carbide membrane by radiation curing of polycarbosilane and polyvinylsilane and its gas separation up to 250℃ [J]. J. Am. Ceram. Soc ., 2007 , 90 : 275 - 278 .

Kim Y H , Kim S R , Song B G , et al . Nanoporous SiC membrane derived from preceramic polymer [J]. Solid State Pheno ., 2007 , 12 : 1733 - 1736 .

Ding S Q , Zhu S M , Zeng Y P . Effect of Y 2 O 3 addition on the properties of reaction-bonded porous SiC ceramics [J]. Ceram. Int ., 2006 , 32 : 461 - 466 .

She J H , Ohji T , Kanzaki S . Oxidation bonding of porous silicon carbide ceramics with synergistic performance [J]. J. Eur. Ceram. Soc ., 2004 , 24 : 331 - 334 .

She J H , Yang J F , Kondo N , et al . High-strength porous silicon carbide ceramics by an oxidation-bonding technique [J]. J. Am. Ceram. Soc ., 2002 , 85 : 2852 - 2854 .

朱玉梅 , 靳正国 . 预氧化在SiC基陶瓷材料烧结中的作用 [J]. 天津大学学报 , 2006 , 36 : 769 - 772 .

Zhu Y M , Jin Z G . Effect of preoxidation on sintering of SiC - based ceramic materials [J]. J. Tianjin Univ ., 2006 , 36 : 769 - 772 .

Yang Y , Han F , Xu W Q , et al . Low-temperature sintering of porous silicon carbide ceramic support with SDBS as sintering aid [J]. Ceram. Int ., 2017 , 43 : 3377 - 3384 .

She J H , Ohji T , Deng Z Y , et al . Thermal shock behavior of porous silicon carbide ceramics [J]. J. Am. Ceram. Soc ., 2002 , 85 : 2125 - 2127 .

She J H , Deng Z Y , Daniel D J , et al . Oxidation bonding of porous silicon carbide ceramics [J]. J. Mater. Sci ., 2002 , 37 : 3615 – 3622 .

Han F , Zhong Z X , Yang Y , et al . High gas permeability of SiC porous ceramics reinforced by mullite fibers [J]. J.Eur. Ceram. Soc ., 2016 , 36 : 3909 - 3918 .

Ebadzadeh T , Majidian H , Salahi E . Effect of SiC additions on microstructure, mechanical properties and thermal shock behaviour of alumina–mullite–zirconia composites [J]. Mater. Sci. Eng. A , 2011 , 368 : 585 - 592 .

Lin Y J , Tsang , Chia P . Fabrication of mullite/SiC and mullite/zirconia/SiC composites by ‘dual’ in-situ reaction syntheses [J]. Mater. Sci. Eng. A , 2003 , 344 : 168 - 174 .

Dong S , Zhang X H , Zhang D Y , et al . Strong effect of atmosphere on the microstructure and microwave absorption properties of porous SiC ceramics [J]. J. Eur. Ceram. Soc ., 2018 , 38 : 29 - 39 .

Chen J W , Zhao H Z , Yu J , et al . Synthesis and characterization of reaction-bonded calcium alumino-titanate-bauxite-SiC composite refractories in a reducing atmosphere [J]. Ceram. Int ., 2018 , 44 : 15338 - 15345 .

Zhao X N , Yang J J , Xin H , et al . Improved dispersion of SiC whisker in nano hydroxyapatite and effect of atmospheres on sintering of the SiC whisker reinforced nano hydroxyapatite composites [J]. Mater. Sci. Eng. C , 2018 , 91 : 135 - 146 .

Yang H , Zhou P , Zhao H , et al . Corrosion of SiC layers on coated zirconia particles in wet atmosphere [J]. Ceram. Int ., 2018 , 44 : 12797 - 12804 .

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

煤热解过程分析与工艺调控方法

基于气/液相法的中空纤维无泡曝气膜传氧性能

液氢贮箱在轨排气的闪蒸特性与热力态调节规律研究

压力波强化横掠管束传热实验研究

烟气脱硫过程含硫量自适应预测与异常状态溯源方法