Experimental investigation and model validation for liquid desiccant dehumidification and regeneration in falling-film plate

QIAN Junfei; YIN Yonggao; PAN Xiongwei; ZHANG Xiaosong

doi:10.3969/j.issn.0438-1157.2014.06.017

您当前的位置：

首页 >

文章列表页 >

Experimental investigation and model validation for liquid desiccant dehumidification and regeneration in falling-film plate

更新时间：2025-12-10

- Experimental investigation and model validation for liquid desiccant dehumidification and regeneration in falling-film plate
- CIESC Journal Issue 6, Pages: 2070-2077(2014)
- 作者机构：
  
  东南大学能源与环境学院, 能源热转换及其过程测控教育部重点实验室,江苏,南京,210096
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.06.017
  CLC： U831.6
- Online First：05 June 2014，
  
  Published：05 June 2014
- 稿件说明：
移动端阅览
QIAN Junfei, YIN Yonggao, PAN Xiongwei, et al. Experimental investigation and model validation for liquid desiccant dehumidification and regeneration in falling-film plate[J]. CIESC Journal, 2014, (6): 2070-2077.
DOI：

QIAN Junfei, YIN Yonggao, PAN Xiongwei, et al. Experimental investigation and model validation for liquid desiccant dehumidification and regeneration in falling-film plate[J]. CIESC Journal, 2014, (6): 2070-2077. DOI： 10.3969/j.issn.0438-1157.2014.06.017.

摘要

在平板降膜溶液除湿/再生实验平台上，以LiCl水溶液作为除湿溶液，实验研究了空气、溶液的入口参数对空气出口参数的影响，并根据实验数据得到了耦合传热传质系数的关联式，为NTU-Le模型提供了重要的数据支持，同时将实验数据与NTU-Le传热传质模型计算所得的数据进行比较，来验证NTU-Le传热传质模型在平板降膜溶液除湿/再生过程中的适用性和准确度。结果显示：实验数据和模型计算值之间的偏差均在10%以内，表示NTU-Le模型适用于平板降膜溶液除湿/再生过程。

Abstract

To investigate the heat and mass transfer performance of liquid desiccant dehumidification/regeneration in falling-film plates

experiments were performed in the dehumidifier and regenerator using LiCl solution as the liquid desiccant. Effects of inlet air and solution parameters on their outlet parameters were examined experimentally. Empirical correlations coupling heat and mass transfer coefficients were presented

and the calculation results from NTU-Le heat and mass transfer model was compared with experimental data to verify the accuracy and suitability of the model. The results show that the error between simulation results and experimental data is within 10%

so that the NTU-Le model is suitable for the liquid desiccant dehumidification and regeneration in falling-film plates. The experimental results also provide reliable data for further analysis of heat and mass transfer performance between air and desiccant.

关键词

Keywords

references

Views

291

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Performance of regeneration processes of internally heated regenerator and adiabatic regenerator

A novel Z-type packing used for desiccant regenerator

Performance of solar liquid desiccant regeneration

Investigation on the dynamics and vaporization characteristics of droplet impact on the heated wall surface

Improvement and numerical validation of quasi-steady-state frosting model based on thermal and mass transfer effect

Related Author

WANG Qin

WU Wei

LIU Songsong

GU Chenjie

CHEN Cong

TANG Zhibiao

ZHENG Baojun

GAO Longfei

Related Institution

Engineering Laboratory for Energy System Process Conversion and Emission Control Technology of Jiangsu Province, School of Energy and Mechanical Engineering, Nanjing Normal University

College of Energy Power and Mechanical Engineering, North China Electric Power University

Energy Storage and Novel Technology of Electrical Engineering Department, China Electric Power Research Institute Limited Company

School of Mechanical Engineering, Lanzhou Jiaotong University

Key Laboratory of Railway Vehicle Thermal Engineering, Ministry of Education

⁰