丙烷预冷混合制冷剂液化工艺原料气敏感性分析

潘红宇; 李玉星; 朱建鲁

doi:10.11949/j.issn.0438-1157.20150733

您当前的位置：

首页 >

文章列表页 >

丙烷预冷混合制冷剂液化工艺原料气敏感性分析

流体力学与传递现象 | 更新时间：2025-12-10

- 丙烷预冷混合制冷剂液化工艺原料气敏感性分析
- Sensibility analysis of feed gas in propane pre-cool mixed refrigerant liquefaction process feed gas
- 化工学报 2015年第S2期页码：186-191
- 作者机构：
  
  中国石油大学(华东)储建学院,山东,青岛,266580
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20150733
  中图分类号： Q026.1
- 网络首发：2015-08-31，
  
  纸质出版：2015-08-31
- 稿件说明：
移动端阅览
潘红宇, 李玉星, 朱建鲁. 丙烷预冷混合制冷剂液化工艺原料气敏感性分析[J]. 化工学报, 2015,(S2):186-191.

PAN Hongyu, LI Yuxing, ZHU Jianlu. Sensibility analysis of feed gas in propane pre-cool mixed refrigerant liquefaction process feed gas[J]. CIESC Journal, 2015, (S2): 186-191.
潘红宇, 李玉星, 朱建鲁. 丙烷预冷混合制冷剂液化工艺原料气敏感性分析[J]. 化工学报, 2015,(S2):186-191. DOI： 10.11949/j.issn.0438-1157.20150733.

PAN Hongyu, LI Yuxing, ZHU Jianlu. Sensibility analysis of feed gas in propane pre-cool mixed refrigerant liquefaction process feed gas[J]. CIESC Journal, 2015, (S2): 186-191. DOI： 10.11949/j.issn.0438-1157.20150733.

摘要

液化天然气液化后的体积仅为原体积的1/625

十分有利于运输和储存。丙烷预冷混合制冷剂液化工艺是目前最常用的天然气液化工艺

该工艺结合了级联式液化流程与混合制冷剂液化流程的优点

既高效又简单

目前世界上80%以上的基本负荷型天然气液化装置采用了此流程。由于实际情况中原料气的入口压力、温度、组分均存在变化的可能

需要针对工艺的原料气敏感性进行动态仿真分析。通过分别添加原料气压力、温度、组分的扰动

得到了各个工艺系统的动态响应。结果表明:当丙烷预冷混合制冷剂液化工艺分别存在原料气压力、温度、组分扰动时

各个系统均能在一段时间后重新恢复稳定

稳定时间为20~250 min。验证了丙烷预冷混合制冷剂液化工艺在原料气入口条件扰动时的稳定性和可靠性。

Abstract

After liquefied at low temperature

the volume of the natural gas is only 1/625 of its original volume

greatly convenient for its conveyance and storage.Propane pre-cooled mixed refrigerant process is the most common gas liquefaction process by now

which is a combination of cascading liquefaction and mixed-refrigerant liquefaction process.Efficient as well as simple

more than 80 percent of the basic duty natural gas liquefaction plants are using this process in the world.Because of the actual situation that the pressure

temperature and component are likely to change in the inlet feed gas

it is necessary to do dynamic simulation analysis of the sensitivity of the feed gas.By adding the perturbation of pressure

temperature

component on feed gas separately

the dynamic response of the respective process system is obtained.The results show that:when the perturbation of pressure

temperature

component respectively react on propane pre-cooled mixed refrigerant liquefaction process

each system can regain stability after a period of time

and the stabilization time ranges from 20 to 250 minutes.In this way

the stability and reliability of propane pre-cooled mixed refrigerant liquefaction process are verified when the perturbation of feed gas exists.

关键词

Keywords

references

浏览量

194

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

CO耐硫甲烷化MoS2/Si-ZrO2催化剂的失活原因研究

双混合制冷剂天然气液化过程实验分析

混合制冷剂中重烃对天然气液化流程的影响

天然气混输管网热值波动过程模拟

基于MCM-41的镍基甲烷化催化剂活性与稳定性