Effects of charge pressure on continuous production of CO<sub>2</sub> hydrate in compression refrigeration cycle

XIE Zhenxing; XIE Yingming; ZHOU Xingfa; FANG Yajun

doi:10.3969/j.issn.0438-1157.2014.06.047

您当前的位置：

首页 >

文章列表页 >

Effects of charge pressure on continuous production of CO₂ hydrate in compression refrigeration cycle

更新时间：2025-12-10

- Effects of charge pressure on continuous production of CO₂ hydrate in compression refrigeration cycle
- CIESC Journal Issue 6, Pages: 2301-2307(2014)
- 作者机构：
  
  上海理工大学能源与动力工程学院,上海,200093
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.06.047
  CLC： K02
- Online First：05 June 2014，
  
  Published：05 June 2014
- 稿件说明：
移动端阅览
XIE Zhenxing, XIE Yingming, ZHOU Xingfa, et al. Effects of charge pressure on continuous production of CO₂ hydrate in compression refrigeration cycle[J]. CIESC Journal, 2014, (6): 2301-2307. DOI: 10.3969/j.issn.0438-1157.2014.06.047.
DOI：

XIE Zhenxing, XIE Yingming, ZHOU Xingfa, et al. Effects of charge pressure on continuous production of CO₂ hydrate in compression refrigeration cycle[J]. CIESC Journal, 2014, (6): 2301-2307. DOI: 10.3969/j.issn.0438-1157.2014.06.047. DOI：

摘要

研制了一台能够连续制备蓄冷用CO2水合物的压缩式循环实验装置，并在该装置上研究了充注压力对水合物的预冷时间、生成质量、水合比例和潜热蓄冷量的影响。实验结果表明水合物在CO2气泡上升过程中生成，在气液界面处堆积。高的充注压力有着更理想的蓄冷特性，当充注压力为4.2 MPa时，预冷时间为8 min、水合物生成质量为8.44 kg、水合比例为75.1%、水合物潜热蓄冷量为4.22 MJ。充注压力为3.8 MPa及以上时，水合物生成量大，水合物阻碍釜内各部分的传热，使釜内中层、下层的温差较大。水合物生成过程后期，水合放热量减少，液体CO2在反应釜内的蒸发吸热效应使得釜内温度继续降低，一直到低于0℃，充注压力越高，此现象越明显。

Abstract

A novel pilot-scale apparatus was designed to continuously produce CO2 hydrate for cool storage. The pre-chilling time

amount of CO2 hydrate formation

hydration ratio

and cool energy of hydrate were analyzed under different CO2 charge pressures. Results showed that CO2 hydrate formed during the rising process of CO2 bubbles in water and cumulated at the gas-liquid interface. The cool storage performance can be improved greatly as the charge pressure increases. Under charge pressure of 4.2 MPa

the pre-chilling time

amount of hydrate formation

hydration ratio and latent cool energy storage are 8 min

8.44 kg

75.1% and 4.22 MJ respectively. When the charge pressure is higher than 3.8 MPa

large temperature differences appear between the middle and low parts of reactor

resulted from low thermal conductivity of formed hydrate. Evaporation of liquid CO2 reduces reactor temperature to 0℃ or even lower at late stage of hydrate formation

which is more evident at higher charge pressures.

关键词

Keywords

references

Views

757

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on the enhanced method of CO2-seawater hydrate generation

Effects of nanoparticles on CO2 hydrate thermal conductivity

Characteristics of growth and cool storage of CO2 hydrates produced in direct-contact way

Study on droplet size variation of CO2 spray injection by swirl nozzle under deepwater conditions

Zn-doped PdO/ZrO2 with rich oxygen vacancies for the synthesis of diphenyl carbonate from CO2 and phenol

Related Author

YANG Mingjun

SONG Wei

ZHANG Lei

LING Zheng

CHEN Bingbing

SONG Yongchen

LIU Ni

HONG Chunfang

Related Institution

School of Energy and Power Engineering, Dalian University of Technology

College of Mechanical and Transportation Engineering, China University of Petroleum

Beijing Huairou Laboratory

State Key Laboratory of Heavy Oil Processing, China University of Petroleum

College of Chemistry and Chemical Engineering, Taiyuan University of Technology, Shanxi Key Laboratory of Efficient and Clean Utilization of Gas Energy

⁰

Effects of charge pressure on continuous production of CO2 hydrate in compression refrigeration cycle

DOI：10.3969/j.issn.0438-1157.2014.06.047

摘要

Abstract

关键词

Keywords

references

Effects of charge pressure on continuous production of CO₂ hydrate in compression refrigeration cycle