Pyrolysis of propane to acetylene using high-power rotating arc hydrogen plasma

SU Baogen; FANG Jianwei; WEN Guangdong; MA Jie; XING Huabin; REN Qilong

doi:10.3969/j.issn.0438-1157.2013.11.021

您当前的位置：

首页 >

文章列表页 >

Pyrolysis of propane to acetylene using high-power rotating arc hydrogen plasma

更新时间：2025-12-10

- Pyrolysis of propane to acetylene using high-power rotating arc hydrogen plasma
- CIESC Journal Issue 11, Pages: 4039-4045(2013)
- 作者机构：
  
  浙江大学化学工程与生物工程学系, 生物质化工教育部重点实验室,浙江,杭州,310027
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2013.11.021
  CLC： Q211
- Online First：05 November 2013，
  
  Published：05 November 2013
- 稿件说明：
移动端阅览
SU Baogen, FANG Jianwei, WEN Guangdong, et al. Pyrolysis of propane to acetylene using high-power rotating arc hydrogen plasma[J]. CIESC Journal, 2013, (11): 4039-4045.
DOI：

SU Baogen, FANG Jianwei, WEN Guangdong, et al. Pyrolysis of propane to acetylene using high-power rotating arc hydrogen plasma[J]. CIESC Journal, 2013, (11): 4039-4045. DOI： 10.3969/j.issn.0438-1157.2013.11.021.

摘要

通过合理的简化计算

建立了物料与能量衡算模型

优选工艺条件

并进行了MW级旋转弧氢等离子体裂解丙烷制乙炔的实验研究

考察了碳氢比与氢气比焓对裂解反应的影响。实验中输入功率的最大值为794.2 kW

实验结果表明:在实验范围内

丙烷的转化率维持在99.8%以上

裂解气中乙炔的最高含量达到了12.65%;碳氢比增加时

乙炔收率和比能耗均存在最佳点;氢气比焓增加时

乙炔收率存在最佳点

而比能耗则逐渐增加;实验中得到的最高乙炔收率为85.4%

最低比能耗为8.85 kW·h·(kg C2H2)-1。实验结果验证了物料与能量衡算模型可以用于指导工艺条件的优选。

Abstract

A theoretical model used for selecting optimum experimental conditions was established by calculation of material and energy balance.Experimental conditions were determined according to this theoretical model.Pyrolysis of propane to acetylene was conducted in 1 MW plasma torch.Carbon hydrogen ratio and specific enthalpy of hydrogen were investigated

because they affected propane conversion efficiency

acetylene yield and specific energy of requirement; and the relationship among them were analyzed.The maximum input power in this experiment was 794.2 kW.The conversion efficiencies of propane were more than 99.8%

the highest concentration of acetylene was 12.65%.The best results of acetylene yield and specific energy of requirement could be found in this experimental range

when carbon hydrogen ratio changed.With the increase of specific enthalpy of hydrogen

there existed an optimum value of acetylene yield

while the value of specific energy of requirement increased.The highest acetylene yield obtained was 85.4% and the lowest specific energy of requirement was 8.85 kW·h·(kg C2H2)-1.The theoretical model could be used for optimizing experimental conditions according to these results.

关键词

Keywords

references

Views

797

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Thermodynamic analysis on synthesis of key intermediate BaC2 in coal to acetylene

Influences of working conditions on heat transfer characteristics in shell side of LNG spiral wound heat exchangers

Adsorption isotherms and selectivity of CH4/C2H6/C3H8 on MOF-505@5GO

Porous hydrogen-bonded organometallic frameworks for adsorption separation of acetylene and carbon dioxide

Reaction behaviors and feed characterization of light hydrocarbon catalytic pyrolysis for production of light olefins

Related Author

YAN Long

CHEN Siyuan

JIANG Biao

ZHAO Hong

LI Miao

YU Sicong

DING Chao

HU Haitao

Related Institution

Shanghai Advanced Research Institute, Chinese Academy of Sciences

University of Chinese Academy of Sciences

School of Chemistry and Chemical Engineering, Yulin University

R & D Center, CNOOC Gas & Power Group

School of Mechanical Engineering, Shanghai Jiao Tong University

⁰