Design and analysis of plastic fin-tube heat exchanger for flue gas heat recovery

CHEN Lin; SUN Yingying; LIANG Jiangtao; DU Xiaoze; YANG Lijun

doi:10.3969/j.issn.0438-1157.2014.z1.028

您当前的位置：

首页 >

文章列表页 >

Design and analysis of plastic fin-tube heat exchanger for flue gas heat recovery

更新时间：2025-12-10

- Design and analysis of plastic fin-tube heat exchanger for flue gas heat recovery
- CIESC Journal Issue S1, Pages: 175-179(2014)
- 作者机构：
  
  电站设备状态监测与控制教育部重点实验室, 华北电力大学能源动力与机械工程学院,北京,102206
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.z1.028
  CLC： K124
- Online First：30 May 2014，
  
  Published：30 May 2014
- 稿件说明：
移动端阅览
CHEN Lin, SUN Yingying, LIANG Jiangtao, et al. Design and analysis of plastic fin-tube heat exchanger for flue gas heat recovery[J]. CIESC Journal, 2014, (S1): 175-179.
DOI：

CHEN Lin, SUN Yingying, LIANG Jiangtao, et al. Design and analysis of plastic fin-tube heat exchanger for flue gas heat recovery[J]. CIESC Journal, 2014, (S1): 175-179. DOI： 10.3969/j.issn.0438-1157.2014.z1.028.

摘要

排烟热损失约占锅炉全部热损失的一半以上，回收烟气余热有助于节能减排。针对烟气余热回收中的腐蚀问题，基于导热塑料设计了耐腐蚀的翅片管换热器。结合1000 WM火力发电机组烟气余热回收的运行参数，运用经验证的模型计算了换热器的换热面积和外形体积，简要分析了塑料热导率和凝结水流程对这些设计参数的影响，所得到的结果有望为烟气余热回收的工程应用提供参考。

Abstract

Heat loss due to exhausted flue gas accounts for more than half of boiler's total heat losses. Flue gas heat recovery helps to reduce both fuel consumption and pollution emission

which is of great significance. One of the main problems in flue gas heat recovery that restricts the flue gas outlet temperature is the low temperature acid corrosion to metal heat exchangers. In order to overcome this problem

an anti-corrosion fin-tube heat exchanger based on thermally conductive plastic was designed as a low temperature economized. Using the heat recovery operational condition in a 1000 MW thermal power plant

the parameters of heat transfer area and outline dimensions of the heat exchanger were calculated by a validated mathematical model. Then

the influences of plastic thermal conductivity and number of flow paths on the design parameters were analyzed. It is hoped that the results in this paper could give some reference to engineering applications.

关键词

Keywords

references

Views

311

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Flue gas dehumidification through air cooling enhanced by hydrophobic ceramic membranes

Feasibility study of spiral twisted tube for gas turbine inlet temperature regulating heat exchanger

Performance optimization of ORC steam generator based on the second law of thermodynamics

In-plant experimental study on desulfurized flue gas corrosion

SO2 corrosion resistance of composite ceramic coating for boiler heating surface

Related Author

Chao JI

Wei LIU

Hong QI

Aimin TU

Xun MO

Dongsheng ZHU

Yinde YIN

Shijie LIU

Related Institution

College of Chemical Engineering, Nanjing Tech University

Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences

Key Laboratory of Renewable Energy, Chinese Academy of Sciences

Guangdong Key Laboratory of New and Renewable Energy Research and Development

Faculty of Metallurgical and Energy Engineering, Kunming University of Science and Technology

⁰