CO<sub>2</sub> absorption properties of supported [APMIm][Br]

CHEN Yifeng; WANG Changsong; DING Jian; YANG Zhuhong; LU Xiaohua

doi:10.3969/j.issn.0438-1157.2014.05.022

您当前的位置：

首页 >

文章列表页 >

CO₂ absorption properties of supported [APMIm][Br]

更新时间：2025-12-10

- CO₂ absorption properties of supported [APMIm][Br]
- CIESC Journal Issue 5, Pages: 1716-1720(2014)
- 作者机构：
  
  南京工业大学材料化学国家重点实验室,江苏,南京,210009
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.05.022
  CLC： 511
- Online First：05 May 2014，
  
  Published：05 May 2014
- 稿件说明：
移动端阅览
CHEN Yifeng, WANG Changsong, DING Jian, et al. CO₂ absorption properties of supported [APMIm][Br][J]. CIESC Journal, 2014, (5): 1716-1720. DOI: 10.3969/j.issn.0438-1157.2014.05.022.
DOI：

CHEN Yifeng, WANG Changsong, DING Jian, et al. CO₂ absorption properties of supported [APMIm][Br][J]. CIESC Journal, 2014, (5): 1716-1720. DOI: 10.3969/j.issn.0438-1157.2014.05.022. DOI：

摘要

1-氨丙基-3-甲基咪唑溴盐（[APMIm][Br]）离子液体通过化学反应捕集CO2。采用浸渍-蒸发将[APMIm][Br]离子液体负载在硅胶表面，通过比表面孔隙吸附测定仪、热重分析仪（TGA）对吸收剂的结构与性能进行研究，负载量为10%～50%，温度为303.15～323.15 K，CO2浓度分别为10%、30%、50%。结果表明：硅胶表面的离子液体薄膜厚度达到86 nm（负载40%）时，具有最快的吸收速率，且受CO2浓度和温度变化的影响较小，平衡吸收量在50% CO2体系中达到理论吸收量的80%，随着温度的升高而降低，当负载量为50%时，膜厚增加到230 nm，导致吸收速率和平衡吸收量大幅度下降。值得注意的是：负载离子液体吸收剂在循环使用3次之后，结构与性能均保持不变，表现出一定的工业运用前景。

Abstract

CO2 was absorbed by 1-aminopropyl-3-methylimidazolium bromine([APMIm][Br])as chemical reaction. The absorbents were prepared by supporting ionic liquids on porous silica gel through the impregnation-evaporation method

and pore structure and absorption capacity were characterized with specific surface pore adsorption apparatus and thermogravimetric analysis

respectively. CO2 absorption was conducted under the following conditions: 10% to 50% of ionic liquids loading

303.15 K to 323.15 K of temperature

and 10%

30%

50% of CO2 in mixed gas. The results suggested that absorption rate was fastest when film thickness of ionic liquids on the silica gel was 86 nm

and was little affected by the change of CO2 concentration and temperature. Equilibrium absorption amount reached 80% of the theoretical uptake in 50% CO2 system

and was reducing with increasing temperature. However

absorption rate and capacity decreased obviously as film thickness of ionic liquid exceeded 230 nm. The properties of supported ionic liquid absorbent remained unchanged after recycling three times

showing the prospect of industrial use.

关键词

Keywords

references

Views

940

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Absorption performance and stratification mechanism of biphasic CO2 absorbent[Bmim] [BF4]/MEA aqueous mixtures

Effect of sulfolane on CO2 absorption and desorption by monoethanolamine aqueous solution

Thermodynamic modeling and process simulation for CO2 absorption into aqueous monoethanolamine solution

Vapor liquid equilibria and heat of desorption of CO2 in aqueous mixture of[Bmim] [BF4] and MEA

Research progress of ozone oxidation denitrification technology

Related Author

XU Lingjun

QI Yang

WANG Shujuan

GUO Dongfang

GAO Shiwang

LUO Weiliang

CHEN Jian

LI Han

Related Institution

CSIRO Manufacturing, Clayton

Key Laboratory for Thermal Science and Power Engineering of Ministry of Education, Beijing Engineering Research Center for Ecological Restoration and Carbon Fixation of Saline-Alkaline and Desert Land, Department of Energy and Power Engineering, Tsinghua University

Huaneng Clean Energy Research Institute

State Key Laboratory of Chemical Engineering, Department of Chemical Engineering, Tsinghua University

State Key Laboratory of Chemical Engineering, Tsinghua University

⁰

CO2 absorption properties of supported [APMIm][Br]

DOI：10.3969/j.issn.0438-1157.2014.05.022

摘要

Abstract

关键词

Keywords

references

CO₂ absorption properties of supported [APMIm][Br]