Characteristics of products from sewage sludge pyrolysis at various temperature ranges

JIN Pen; LI Baoxia; JIN Cheng

doi:10.3969/j.issn.0438-1157.2014.06.049

您当前的位置：

首页 >

文章列表页 >

Characteristics of products from sewage sludge pyrolysis at various temperature ranges

更新时间：2025-12-10

- Characteristics of products from sewage sludge pyrolysis at various temperature ranges
- CIESC Journal Issue 6, Pages: 2316-2322(2014)
- 作者机构：
  
  1. 西北民族大学化工学院,甘肃,兰州,730000
  2. 甘肃省高校环境友好复合材料及生物质利用省级重点实验室,甘肃,兰州,730000
  3. 华侨大学化工学院,福建,厦门,361021
  4. 兰州大学资源环境学院,甘肃,兰州,730000
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.06.049
  CLC： K6
- Online First：05 June 2014，
  
  Published：05 June 2014
- 稿件说明：
移动端阅览
JIN Pen, LI Baoxia, JIN Cheng. Characteristics of products from sewage sludge pyrolysis at various temperature ranges[J]. CIESC Journal, 2014, (6): 2316-2322.
DOI：

JIN Pen, LI Baoxia, JIN Cheng. Characteristics of products from sewage sludge pyrolysis at various temperature ranges[J]. CIESC Journal, 2014, (6): 2316-2322. DOI： 10.3969/j.issn.0438-1157.2014.06.049.

摘要

对城市污水污泥（简称污泥）进行工业分析和热重分析，考察污泥的基本组成和热重特性；采用气相色谱（GC）检测了不同热解温度区间内污泥热解生成的气体产物成分，并利用SEM和BET分别分析了不同热解终温下裂解炭的形貌特征和比表面积。结果表明：污泥热解可以分为水分析出阶段、挥发分析出阶段和焦炭化阶段；不同热解温度区间内污泥热解气体产物的组成有很大差别，热解温度350℃后H2在热解气中的含量快速增加，CH4含量在350～450℃时达到最大值，而CO主要在热解温度为350～750℃时生成，CO2含量随着热解温度的增加迅速下降；随着热解终温的不断升高，裂解炭结构变得越来越疏松，比表面积也随之增大，750℃达到最大值55 m2·g-1。

Abstract

Municipal sewage sludge (i.e. sludge) at various temperature ranges was analyzed by proximate analysis and thermogravimetric analysis methods. The gaseous components produced by the sludge pyrolysis were detected by gas chromatography (GC)

while the morphology and specific surface area of pyrolytic char measured by SEM and BET techniques

respectively. The results show that the pyrolysis process of sludge can involve water evaporation

organics volatilization and char formation steps. There are obvious differences between the gas components obtained at different ranges of pyrolysis temperature. The H2 content will rapidly increase when pyrolysis temperature is larger than 350℃

the maximum CH4 content obtained when temperature is in 350-450℃

the temperature range generated CO is mainly in 350-750℃

and the CO2 content declines for the whole range of pyrolysis temperature. With rising final temperature of pyrolysis

the char structure becomes more and more loose and it specific surface area increases. The maximum specific surface area of char produces is 55 m2·g-1 at 750℃.

关键词

Keywords

references

Views

363

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Migration of sulfur and nitrogen during co-hydrothermal carbonization process of sewage sludge and high-sulfur coal

Phosphorus recovery from products of sewage sludge via different thermal treatment processes

Morphology of phosphorus and metal extraction behavior in sewage sludge during hydrothermal carbonization treatment

Study on pyrolysis mechanism of carbon and oxygen-containing functional groups in sludge by Py-GC/MS

Study on release of polycyclic aromatic hydrocarbons during sewage sludge pyrolysis

Related Author

CHENG Fangqin

YANG Fengling

SONG Xutao

WANG Baofeng

YANG Xiaoyang

Yu QIAO

Jing LIU

Chao FENG

Related Institution

Institute of Resources and Environment Engineering, Shanxi University, Engineering Research Center of CO2 EmissionReduction and Resource Utilization-Ministry of Education of the People’s Republic of China

State Key Laboratory of Coal Combustion, Huazhong University of Science and Technology

EU Institute for Clean and Renewable Energy at Huazhong University of Science and Technology

Key Laboratory of the Three Gorges Reservoir Region’s Eco-Environment, Ministry of Education, Chongqing University

Institute of Energy and Power Engineering, Zhejiang University of Technology

⁰