Permeability measurement method of crushed tight porous medium

ZHOU Bo; XU Ruina; JIANG Peixue

doi:10.3969/j.issn.0438-1157.2014.z1.057

您当前的位置：

首页 >

文章列表页 >

Permeability measurement method of crushed tight porous medium

更新时间：2025-12-10

- Permeability measurement method of crushed tight porous medium
- CIESC Journal Issue S1, Pages: 353-358(2014)
- 作者机构：
  
  热科学与动力工程教育部重点实验室, 北京市二氧化碳资源利用与减排技术重点实验室, 清华大学热能工程系,北京,100084
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.z1.057
  CLC： Q021.1
- Online First：30 May 2014，
  
  Published：30 May 2014
- 稿件说明：
移动端阅览
ZHOU Bo, XU Ruina, JIANG Peixue. Permeability measurement method of crushed tight porous medium[J]. CIESC Journal, 2014, (S1): 353-358.
DOI：

ZHOU Bo, XU Ruina, JIANG Peixue. Permeability measurement method of crushed tight porous medium[J]. CIESC Journal, 2014, (S1): 353-358. DOI： 10.3969/j.issn.0438-1157.2014.z1.057.

摘要

基于均匀各向同性多孔介质、达西渗流和理想气体假设，考虑Klinkenberg效应建立了针对具有纳米尺度孔径的低渗透率多孔介质中的渗流模型。针对致密球形破碎样品的压力脉冲实验，建立了相应的边界条件，同时利用有限差分方法获得其实验腔的压力变化曲线的数值解。通过对渗流方程进行量纲1化，引入了与孔隙率、渗透率和滑移参数有关的量纲1参数Z、Z*和bK。通过改变参数Z、Z*和bK研究了样品边界处压力的变化规律，给出了一种数据处理方法，对于致密球形破碎多孔介质的压力脉冲实验，通过对实验测量的样品边界处压力曲线的分析，结合偏微分方程正问题的数值解，可以确定样品的孔隙率、渗透率和滑移参数，从而更为简便地分析压力脉冲衰减曲线实验数据，得到致密多孔介质样品渗透率。

Abstract

A model for flows in low permeability porous media with nano scale pores has been derived with assumptions including homogeneity

the Darcy's law

ideal gas model and the Klinkenberg effect. Numerical simulations are carried out for pressure pulse decay experiment with spherical crushed samples using the finite difference method with suitable boundary conditions. Non-dimensional parameters Z

Z* and bK are introduced when the governing equations are non-dimensionalized. Various pressure decay curves are investigated numerically when various parameters Z

Z* and bK are applied. A data processing method for the present pressure pulse decay experiment is proposed. Porosity

permeability and the Klinkenberg coefficient can be determined by combining both the measured pressure decay curves at the sample boundaries and the numerical solutions of the governing equations. The permeability and the Klinkenberg coefficient of a porous medium sample cannot be determined using only one pressure decay curve.

关键词

Keywords

references

Views

360

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical simulation of flow characteristics in a rotating membrane filter

3D characterization of pore structure and seepage simulation of tar-rich coal (long flame coal)

Thermal efficiency research of regenerator for horseshoe flame glass furnace based on numerical simulation

Inverse analysis on permeability of micro-nano porous materials based on two-dimensional seepage equation

Inverse modeling of EGS heat reservoir based on micro-seismic data and analysis of its heat recovery performance

Related Author

WANG Xiaoxuan

HU Xiaohong

LU Yunan

WANG Shiyong

FAN Fengxian

HUANG Xiaole

YANG Fu

HAN Lei

Related Institution

School of Energy and Power Engineering, University of Shanghai for Science and Technology

Shanghai Key Laboratory of Multiphase Flow and Heat Transfer in Power Engineering

Shanghai Research Institute of Chemical Industry Company Limited

National Petroleum and Chemical Industry Filtration and Separation Engineering Research Center

State Key Laboratory of Multiphase Flow in Power Engineering, Xi’an Jiaotong University

⁰