管壳式相变储热器性能快速预测研究

徐阳; 郑章靖; 李明佳

doi:10.11949/0438-1157.20190509

您当前的位置：

首页 >

文章列表页 >

管壳式相变储热器性能快速预测研究

流体力学与传递现象 | 更新时间：2020-06-24

- 管壳式相变储热器性能快速预测研究
- Performance prediction of shell-and-tube latent heat thermal energy storage unit
- 化工学报 2019年70卷第S2期页码：237-243
- 作者机构：
  
  1.中国矿业大学电气与动力工程学院，江苏徐州 221116
  2.中国矿业大学江苏省高效储能技术与装备工程实验室，江苏徐州 221116
  3.西安交通大学能源与动力工程学院，热流科学与工程教育部重点实验室，陕西西安 710049
- 作者简介：
  
  徐阳(1989—)，女，博士，讲师，xuyangcumt@cumt.edu.cn
  郑章靖(1986—)，男，博士，讲师，zhengzj@ cumt.edu.cn
- 基金信息：
  
  国家自然科学基金项目(51806237);江苏省自然科学基金项目(BK20170283);中国博士后科学基金项目(2019M652002)
- DOI：10.11949/0438-1157.20190509
  中图分类号： TK 124
- 收稿：2019-05-15，
  
  修回：2019-06-11，
  
  纸质出版：2019-09-05
- 稿件说明：
移动端阅览
徐阳, 郑章靖, 李明佳. 管壳式相变储热器性能快速预测研究[J]. 化工学报, 2019, 70(S2): 237-243

XU Yang, ZHENG Zhangjing, LI Mingjia. Performance prediction of shell-and-tube latent heat thermal energy storage unit[J]. CIESC Journal, 2019, 70(S2): 237-243
徐阳, 郑章靖, 李明佳. 管壳式相变储热器性能快速预测研究[J]. 化工学报, 2019, 70(S2): 237-243 DOI： 10.11949/0438-1157.20190509.

XU Yang, ZHENG Zhangjing, LI Mingjia. Performance prediction of shell-and-tube latent heat thermal energy storage unit[J]. CIESC Journal, 2019, 70(S2): 237-243 DOI： 10.11949/0438-1157.20190509.

摘要

为了构建一种具有普适性的完全熔化时间预测公式，引入一种无量纲储热时间的概念，定义为实际储热时间与基准储热时间的比值。基准储热时间通过静态近似法获得，可以基本反映完全熔化时间与其影响参数的非线性关系，有效降低了无量纲储热时间拟合关联式的非线性度，并扩大了其适用范围。针对套管式固液相变储热器，通过数值模拟方法分析了Stefan数、无量纲长度以及外内径比率三个参数对无量纲储热时间的影响规律，并拟合了关联式。结果显示，所构建的经验关联式具有较好的应用范围和预测准确度；在考虑的参数范围内，快速预测结果的误差可以控制在10%以内。所提出的无量纲储热时间及其关联式构建方法可推广应用于其他固液相变储热器。

Abstract

In order to construct a universal prediction method for complete melting time

a concept of dimensionless heat storage time is introduced

which is defined as the ratio of actual melting time to referenced melting time. The referenced melting time obtained by static approximation method can basically reflect the non-linear relationship between the melting time and its influencing parameters

which effectively reduces the non-linearity of dimensionless melting time fitting correlation and enlarges its application scope. The influence of Stefan number

dimensionless length and ratio of outer diameter to inner diameter on dimensionless melting time of shell-and-tube latent heat thermal energy storage unit was analyzed by numerical simulation method

and the correlation equation was fitted. The results show that the empirical correlation has a wide application range and high prediction accuracy. Within the parameters considered in this paper

the error of fast prediction results is no more than 10%. The dimensionless heat storage time and its correlation method proposed in this paper can be popularized to other forms of solid-liquid phase change thermal energy storage devices.

关键词

Keywords

references

Zheng Z J , Xu Y . A novel system for high-purity hydrogen production based on solar thermal cracking of methane and liquid-metal technology: thermodynamic analysis [J]. Energy Conversion and Management , 2018 , 157 : 562 - 574 .

Zheng Z J , He Y L , Li Y S . An entransy dissipation-based optimization principle for solar power tower plants [J]. Science China: Technological Sciences , 2014 , 57 : 773 - 783 .

熊亚选 , 栗博 , 吴玉庭 , 等 . 添加纳米 SiO 2 对四元溴化盐相变热物性的影响 [J]. 化工学报 , 2017 , 68 ( 4 ): 1299 - 1305 .

Xiong Y X , Li B , Wu Y T , et al . Improving phase change thermal properties of quaternary bromides by adding SiO 2 nanoparticle [J]. CIESC Journal , 2017 , 68 ( 4 ): 1299 - 1305 .

Liu M , Saman W , Bruno F . Review on storage materials and thermal performance enhancement techniques for high temperature phase change thermal storage systems [J]. Renewable and Sustainable Energy Reviews , 2012 , 16 ( 4 ): 2118 - 2132 .

Medrano M , Yilmaz M O , Nogués M , et al . Experimental evaluation of commercial heat exchangers for use as PCM thermal storage systems [J]. Applied Energy , 2009 , 86 ( 10 ): 2047 - 2055 .

Yang X H , Lu Z , Bai Q , et al . Thermal performance of a shell-and-tube latent heat thermal energy storage unit: role of annular fins [J]. Applied Energy , 2017 , 202 : 558 - 570 .

Zhu Z Q , Huang Y K , Hu N , et al . Transient performance of a PCM-based heat sink with a partially filled metal foam: effects of the filling height ratio [J]. Applied Thermal Engineering , 2018 , 128 : 966 - 972 .

Tao Y B , You Y , He Y L . Lattice Boltzmann simulation on phase change heat transfer in metal foams/paraffin composite phase change material [J]. Applied Thermal Engineering , 2016 , 93 : 476 - 485 .

Wu W , Zhang S L , Wang S F . A novel lattice Boltzmann model for the solid-liquid phase change with the convection heat transfer in the porous media [J]. International Journal of Heat and Mass Transfer , 2017 , 104 : 675 - 687 .

Yang J , Yang L , Xu C , et al . Experimental study on enhancement of thermal energy storage with phase-change material [J]. Applied Energy , 2016 , 169 : 164 - 176 .

Xu Y , Ren Q , Zheng Z J , et al . Evaluation and optimization of melting performance for a latent heat thermal energy storage unit partially filled with porous media [J]. Applied Energy , 2017 , 193 : 84 - 95 .

Xu Y , Li M J , Zheng Z J , et al . Melting performance enhancement of phase change material by a limited amount of metal foam: configurational optimization and economic assessment [J]. Applied Energy , 2018 , 212 : 868 - 880 .

Zheng Z J , Xu Y , Li M J . Eccentricity optimization of a horizontal shell-and-tube latent-heat thermal energy storage unit based on melting and melting-solidifying performance [J]. Applied Energy , 2018 , 220 : 447 - 454 .

Xu H J , Zhao C Y . Thermal performance of cascaded thermal storage with phase-change materials (PCMs)(Ⅰ): Steady cases [J]. International Journal of Heat and Mass Transfer , 2017 , 106 : 932 - 944 .

Yuan Y P , Cao X L , Xiang B , et al . Effect of installation angle of fins on melting characteristics of annular unit for latent heat thermal energy storage [J]. Solar Energy , 2016 , 136 : 365 - 378 .

Kamkari B , Shokouhmand H . Experimental investigation of phase change material melting in rectangular enclosures with horizontal partial fins [J]. International Journal of Heat and Mass Transfer , 2014 , 78 : 839 - 851 .

Rathod M K , Banerjee J . Thermal performance of a phase change material-based latent heat thermal storage unit [J]. Heat Transfer—Asian Research , 2014 , 43 ( 8 ): 706 - 719 .

Rathod M K , Banerjee J . Development of correlation for melting time of phase change material in latent heat storage unit [J]. Energy Procedia , 2015 , 75 : 2125 - 2130 .

Voller V R , Cross M . Estimating the solidification/melting times of cylindrically symmetric regions [J]. International Journal of Heat and Mass Transfer , 1981 , 24 ( 9 ): 1457 - 1462 .

Solomon A D . Melt time and heat flux for a simple PCM body [J]. Solar Energy , 1979 , 22 ( 3 ): 251 - 257 .

Riley D S , Smith F T , Poots G . The inward solidification of spheres and circular cylinders [J]. International Journal of Heat and Mass Transfer , 1974 , 17 ( 12 ): 1507 - 1516 .

Ho C J , Viskanta R . Heat transfer during melting from an isothermal vertical wall [J]. Journal of Heat Transfer , 1984 , 106 ( 1 ): 12 - 19 .

Zhang Y , Chen Z , Wang Q , et al . Melting in an enclosure with discrete heating at a constant rate [J]. Experimental Thermal and Fluid Science , 1993 , 6 ( 2 ): 196 - 201 .

Bilir L , Ilken Z . Total solidification time of a liquid phase change material enclosed in cylindrical/spherical containers [J]. Applied Thermal Engineering , 2005 , 25 ( 10 ): 1488 - 1502 .

Belusko M , Tay N , Liu M , et al . Effective tube-in-tank PCM thermal storage for CSP applications(Ⅰ): Impact of tube configuration on discharging effectiveness [J]. Solar Energy , 2016 , 139 : 733 - 743 .

Tay N H S , Bruno F , Belusko M . Experimental validation of a CFD and an ε-NTU model for a large tube-in-tank PCM system [J]. International Journal of Heat and Mass Transfer , 2012 , 55 : 5931 - 5940 .

Dittus F , Boelter L . Heat transfer in automobile radiators of the tubular type [J]. International Communications in Heat and Mass Transfer , 1985 , 12 : 3 - 22 .

Alexiades V . Mathematical Modeling of Melting and Freezing Processes [M]. Boca Raton : CRC Press , 1993 : 145 .

Zheng Z J , Li M J , He Y L . Thermal analysis of solar central receiver tube with porous inserts and non-uniform heat flux [J]. Applied Energy , 2017 , 185 : 1152 - 1161 .

Zheng Z J , Li M J , He Y L . Optimization of porous insert configurations for heat transfer enhancement in tubes based on genetic algorithm and CFD [J]. International Journal of Heat and Mass Transfer , 2015 , 87 : 376 - 379 .

Zheng Z J , Xu Y , He Y L . Thermal analysis of a solar parabolic trough receiver tube with porous insert optimized by coupling genetic algorithm and CFD [J]. Science China: Technological Sciences , 2016 , 59 ( 10 ): 1475 - 1485 .

Zheng Z J , He Y , He Y L , et al . Numerical optimization of catalyst configurations in a solar parabolic trough receiver–reactor with non-uniform heat flux [J]. Solar Energy , 2015 , 122 : 113 - 125 .

陶文铨 . 数值传热学 [M]. 2 版 . 西安 : 西安交通大学出版社 , 2001 : 220 .

Tao W Q . Numerical Heat Transfer [M]. 2nd ed . Xi’an : Xi’an Jiaotong University Press , 2001 : 220 .

杨世铭 , 陶文铨 . 传热学 [M]. 2 版 . 北京 : 高等教育出版社 , 1998 : 168 .

Yang S M , Tao W Q . Heat Transfer [M]. 2nd ed . Beijing : Higher Education Press , 1998 : 168 .

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

基于热质传递效应的准稳态结霜模型改进及数值验证

欧拉-拉格朗日迭代固-液相变算法

缠绕管式换热器全模型研究

超薄热管启动特性和传热性能数值模拟

板式换热器相变流动的传热及压降特性