Experimental analysis of ice-making characteristics with adsorption in vacuum environment

ZHANG Xuelai; ZHAO Qunzhi; MENG Xianglai; LI Chunlei; XU Bin

doi:10.3969/j.issn.0438-1157.2014.10.050

您当前的位置：

首页 >

文章列表页 >

Experimental analysis of ice-making characteristics with adsorption in vacuum environment

更新时间：2025-12-10

- Experimental analysis of ice-making characteristics with adsorption in vacuum environment
- CIESC Journal Issue 10, Pages: 4131-4137(2014)
- 作者机构：
  
  上海海事大学冰蓄冷技术研究所,上海,201306
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.10.050
  CLC： K02
- Online First：05 October 2014，
  
  Published：05 October 2014
- 稿件说明：
移动端阅览
ZHANG Xuelai, ZHAO Qunzhi, MENG Xianglai, et al. Experimental analysis of ice-making characteristics with adsorption in vacuum environment[J]. CIESC Journal, 2014, (10): 4131-4137.
DOI：

ZHANG Xuelai, ZHAO Qunzhi, MENG Xianglai, et al. Experimental analysis of ice-making characteristics with adsorption in vacuum environment[J]. CIESC Journal, 2014, (10): 4131-4137. DOI： 10.3969/j.issn.0438-1157.2014.10.050.

摘要

基于水的真空闪蒸理论，设计了一种吸附作用下闪蒸制冰的实验装置。在一定的预设压力值（400、600、800 Pa）、液面高度（20～50 mm）及初始温度（32、22℃）条件下，进行了有无吸附模块的对比性实验。对实验结果进行了定性分析，结果表明：与无吸附条件相比，在吸附作用下，闪蒸室压力及液体温度下降得更快，沸石吸附模块的存在能够强化真空条件下水的闪蒸。同时分析了液面高度对闪蒸的影响，相同的初始温度、预设压力条件下，液面高度越小，吸附条件下闪蒸室的压力下降得越快。

Abstract

Based on the theory of vacuum flash of water

a flash device is designed for experiment of ice-making under the condition of adsorption. Vacuum preparation of binary ice makes use of the principle of the triple point of water. However

the water flash will inevitably increase the chamber pressure and the pressure will be higher than the triple point (611 Pa). This paper proposes a method using solid adsorbent to maintain the pressure. Based on the initial establishment of a low pressure environment

the flash vapor can be adsorbed by the solid zeolite adsorbent in the closed system. Due to the experimental conditions

only the effect of adsorption modules on the flash is analyzed. At certain preset pressure (400

600

and 800 Pa)

height of liquid film (20-50 mm) and initial temperature (32℃

22℃)

comparative experiments are carried out in the presence or absence of adsorption module. The results show that the flash chamber pressure and temperature of liquid film can be reduced faster with the adsorption. With the adsorption module

vacuum flash of water can be enhanced. With smaller height of liquid film

the flash chamber pressure decreases more quickly at the same initial temperature and preset pressure.

关键词

Keywords

references

Views

279

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Selective adsorption and purification of low-concentration Kr gas using various adsorbents

Controllable construction of Cu(Ⅰ) in Y zeolite for adsorptive separation of ethylene/ethane

Characteristics of dynamic ice-making via Al2O3-H2O nanofluid's vacuum flash

Adaptive modeling of simulated moving bed based on KELM-ANFIS

Progress in research of selective oxidation of low carbon polyols over nano-Au catalysts with precise electronic effect regulation

Related Author

TAO Chunhui

LI Yinhui

FU Yu

DUAN Ran

ZHAO Zeyi

TANG Yufeng

ZHANG Gang

MA Heping

Related Institution

School of Chemical Engineering and Technology, Xi’an Jiaotong University

China National Nuclear Industry Corporation

State Key Laboratory of Materials-Oriented Chemical Engineering, College of Chemical Engineering, Nanjing Tech University

Institute of Cool Thermal Storage Technology, Shanghai Maritime University

School of Chemical Engineering and Technology, Xi'an Jiaotong University, Xi 'an

⁰