Pressure drop of gas-solids distributor located at outlet of riser with combined restraint

JIA Mengda; WANG Dewu; ZHANG Shaofeng; ZHAO Lijun; LI Rui; WU Guangheng

doi:10.3969/j.issn.0438-1157.2014.09.009

您当前的位置：

首页 >

文章列表页 >

Pressure drop of gas-solids distributor located at outlet of riser with combined restraint

更新时间：2025-12-10

- Pressure drop of gas-solids distributor located at outlet of riser with combined restraint
- CIESC Journal Issue 9, Pages: 3375-3382(2014)
- 作者机构：
  
  1. 河北工业大学化工学院,天津,300130
  2. 河北工业大学海水资源高效利用化工技术教育部工程研究中心,天津,300130
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.09.009
  CLC： Q051.1TQ052
- Online First：05 September 2014，
  
  Published：05 September 2014
- 稿件说明：
移动端阅览
JIA Mengda, WANG Dewu, ZHANG Shaofeng, et al. Pressure drop of gas-solids distributor located at outlet of riser with combined restraint[J]. CIESC Journal, 2014, (9): 3375-3382.
DOI：

JIA Mengda, WANG Dewu, ZHANG Shaofeng, et al. Pressure drop of gas-solids distributor located at outlet of riser with combined restraint[J]. CIESC Journal, 2014, (9): 3375-3382. DOI： 10.3969/j.issn.0438-1157.2014.09.009.

摘要

在一套组合约束型提升管冷态实验装置上，通过实验研究了不同操作条件下提升管出口气固分布器的压降，并与常规气体分布器压降进行了对比。实验结果表明，在零床层及有床层的操作模式下，气固分布器压降均随提升管内表观气速和颗粒循环强度的增加而增大，在颗粒循环强度较低时，气固分布器压降曲线变化的斜率随着表观气速的增加而增大，在颗粒循环强度较高时，气固分布器压降曲线变化的斜率随着表观气速的增加而减小；随着开孔率及上部流化床层压降增加，气固分布器压降呈降低趋势，当流化床层压降达到一定程度后，分布器各孔方可实现有效布气，此后气固分布器压降趋于近似不变；在相同表观气速及开孔率下，气固分布器压降大于常规气体分布器压降。

Abstract

Based on a cold model experimental setup of riser reactor with combined restraint outlet

an experiment was conducted to analyze pressure drop of gas-solids distributor at the outlet of riser under different circumstances. Gas-solids distributor's pressure drop increased with increasing superficial gas velocity and solids flux

with or without active operating bed. The slope of gas-solids distributor's pressure drop curve increased with increasing superficial gas velocity at lower solids flux

while decreased at higher solids flux. Pressure drop of the distributor declined with increasing distributor's aperture ratio and increasing pressure drop of the upper fluidized bed. When the pressure drop of the upper fluidized bed increased to a specific value

the holes of the distributor were all able to be passed through by gas-solids flow

with the distributor pressure drop approximately unchangeable. At the same superficial gas velocity

pressure drop of gas-solids distributor was bigger than that of conventional gas distributor.

关键词

Keywords

references

Views

203

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Gas-solid flow characteristics in the rolling fluidized-bed

Model prediction and experimental study of pressure drop in double circulating fluidized bed risers of gas-solid two-phase flow

Performance study of gas-liquid vortex separators under low cross-sectional gas velocity

Study on flow mechanism of binary particles with large differences in draft tube fluidized beds

Prediction of biomass pyrolysis product yield based on machine learning algorithms

Related Author

Peng TIAN

Dewu WANG

Ruojin WANG

Meng TANG

Xiaolei HAO

Shaofeng ZHANG

YANG Xin

CHEN Hongwei

Related Institution

National-Local Joint Engineering Laboratory for Energy Conservation of Chemical Process Integration and Resources Utilization, Hebei University of Technology

School of Mechanical Engineering, Hebei University of Technology

Key laboratory of Condition Monitoring and Control for Power Plant Equipment, Ministry of Education, North China Electric Power University

HeBei University of Water Resources and Electric Engineering

National-Local Joint Engineering Laboratory for Energy Conservation of Chemical Process Integration and Resources Utilization, Hebei University of Technology

⁰