Effect of liquid flow behaviour on performance of corrugated structured packing

LI Hong; YAO Yuebin; WANG Fangzhou; GAO Xin; LI Xingang

doi:10.3969/j.issn.0438-1157.2014.12.016

您当前的位置：

首页 >

文章列表页 >

Effect of liquid flow behaviour on performance of corrugated structured packing

更新时间：2025-12-10

- Effect of liquid flow behaviour on performance of corrugated structured packing
- CIESC Journal Issue 12, Pages: 4760-4766(2014)
- 作者机构：
  
  1. 天津大学化工学院,天津,300072
  2. 精馏技术国家工程研究中心,天津,300072
  3. 天津化学化工协同创新中心,天津,300072
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.12.016
  CLC： Q02
- Online First：05 December 2014，
  
  Published：05 December 2014
- 稿件说明：
移动端阅览
LI Hong, YAO Yuebin, WANG Fangzhou, et al. Effect of liquid flow behaviour on performance of corrugated structured packing[J]. CIESC Journal, 2014, (12): 4760-4766.
DOI：

LI Hong, YAO Yuebin, WANG Fangzhou, et al. Effect of liquid flow behaviour on performance of corrugated structured packing[J]. CIESC Journal, 2014, (12): 4760-4766. DOI： 10.3969/j.issn.0438-1157.2014.12.016.

摘要

根据液相在波纹规整填料片上呈现渗流、膜状流等不同的流动方式

选择5种不同的波纹规整填料对其流体力学和传质性能进行研究

以探究液相在波纹片上的流动方式对波纹规整填料性能的影响.研究结果表明

液相呈渗流流动的泡沫碳化硅波纹规整填料(SCFP型)有利于液体横向扩散和液膜均匀分布

当液相喷淋密度和气相F因子均较小时

其压降最低

传质效率最高;液相主要呈渗流流动、兼有膜状流动的双层错孔丝网填料(DMⅢ型)有利于波纹片两侧液体交换

强化液体在流动过程中的扰动

其压降及传质性能略逊于SCFP型填料;液相主要呈膜状流动的BX型、DMⅠ型及DMⅡ型填料波纹片表面液膜较厚

横向扩散能力差

其传质效率低于SCFP型和DMⅢ型填料.研究揭示了依靠渗流作用的波纹规整填料具有较好的应用性能

为波纹规整填料的进一步发展开拓了新思路.

Abstract

Five corrugated structured packings are selected based on different liquid flow patterns including seepage flow and film flow. The hydrodynamic and mass transfer performance are studied in order to explore the effect of liquid flow patterns on the performance of structured packings. The experimental results show that liquid mainly presents a seepage flow in the porous structure of SCFP type packing

which benefits the lateral spreading of liquid and uniform distribution of liquid membrane. The SCFP type packing shows the highest mass transfer efficiency and lowest pressure drop when the F factor is lower. Liquid displays a partly seepage flow in the special structure of DMⅢ type packing

which can promote the liquid exchange between two sides of one sheet and intensify liquid turbulence

increasing mass transfer efficiency and reducing pressure drop compared with DMⅠand DMⅡtype structured packings. Liquid flows in the form of film on the surface of BX and DMⅠtype packings and this flow pattern results in a high velocity and a short residence time of liquid film. Thus the mass transfer efficiency of BX and DMⅠtype packings is lower than that of SCFP and DMⅢ type packings. This study shows that the structured corrugated packing with seepage flow presents good performance

opening up a new method to develop structured corrugated packings.

关键词

Keywords

references

Views

222

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study and application of FGP packing in energy saving and emission reduction of methanol distillation

Mass and heat transfer characteristics of tubular solar still under vacuum condition

Life cycle cost evaluation of structured corrugation SiC-foam packing

Liquid flow characteristics of structured corrugation SiC-foam packing sheets

Mass transfer and hydraulic performance of CO2 absorption by ionic liquids over structured packings

Related Author

Qunsheng LI

Yang LI

Zhongqi REN

Jiaxing XUE

XIE Guo

SUN Licheng

MO Zhengyu

LIU Hongtao

Related Institution

State Key Laboratory of Chemical Resource Engineering, College of Chemical Engineering, Beijing University of Chemical Technology

State Key Laboratory of Hydraulics and Mountain River Engineering, Sichuan University

School of Chemical Engineering and Technology, Tianjin University

State Key Laboratory of Chemical Resource Engineering, Beijing University of Chemical Technology

School of Chemical Engineering, Northwest University

⁰