Effects of surface deposition on quenching boiling of aqueous suspension with graphene oxide nanosheets

DONG Feiying; LI Danyang; ZHANG Liang; FAN Liwu; XU Xu; YU Zitao; HU Yacai

doi:10.3969/j.issn.0438-1157.2014.02.037

您当前的位置：

首页 >

文章列表页 >

Effects of surface deposition on quenching boiling of aqueous suspension with graphene oxide nanosheets

更新时间：2025-12-10

- Effects of surface deposition on quenching boiling of aqueous suspension with graphene oxide nanosheets
- CIESC Journal Issue 2, Pages: 628-632(2014)
- 作者机构：
  
  1. 浙江大学热工与动力系统研究所,浙江,杭州,310027
  2. 中国计量学院计量测试工程学院,浙江,杭州,310018
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.02.037
  CLC： K124
- Online First：05 February 2014，
  
  Published：05 February 2014
- 稿件说明：
移动端阅览
DONG Feiying, LI Danyang, ZHANG Liang, et al. Effects of surface deposition on quenching boiling of aqueous suspension with graphene oxide nanosheets[J]. CIESC Journal, 2014, (2): 628-632.
DOI：

DONG Feiying, LI Danyang, ZHANG Liang, et al. Effects of surface deposition on quenching boiling of aqueous suspension with graphene oxide nanosheets[J]. CIESC Journal, 2014, (2): 628-632. DOI： 10.3969/j.issn.0438-1157.2014.02.037.

摘要

采用淬火法对质量分数为0.002%的氧化石墨烯水悬浮液的瞬态沸腾特性进行了表征。通过对三种代表性工况的对比分析研究了氧化石墨烯在沸腾表面的沉积对淬火沸腾过程的影响。由于氧化石墨烯在过渡沸腾阶段的沉积，水悬浮液的淬火过程较之去离子水缩短了约10 s，临界热通量则提升了约10%，对应的表面接触角从104°减小到78°。将已沉积表面再次在去离子水中淬火后，表面接触角回升到89°，临界热通量则有所回落。结果表明，氧化石墨烯的表面沉积虽然是强化临界热通量的决定性因素，但淬火过程的速率和过渡沸腾阶段的传热速率还受到氧化石墨烯的动态沉积过程和水悬浮液中悬浮氧化石墨烯的共同影响。

Abstract

The transient boiling of an aqueous suspension with graphene oxide nanosheets (GONs)

at a mass fraction of 0.002%

was characterized using the quenching method. The effects of GONs deposited on the boiling surface were compared among three representative cases. With the deposition of GONs during the transition boiling phase

the quenching period of the suspension was shortened by 10 s as compared to that of deionized water

while the critical heat flux (CHF) was improved by 10% and the contact angle was reduced from 104° to 78°. After subsequent quenching of the boiling surface with GON deposition in deionized water

the contact angle was increased to 89° and the CHF was somewhat deteriorated. It was concluded that the enhancement of CHF is primarily resulted from surface deposition of GONs. The quenching speed and the heat transfer rate during the transition boiling phase are also affected by the dynamic deposition process and the suspended GONs.

关键词

Keywords

references

Views

301

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Heat transfer capacity of spray cooling under vibration environment

Experimental study on the downward-facing surface enhanced boiling heat transfer of multiscale groove-fin structures

Research on enhanced boiling heat transfer of multilevel composite wick structure

Research progress on basic theory and improvement technology for critical heat flux of microchannel

Novel flat plate evaporator of loop gravity assisted heat pipe for high heat flux electronic cooling

Related Author

HUANG Jinzuo

LI Zhaohua

CHEN Xinwen

QIAN Yuqi

ZHANG Meng

ZHOU Hang

ZHAO Xiucong

ZHANG Junfeng

Related Institution

College of Mechanical Engineering, Yangzhou University

Beijing Key Laboratory of Passive Nuclear Power Safety and Technology, North China Electric Power University

School of Nuclear Science and Engineering, Shanghai Jiao Tong University

School of Energy and Power Engineering, Nanjing University of Science and Technology

Hefei General Environment Control Technology Co., Ltd.

⁰