Effect of real gas on dynamic performance of T-groove dry gas seal

SONG Pengyun; HU Xiaopeng; XU Hengjie

doi:10.3969/j.issn.0438-1157.2014.04.026

您当前的位置：

首页 >

文章列表页 >

Effect of real gas on dynamic performance of T-groove dry gas seal

更新时间：2025-12-10

- Effect of real gas on dynamic performance of T-groove dry gas seal
- CIESC Journal Issue 4, Pages: 1344-1352(2014)
- 作者机构：
  
  昆明理工大学化学工程学院,云南,昆明,650500
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.04.026
  CLC： 277.9TH136
- Online First：10 January 2014，
  
  Published：10 January 2014
- 稿件说明：
移动端阅览
SONG Pengyun, HU Xiaopeng, XU Hengjie. Effect of real gas on dynamic performance of T-groove dry gas seal[J]. CIESC Journal, 2014, (4): 1344-1352.
DOI：

SONG Pengyun, HU Xiaopeng, XU Hengjie. Effect of real gas on dynamic performance of T-groove dry gas seal[J]. CIESC Journal, 2014, (4): 1344-1352. DOI： 10.3969/j.issn.0438-1157.2014.04.026.

摘要

目前，针对干气密封的研究一般把气体处理为理想气体，但是在高压工况下，气体的实际行为与理想气体有较大差异。采用维里方程表达气体的实际行为，获得实际气体效应修正的气体润滑雷诺方程，利用小扰动法和有限差分法求解该雷诺方程，获得压力分布，进而获得气膜刚度和气膜阻尼等表征干气密封动态特性参数。针对T槽干气密封，以二氧化碳（CO2）、氢气（H2）和氮气（N2）为例，分别分析了实际气体效应对T槽干气密封的气膜刚度和气膜阻尼等动态特性的影响，并与理想气体进行对比，结果表明：随着压缩数的增大，三种实际气体与理想气体的气膜刚度、气膜阻尼均增大。随着频率数的增大，实际气体与理想气体的气膜刚度增大，气膜阻尼减小。实际气体气膜刚度、气膜阻尼偏离理想气体气膜刚度、气膜阻尼的程度随着压缩因子Z偏离理想气体（Z=1）的程度增加而增加。对于CO2 （Z<1），气膜刚度大于理想气体气膜刚度，而气膜阻尼小于理想气体气膜阻尼。对于H2 （Z>1），气膜刚度小于理想气体气膜刚度，而气膜阻尼大于理想气体气膜阻尼。N2（Z≈1）的气膜刚度与气膜阻尼与理想气体近似相等。

Abstract

Lubricating gas is generally considered as ideal gas in the study of dry gas seal. However

the behavior of real gas is quite different from that of ideal gas under high pressures. In this study

the virial equation was used to express the behavior of gas to obtain a Reynolds equation for gas lubricating

modified by the effect of real gas. The Reynolds equation was solved by perturbation method and finite difference method to obtain the pressure distribution

and the dynamic characteristic parameters of dry gas seal

such as gas film stiffness and gas film damping

were obtained. As to the T-groove dry gas seal

carbon dioxide (CO2)

hydrogen (H2) and nitrogen (N2) were taken as examples to analyze the influence of real gas upon the gas film stiffness and gas film damping of T-groove dry gas seal

which were compared with those of ideal gas. The results show that the gas film stiffness and gas film damping of the three real gases and ideal gas increase with the squeeze number. Gas film stiffness of the real gas and ideal gas increase with the increase of frequency number

while the gas film damping decreases. The deviations of the film stiffness and gas film damping of real gas from those of ideal gas increases with the derivation of compressibility number Z from ideal gas (Z=1). For CO2 (Z<1)

its gas film stiffness is larger than that of ideal gas

while the gas film damping is smaller. For H2 (Z>1)

its gas film stiffness is smaller than that of ideal gas

but the gas film damping is larger. For N2 (Z≈1)

both the gas film stiffness and gas film damping are approximately equal to those of ideal gas.

关键词

Keywords

references

Views

368

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effects of the real-gas characteristics of carbon dioxide with impurities on the dry gas seal performance

Analysis of performance of spiral groove dry gas seal considered effects of both real gas and slip flow

Performance analysis and structural optimization of double-sided spiral groove-type dry gas seal

Numerical calculation of CO2 pipeline fracture propagation based on crack tip decompression characteristics

Flow simulation and sealing performance test of ultra-high speed dry gas seal under multiple effects

Related Author

Wei CHEN

Pengyun SONG

Hengjie XU

Xuejian SUN

ZHANG Shuai

WANG Yan

WANG Yutong

CHEN Miaomiao

Related Institution

Faculty of Mechanical and Electrical Engineering, Kunming University of Science and Technology

School of Mechanical Engineering, Jiangsu Ocean University

Ningbo Fangli Seals Co., Ltd.

School of Mechanical and Electronic Engineering, Nanjing Forestry University

Sinoseal Holding Co., Ltd.

⁰