Pseudo-homogeneous model for wet process of dust removal in spiral plate exchanger with axial-cross flow

XU Qipeng; GUI Yueming; ZHU Jiahua; CHENG Yuangui; XIA Sulan

doi:10.3969/j.issn.0438-1157.2014.02.009

您当前的位置：

首页 >

文章列表页 >

Pseudo-homogeneous model for wet process of dust removal in spiral plate exchanger with axial-cross flow

更新时间：2025-12-10

- Pseudo-homogeneous model for wet process of dust removal in spiral plate exchanger with axial-cross flow
- CIESC Journal Issue 2, Pages: 430-436(2014)
- 作者机构：
  
  四川大学化工学院,四川,成都,610065
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2014.02.009
  CLC： 51TK1
- Online First：05 February 2014，
  
  Published：05 February 2014
- 稿件说明：
移动端阅览
XU Qipeng, GUI Yueming, ZHU Jiahua, et al. Pseudo-homogeneous model for wet process of dust removal in spiral plate exchanger with axial-cross flow[J]. CIESC Journal, 2014, (2): 430-436.
DOI：

XU Qipeng, GUI Yueming, ZHU Jiahua, et al. Pseudo-homogeneous model for wet process of dust removal in spiral plate exchanger with axial-cross flow[J]. CIESC Journal, 2014, (2): 430-436. DOI： 10.3969/j.issn.0438-1157.2014.02.009.

摘要

提出了螺旋板换热器轴向错流通道冷却冷凝湿法除尘的方法，指出了PM2.5在尾气对流传热传质边界层内热泳和伴随水蒸气冷凝的扩散泳运动特征和冷凝液膜吸收除尘机理并建立了拟均相模型，获得了PM2.5浓度衰减函数和以冷凝通量nw为参数的捕尘效率模型。通过“三传”类比获得了从尾气流速求取模型参数的方法，并通过恒壁温条件下冷却冷凝实验数据验证了模型参数计算方法的正确性，结果表明水蒸气组分扩散体积通量即PM2.5扩散泳速度Vw是控制性参数，其值在20～40 mm·s-1范围。

Abstract

A wet process of PM2.5 removal from industrial waste gases was proposed

with cooling and condensation in the axial channel of a spiral plate exchanger. The characteristics of thermo-phoresis and diffusion-phoresis of PM2.5 with vapor component in the boundary layer of heat and mass transfer were pointed out. A pseudo-homogeneous model was built based on the mechanism on dust removal by condensate film absorption. Subsequently

the attenuation function of PM2.5 concentration was deduced. The dust removal efficiency equation

with the condensate flux nw and the waste gas inlet velocity u0 as the variables

was obtained. Parameters in the model were derived by means of analogies of momentum

heat and mass transfer

and verified with the experimental data of cooling and condensation under constant wall temperatures. It is shown that the key factor is the vapor diffusion volume flux (or called PM2.5 diffusion-phoresis velocity) Vw with the magnitude of 20—40 mm·s-1.

关键词

Keywords

references

Views

404

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Heat transfer simulation analysis of carbonylation in fixed-bed reactor coupled with mass transfer

Study on entropy wave production and dissipation in partially premixed swirl flames subject to inlet perturbations

Oxygen mass transfer performance of hollow fiber non-bubble aeration membrane based on gas/liquid-phase measurement method

Progress in research of selective oxidation of low carbon polyols over nano-Au catalysts with precise electronic effect regulation

Thermodynamic performance of tower-type solar-assisted supercritical compression CO2 energy storage system

Related Author

Ying LI

Zheqi LI

Xiangping ZHANG

Related Institution

School of Environmental and Chemical Engineering, Dalian Jiaotong University

Institute of Process Engineering, Chinese Academy of Sciences

⁰