R134a在大深宽比微通道内流动沸腾传热机理研究

冯亚利; 江朱叶; 胡成玉; 杨小平; 张永海; 回方娇; 张志伟; 魏进家

doi:10.11949/0438-1157.20260629

您当前的位置：

首页 >

文章列表页 >

R134a在大深宽比微通道内流动沸腾传热机理研究

热力学 | 更新时间：2026-08-04

- R134a在大深宽比微通道内流动沸腾传热机理研究
- Study on flow boiling heat transfer mechanism of R134a in microchannels with high-aspect-ratio
- 化工学报 2026年
- 作者机构：
  
  1.西安交通大学化学工程与技术学院，陕西西安 710049
  2.中航光电科技股份有限公司，河南洛阳 471000
  3.氟氮化工新材料全国重点实验室，陕西西安 710049
- 作者简介：
  
  冯亚利（1985—），女，博士研究生，fengyali@jonhon.cn
  魏进家（1971—），男，博士，教授，jjwei@xjtu.edu.cn
- 基金信息：
- DOI：10.11949/0438-1157.20260629
  中图分类号： TQ 028.8
- 收稿：2026-05-07，
  
  修回：2026-07-31，
  
  录用：2026-08-04，
- 稿件说明：
移动端阅览
冯亚利, 江朱叶, 胡成玉, 等. R134a在大深宽比微通道内流动沸腾传热机理研究[J/OL]. 化工学报, 2026.

FENG Yali, JIANG Zhuye, HU Chengyu, et al. Study on flow boiling heat transfer mechanism of R134a in microchannels with high-aspect-ratio[J/OL]. CIESC Journal, 2026.
冯亚利, 江朱叶, 胡成玉, 等. R134a在大深宽比微通道内流动沸腾传热机理研究[J/OL]. 化工学报, 2026. DOI： 10.11949/0438-1157.20260629.

FENG Yali, JIANG Zhuye, HU Chengyu, et al. Study on flow boiling heat transfer mechanism of R134a in microchannels with high-aspect-ratio[J/OL]. CIESC Journal, 2026. DOI： 10.11949/0438-1157.20260629.

摘要

微通道流动沸腾传热是高功率、大面积芯片散热的有效技术途径。当前研究多聚焦于高质量通量工况，对低质量通量下、大深宽比微通道的研究相对较少。本文以R134a为工质，研究了质量通量（＜100 kg·m

-2

·s

-1

）及深宽比对微通道传热性能、两相压降及流型演变的影响。结果表明，深宽比及质量通量均对两相流型和传热性能有显著影响。在低质量通量下，深宽比为15的微通道（FG-15）传热系数最高（HTC: 15.4 kW·m

-2

·K

-1

）。在中高质量通量下，FG-5综合散热性能最优，其峰值HTC较FG-15提高11.6％，最大散热功率1543 W，热源温度仅71.4℃，且压降较FG-3降低30.6％。可视化观测表明，在给定热通量下，FG-15更易趋向环状流，HTC最高，但高热流下易发生局部干涸，导致临界热通量（CHF）最低；FG-5呈现典型弹状流；FG-3以离散泡状流为主，液相占比大，CHF最高但HTC最低。该现象解释了FG-5在中高热通量下的传热优势。本研究揭示了质量通量和几何结构对微通道流动沸腾性能的综合影响，为微通道散热器的优化设计提供了实验指导。

Abstract

Microchannel flow boiling heat transfer is an effective technical approach for heat dissipation of high-power

large-area chips. Current research mainly focuses on high mass flux conditions

while studies on microchannels with high-aspect-ratios under low mass flux conditions are relatively limited. In this paper

using R134a as the working fluid

the effects of mass flux (

100 kg·m

-2

·s

-1

) and aspect ratio on the boiling heat transfer performance

two-phase pressure drop

and flow pattern evolution of a copper-based microchannel heat sink are systema

tically investigated. The results show that both aspect ratio and mass flux significantly influence the two-phase flow pattern and heat transfer performance. Under low mass flux conditions

the microchannel with an aspect ratio of 15 (FG-15) achieves the highest HTC (15.4 kW·m

-2

·K

-1

). Under medium and high mass flux conditions

the FG-5 exhibits the best overall heat dissipation performance

with a peak HTC 11.6% higher than that of FG-15

a maximum heat dissipation power of 1543 W

a heat source temperature of only 71.4 °C

and a pressure drop reduction of 30.6% compared to FG-3. Visualization observations indicate that at a given heat flux

FG-15 tends toward annular flow

achieving the highest HTC but being prone to local dryout at high heat flux

resulting in the lowest critical heat flux (CHF). FG-5 exhibits typical slug flow

while FG-3 remains dominated by discrete bubbly flow with a large liquid fraction

yielding the highest CHF but the lowest HTC. These observations explain the heat transfer advantage of FG-5 under medium-to-high heat flux conditions. This study reveals the combined effects of mass flux and geometry on microchannel flow boiling performance

providing experimental guidance for the optimal design of microchannel heat sinks.

关键词

Keywords

references

Shang H Q , Xia G D , Cheng L X , et al . Comprehensive review of enhancement techniques and mechanisms for flow boiling in micro/mini-channels [J ] . Applied Thermal Engineering , 2025 , 258 : 124783 .

Huang C N , Kharangate C R . A new mechanistic model for predicting flow boiling critical heat flux based on hydrodynamic instabilities [J ] . International Journal of Heat and Mass Transfer , 2019 , 138 : 1295 - 1309 .

Zhang K , Yang J S , Huai X L , et al . Highly stable subcooled flow boiling enabled by an opposed wall jet design [J ] . International Journal of Heat and Mass Transfer , 2023 , 216 : 124562 .

Rohini A K , Choi W W , Kim S M . Subcooled flow boiling in multiple parallel rectangular micro-channel heat sink: Development of heat transfer correlation [J ] . Applied Thermal Engineering , 2024 , 250 : 123444 .

Ding T , Chen X X , Li Z Y , et al . A review of flow boiling heat transfer: Theories, new methods and emerging applications [J ] . Renewable and Sustainable Energy Reviews , 2025 , 215 : 115615 .

Bortolin S , Francescon A , Ribatski G , et al . Flow boiling of R134a and HFE-7000 in a single silicon microchannel with microstructured sidewalls [J ] . International Journal of Heat and Mass Transfer , 2021 , 179 : 121653 .

Ateş A , Çelik S , Yağcı V , et al . Flow boiling of dielectric fluid HFE–7000 in a minichannel with pin fin structured surfaces [J ] . Applied Thermal Engineering , 2023 , 223 : 120045 .

Wongpromma P , Wongwises S . Flow patterns and heat transfer characteristics in flow boiling of R-513A and R-134a refrigerant in open microchannel heat sinks [J ] . International Journal of Multiphase Flow , 2025 , 189 : 105237 .

Fang X D . A new correlation of flow boiling heat transfer coefficients based on R134a data [J ] . International Journal of Heat and Mass Transfer , 2013 , 66 : 279 - 283 .

Shah N , Mehta H B , Banerjee J . Synchronized visualization and thermal measurements of flow boiling in high-aspect-ratio microchannel with backflow controller [J ] . International Journal of Multiphase Flow , 2025 , 185 : 105140 .

Camarasa J , Vilarrubí M , Ibáñez M , et al . Experimental study of flow boiling cooling in a novel variable density pin–fin device [J ] . Applied Thermal Engineering , 2025 , 269 : 126023 .

Yang G , Zhang W C , Binama M , et al . Review on bubble dynamic of subcooled flow boiling-part b: Behavior and models [J ] . International Journal of Thermal Sciences , 2023 , 184 : 108026 .

Yin L F , Wang Y J , Jia L . Flow boiling instability of R134a in the large-area heat sink with interconnected parallel multi-minichannels [J ] . International Journal of Thermal Sciences , 2024 , 204 : 109193 .

Criscuolo G , Markussen W B , Meyer K E , et al . High heat flux flow boiling of R1234yf, R1234ze(E) and R134a in high aspect ratio microchannels [J ] . International Journal of Heat and Mass Transfer , 2022 , 186 : 122215 .

Deng D X , Zeng L , Sun W . A review on flow boiling enhancement and fabrication of enhanced microchannels of microchannel heat sinks [J ] . International Journal of Heat and Mass Transfer , 2021 , 175 : 121332 .

Cheng L X , Xia G D . Fundamental issues, mechanisms and models of flow boiling heat transfer in microscale channels [J ] . International Journal of Heat and Mass Transfer , 2017 , 108 : 97 - 127 .

Zou Y , Li J Y , Li T Y , et al . Experimental study of the effect of surface roughness on the heat transfer characteristics of subcooled flow boiling in a narrow rectangular channel [J ] . Annals of Nuclear Energy , 2025 , 210 : 110842 .

Li Y , Wu H Y , Yao Y P . Enhanced flow boiling heat transfer and suppressed boiling instability in counter-flow stepped microchannels [J ] . International Journal of Heat and Mass Transfer , 2022 , 194 : 123025 .

Qiu J C , Zhao Q , Lu M X , et al . Experimental study of flow boiling heat transfer and pressure drop in stepped oblique-finned microchannel heat sink [J ] . Case Studies in Thermal Engineering , 2022 , 30 : 101745 .

Cui P L , Liu Z Y , Wu H Y . Subcooled flow boiling in ultrahigh-aspect-ratio microchannels for high heat flux cooling [J ] . International Communications in Heat and Mass Transfer , 2024 , 151 : 107221 .

Cheng X , Wu J J . Geometry-metrics-dependent flow boiling characteristics in rectangular microchannels [J ] . International Journal of Heat and Mass Transfer , 2024 , 218 : 124733 .

Yin L F , Xu R N , Jiang P X , et al . Subcooled flow boiling of water in a large aspect ratio microchannel [J ] . International Journal of Heat and Mass Transfer , 2017 , 112 : 1081 - 1089 .

Zhang Z Q , Jia L , Dang C , et al . Experimental study on flow boiling characteristics of R134a inside high-heat-flux microchannels [J ] . International Journal of Heat and Fluid Flow , 2024 , 107 : 109372 .

Dalkılıç A S , Özman C , Sakamatapan K , et al . Experimental investigation on the flow boiling of R134a in a multi-microchannel heat sink [J ] . International Communications in Heat and Mass Transfer , 2018 , 91 : 125 - 137 .

Thiangtham P , Keepaiboon C , Kiatpachai P , et al . An experimental study on two-phase flow patterns and heat transfer characteristics during boiling of R134a flowing through a multi-microchannel heat sink [J ] . International Journal of Heat and Mass Transfer , 2016 , 98 : 390 - 400 .

Yan Q , Jia L , An Z J , et al . A comprehensive criterion for slug-annular flow transition based on flow boiling of R134a in microchannels [J ] . International Communications in Heat and Mass Transfer , 2019 , 105 : 1 - 9 .

Li X J , Jia L . The investigation on flow boiling heat transfer of R134a in micro-channels [J ] . Journal of Thermal Science , 2015 , 24 ( 5 ): 452 - 462 .

Yuan C , Jin S H , Li H Q , et al . Experimental study of R134a and its alternative mixture R450A flow boiling in a microchannel tube [J ] . International Communications in Heat and Mass Transfer , 2024 , 159 : 108319 .

Dang C , Jia L , Xu M C , et al . Experimental study on flow boiling characteristics of pure refrigerant (R134a) and zeotropic mixture (R407C) in a rectangular micro-channel [J ] . International Journal of Heat and Mass Transfer , 2017 , 104 : 351 - 361 .

Widgington J J , Ivanov A , Karayiannis T G . Flow boiling heat transfer in a single microchannel and comparison with correlations [J ] . International Journal of Heat and Mass Transfer , 2025 , 251 : 127388 .

Moffat R J . Describing the uncertainties in experimental results [J ] . Experimental Thermal and Fluid Science , 1988 , 1 ( 1 ): 3 - 17 .

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

楔形歧管微通道流动与沸腾换热

CO2管内流动沸腾换热模型评价研究

水平微细管内CO2流动沸腾换热特性

新型制冷剂R1234ze(E)水平圆管内流动沸腾换热特性

面向高效C2H2/C2H4分离的非互穿三维COFs高通量筛选