缠绕管式换热器壳程强化传热性能影响因素分析

高兴辉; 周帼彦; 涂善东

doi:10.11949/0438-1157.20181534

您当前的位置：

首页 >

文章列表页 >

缠绕管式换热器壳程强化传热性能影响因素分析

流体力学与传递现象 | 更新时间：2026-07-24

- 缠绕管式换热器壳程强化传热性能影响因素分析
- Study on effects of structural parameters on shell-side heat transfer enhancement in spiral wound heat exchangers
- 化工学报 2019年70卷第7期页码：2456-2471
- 作者机构：
  
  华东理工大学机械与动力工程学院，承压系统与安全教育部重点实验室，上海 200237
- 作者简介：
  
  高兴辉（1993—），男，硕士研究生，961277609@qq.com
  周帼彦（1977—），女，博士，教授，zhougy@ecust.edu.cn
- 基金信息：
- DOI：10.11949/0438-1157.20181534
  中图分类号： TK 172
- 收稿：2019-01-02，
  
  修回：2019-04-12，
  
  网络首发：2026-07-24，
  
  纸质出版：2019-07-05
- 稿件说明：
移动端阅览
高兴辉, 周帼彦, 涂善东. 缠绕管式换热器壳程强化传热性能影响因素分析[J]. 化工学报, 2019, 70(7): 2456-2471

GAO Xinghui, ZHOU Guoyan, TU Shandong. Study on effects of structural parameters on shell-side heat transfer enhancement in spiral wound heat exchangers[J]. CIESC Journal, 2019, 70(7): 2456-2471
高兴辉, 周帼彦, 涂善东. 缠绕管式换热器壳程强化传热性能影响因素分析[J]. 化工学报, 2019, 70(7): 2456-2471 DOI： 10.11949/0438-1157.20181534.

GAO Xinghui, ZHOU Guoyan, TU Shandong. Study on effects of structural parameters on shell-side heat transfer enhancement in spiral wound heat exchangers[J]. CIESC Journal, 2019, 70(7): 2456-2471 DOI： 10.11949/0438-1157.20181534.

摘要

由于内部流场信息缺乏，结构参数对流体流动的影响规律不明确，致使缠绕管式换热器壳程强化传热机理不明晰，阻碍其设计准则的进一步规范化和通用。针对上述问题，对缠绕管式换热器壳程流体流动进行几何建模及数值模拟，并通过文献中实验数据进行验证，进而基于该模型对壳程流体流场特性进行详细分析，分析关键结构参数对其壳程传热与阻力性能的影响，并探讨其强化传热机理。结果表明：Realizable

湍流模型可较为准确地描述壳程流体流动；在双对数坐标系内，壳程Nusselt数随Reynolds数的增大而增大，阻力系数

则呈线性降低的趋势；壳程Nusselt数随缠绕管直径

与平均缠绕直径

的增大而增大，随螺距

的增大而减小，阻力系数

则相反；缠绕管直径

对壳程流体传热与阻力性能的影响最大，平均缠绕直径

的影响最小；增大缠绕管直径

与平均缠绕直径

有利于破坏流体速度边界层，增强流体扰动，加快温升速度，强化壳程传热，而增大螺距

则使速度边界层变厚，减小流动阻力的同时降低温升速度，不利于壳程强化传热。

Abstract

Due to the lack of internal flow field information

the influence of structural parameters on fluid flow is not clear

which makes the heat transfer mechanism of the shell-tube heat exchanger shell side unclear and hinders the further standardization and generalization of its design criteria. Aiming at the above problems

geometry modeling and corresponding numerical simulations were carried out for the shell side flow of spiral wound heat exchangers. The feasibility and accuracy of these modellings were verified by comparing with experimental data in the literature. Then the flow field and characteristics of shell side fluid were investigated in detail. The heat transfer enhancement mechanism was further discussed based on the analysis of the influences of key structural parameters on the heat transfer and resistance performance. The results show that the fluid flow on the shell side can be described more accurately by using Realizable

turbulence model. The Nusselt number increases linearly with the increase of the Reynolds number in a log-log coordinate system

whi

le the friction factor

decreases linearly. The Nusselt number increases as the results of increased winding tube diameter

and average winding diameter

and decreased pitch

. But it was opposite for the friction factor

. The heat transfer and resistance performance of the shell side are mostly affected by the winding tube diameter

and the average winding diameter

does the least. Increased winding tube diameter

and average winding diameter

will break the boundary layer of the fluid flow. Then the fluid disturbance increases and hence the temperature increases faster. It is beneficial to enhance heat transfer on shell side. While increased pitch

will make the fluid flow much more smoothly

which causes velocity boundary layer to thicken. Thus flow resistance and temperature rising rate are reduced

it is not good for enhancement of heat transfer on shell side.

关键词

Keywords

references

丁超 , 胡海涛 , 丁国良 , 等 . 运行工况对 LNG 绕管式换热器壳侧换热特性的影响 [J ] . 化工学报 , 2018 , 69 ( 6 ): 2417 - 2423 .

Ding C , Hu H T , Ding G L , et al . Influences of working conditions on heat transfer characteristics in shell side of LNG spiral wound heat exchangers [J ] . CIESC Journal , 2018 , 69 ( 6 ): 2417 - 2423 .

Zeng M , Zhang G P , Li Y , et al . Geometrical parametric analysis of flow and heat transfer in the shell side of a spiral-wound heat exchanger [J ] . Heat Transfer Engineering , 2015 , 36 ( 9 ): 790 - 805 .

Lu X , Du X P , Zeng M , et al . Shell-side thermal-hydraulic performances of multilayer spiral-wound heat exchangers under different wall thermal boundary conditions [J ] . Applied Thermal Engineering , 2014 , 70 ( 2 ): 1216 - 1227 .

Lu X , Zhang G P , Chen Y T , et al . Effect of geometrical parameters on flow and heat transfer performances in multi-stream spiral-wound heat exchangers [J ] . Applied Thermal Engineering , 2015 , 89 : 1104 - 1116 .

于清野 . 缠绕管式换热器计算方法研究 [D ] . 大连 : 大连理工大学 , 2011 .

Yu Q Y . Research on calculation method for helical wound coil tube heat exchangers [D ] . Dalian : Dalian University of Technology , 2011 .

薛佳幸 . 缠绕管式换热器换热工艺研究 [D ] . 兰州 : 兰州交通大学 , 2015 .

Xue J X . Research on heat transfer process of coil-wound heat exchangers [D ] . Lanzhou : Lanzhou Jiaotong University , 2015 .

Shukri T . LNG technology selection [J ] . Hydrocarbon Engineering , 2004 , 9 ( 2 ): 71 - 76 .

Neeraas B O . Condensation of hydrocarbon mixtures in coil wound LNG heat exchangers, tube-side heat transfer and pressure drop [D ] . Trondheim : Norwegian Institute of Technology , 1993 .

Salimpour M R . Heat transfer coefficients of shell and coiled tube heat exchanger [J ] . Experimental Thermal and Fluid Science , 2009 , 33 ( 2 ): 203 - 207 .

Ghorbani N , Taherian H , Gorji M , et al . An experimental study of thermal performance of shell and coil heat exchangers [J ] . International Communications in Heat and Mass Transfer , 2010 , 37 ( 7 ): 775 - 781 .

季鹏 , 李玉星 , 王武昌 , 等 . 结构参数对绕管式换热器传热特性的影响 [J ] . 油气储运 , 2015 , 34 ( 8 ): 886 - 891 .

Ji P , Li Y X , Wang W C , et al . Effect of structural parameter on heat transfer performance of coil-wound heat exchange [J ] . Oil & Gas Storage and Transportation , 2015 , 34 ( 8 ): 886 - 891 .

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

微通道内纳米流体传热流动特性

缠绕管式换热器全模型研究

润滑油在内插同轴交叉翼型涡产生器管内流动与传热特性分析

变扭率扭旋叶片强化传热特性

一种新型变截面换热管强化传热性能