Numerical simulation on shell side fluid flow and heat transfer in heat exchanger with trefoil-baffles

ZHU Lingyun; LANG Hongfang; ZHOU Guoyan; GUO Zhen; TAN Xianghui; YANG Jinchun; ZHU Dongsheng

doi:10.3969/j.issn.0438-1157.2014.03.009

您当前的位置：

首页 >

文章列表页 >

Numerical simulation on shell side fluid flow and heat transfer in heat exchanger with trefoil-baffles

更新时间：2025-12-10

- Numerical simulation on shell side fluid flow and heat transfer in heat exchanger with trefoil-baffles
- CIESC Journal Issue 3, Pages: 829-835(2014)
- 作者机构：
  
  1. 华东理工大学承压系统与安全教育部重点实验室,上海,200237
  2. 深圳中广核工程设计有限公司,广东,深圳,518031
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.03.009
  CLC： K124
- Online First：05 March 2014，
  
  Published：05 March 2014
- 稿件说明：
移动端阅览
ZHU Lingyun, LANG Hongfang, ZHOU Guoyan, et al. Numerical simulation on shell side fluid flow and heat transfer in heat exchanger with trefoil-baffles[J]. CIESC Journal, 2014, (3): 829-835.
DOI：

ZHU Lingyun, LANG Hongfang, ZHOU Guoyan, et al. Numerical simulation on shell side fluid flow and heat transfer in heat exchanger with trefoil-baffles[J]. CIESC Journal, 2014, (3): 829-835. DOI： 10.3969/j.issn.0438-1157.2014.03.009.

摘要

三叶孔板换热器是一种新型纵流换热器，广泛应用于核电装备领域。针对目前使用较多的壳程“单元流道”模型的局限性，建立了三叶孔板换热器壳程整体模型，包括进出口接管。采用商用软件FLUENT14.0及RNG k-ε湍流模型对壳程流体流动与传热进行了数值研究，分析了三叶孔板换热器壳程流动与传热特性。结果表明：流经第一块支撑板后，流体已充分发展，并且随着壳程结构周期性变化，传热与压降也呈现周期性变化。在支撑板附近，流体流速变大，形成射流，并且由于支撑板阻挡，在支撑板前面和尾部产生二次流，能有效冲刷管壁，减薄流动边界层，起到强化传热作用。

Abstract

Heat exchangers with trefoil-baffle are a new type heat transfer device and are widely used in nuclear power system due to their special advantages

with the fluid flowing longitudinally on the shell side. In this study

to avoid the limitation of unit duct model

a whole model for the heat exchanger with trefoil-baffles is established including inlet and outlet nozzles. Based on the RNG k-ε model

numerical simulation shell side fluid flow and heat transfer are conducted by using commercial CFD software FLUENT14.0. Characteristics of fluid flow and heat transfer performance on the shell side are analyzed. The results show that the fluid is fully developed after the first trefoil-baffle and the heat transfer coefficient and pressure drop vary periodically along the shell side. Fluid velocity increases gradually and the jet flow forms in the region near baffles. The secondary flow is also produced on two sides of baffles when the fluid flows through the trefoil-baffle. The jet flow and secondary flow can decrease the thickness of boundary layer and enhance the heat transfer.

关键词

Keywords

references

Views

484

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Prediction of scale factor of heat exchangers based on CNN-LSTM neural network

Local deposition characteristics of CaCO3 fouling under different roughness element structures

Study on coupling operation characteristics of Stirling engine and high temperature heat pipe

A new method of numerical design for flat tube fin heat exchanger

Effect of methane explosion on distribution of pressure field inside and outside buildings

Related Author

ZHANG Hanxiao

WANG Ruiqi

ZHANG Yating

HAN Zhimin

ZHOU Xiangyu

ZHANG Hongyu

XU Zhiming

SONG Jiahao

Related Institution

College of Chemistry and Chemical Engineering, Xi’an University of Science and Technology

School of Energy and Power Engineering, Northeast Electric Power University

School of Mechanical and Power Engineering, Shanghai Jiao Tong University

School of Environmental and Municipal Engineering, Lanzhou Jiaotong University

School of Civil Engineering, Lanzhou University of Technology

⁰