Additional mass due to moisture uptake of foam at 45 K

ZHANG Xiaobin; CHEN Jianye; GAN Zhihua; QIU Limin; YANG Ruping; MA Xiaojing

doi:10.3969/j.issn.0438-1157.2014.04.009

您当前的位置：

首页 >

文章列表页 >

Additional mass due to moisture uptake of foam at 45 K

更新时间：2025-12-10

- Additional mass due to moisture uptake of foam at 45 K
- CIESC Journal Issue 4, Pages: 1215-1220(2014)
- 作者机构：
  
  1. 浙江大学制冷与低温研究所,浙江,杭州,310027
  2. 航天材料及工艺研究所,北京,100076
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.04.009
  CLC： 514.2
- Online First：10 January 2014，
  
  Published：10 January 2014
- 稿件说明：
移动端阅览
ZHANG Xiaobin, CHEN Jianye, GAN Zhihua, et al. Additional mass due to moisture uptake of foam at 45 K[J]. CIESC Journal, 2014, (4): 1215-1220.
DOI：

ZHANG Xiaobin, CHEN Jianye, GAN Zhihua, et al. Additional mass due to moisture uptake of foam at 45 K[J]. CIESC Journal, 2014, (4): 1215-1220. DOI： 10.3969/j.issn.0438-1157.2014.04.009.

摘要

为减少火箭上液氢/液氧燃料蒸发损失，要求绝热材料热导率小，附加质量轻，并有好的抗应力强度。泡沫塑料因其密度低、绝热性能及机械强度好等优点，是国内外最广泛使用的火箭上深低温系统绝热材料。但泡沫塑料长时间存在大温度梯度时，将强化吸湿增重，从而增加火箭起飞附加质量，也恶化绝热效果。因此，获得可靠的泡沫塑料吸湿增重数据对大推力火箭推力设计有重要意义。报告了用脉管制冷机冷却的泡沫塑料吸湿增值实验装置及实验结果。利用两台自行研制的GM型单级脉管制冷机提供冷量，样本一面被冷却到约45 K温度，同时另一面暴露在30℃恒温及>95%的相对湿度环境。设计了一种波纹管结构来减少环境对真空低温系统的漏热。总共测试了4组8个样本，测试时间为7 h。测试结果与液氮温度的测试结果进行对比和分析，结果发现两者吸湿增重相同，即温度梯度降低引起的低温泵增强效应在该温区可忽略不计。同时发现样本搭接结构对吸湿增重没有影响。

Abstract

Low thermal conductivity

small additional mass and good mechanical strength are basic requirements for the thermal insulation of liquid hydrogen and liquid oxygen tank on the rocket. Polyurethane (PU) foam is the most widely-used material in the insulation of the cryogenic tank in rocket due to its light mass

good thermal and mechanical performance. However

long-time exposure to large temperature gradient will incur additional mass due to moisture uptake

which also deteriorates the thermal performance. Thus it is important to determine the exact additional mass for the design of the rocket thrust. This paper designs an experimental apparatus for the test of PU foam specimen

one side of which is cooled to about 45 K and another is exposed to temperature controlled at 30°C and relative humidity of > 95%. Two home-made pulse tube coolers are used to provide the cooling power

which are installed on a vacuum room. Totally 4 groups with each 2 specimens are tested

and the data are compared to the test results at temperature of 78 K. The results reveal that the effects of cryogenic pump for 78 K and 45 K on one side have no effects on the moisture uptake and the butt-jointed structure.

关键词

Keywords

references

Views

492

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on prediction of regeneration rate of mine dehumidification solution

Experimental study on heat and mass transfer performance of elliptical tube-fin evaporative condenser

Mass transfer study of CO2 absorption by TETA/DEEA biphasic absorbent in the microchannel

Numerical simulation of CO2 absorption by alkali liquor in T-junction cylindrical microchannels

Effects of contamination on the motion and mass transfer of single bubble

Related Author

HUANG Rongting

TAO Yichun

CHEN Jianglin

LI Shihang

YANG Zixi

WANG Shiyuan

LUO Xiangxuan

REN Xianchao

Related Institution

State Key Laboratory of Coal Mine Disaster Prevention and Control, School of Safety Engineering, China University of Mining and Technology

Key Laboratory of Gas and Fire Control for Coal Mines, Ministry of Education， China University of Mining and Technology

National Engineering Research Center for Coal Gas Control, China University of Mining and Technology

Jiangsu Engineering Research Center of Dust Control and Occupational Protection, School of Safety Engineering, China University of Mining and Technology

Jiangsu Key Laboratory of Coal-based Greenhouse Gas Control and Utilization, Carbon Neutrality Institute, China University of Mining and Technology

⁰