Adsorption thermodynamics and kinetics of three anionic polymeric dispersants onto imidacloprid particle surface

HAO Han; FENG Jianguo; MA Chao; FAN Tengfei; WU Xuemin

doi:10.3969/j.issn.0438-1157.2013.10.048

您当前的位置：

首页 >

文章列表页 >

Adsorption thermodynamics and kinetics of three anionic polymeric dispersants onto imidacloprid particle surface

更新时间：2025-12-10

- Adsorption thermodynamics and kinetics of three anionic polymeric dispersants onto imidacloprid particle surface
- CIESC Journal Issue 10, Pages: 3838-3850(2013)
- 作者机构：
  
  中国农业大学应用化学系, 农业部农药化学与应用技术重点开放实验室,北京,100193
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2013.10.048
  CLC： Q450.4
- Online First：05 October 2013，
  
  Published：05 October 2013
- 稿件说明：
移动端阅览
HAO Han, FENG Jianguo, MA Chao, et al. Adsorption thermodynamics and kinetics of three anionic polymeric dispersants onto imidacloprid particle surface[J]. CIESC Journal, 2013, (10): 3838-3850.
DOI：

HAO Han, FENG Jianguo, MA Chao, et al. Adsorption thermodynamics and kinetics of three anionic polymeric dispersants onto imidacloprid particle surface[J]. CIESC Journal, 2013, (10): 3838-3850. DOI： 10.3969/j.issn.0438-1157.2013.10.048.

摘要

通过振荡吸附实验研究了三种阴离子聚合物分散剂Morwet D-425、GYD-1252和LG-3在农药吡虫啉颗粒表面的吸附热力学和动力学

对比分析了三种分散剂吸附性能的差异。吸附等温线符合Langmuir和Freundlich吸附等温方程

前者拟合程度较高。由ΔG<0、ΔH<0、ΔS>0可知该吸附为自发、放热、熵增过程

高温不利于吸附进行

|ΔH|<40 kJ·mol-1表明该吸附为物理吸附。通过对比可知Morwet D-425吸附稳定性最高

受温度影响最小;LG-3吸附稳定性最低

受温度影响最大;GYD-1252吸附稳定性介于两者之间。吸附动力学曲线最符合伪二级动力学方程

吸附过程包括颗粒外传质扩散和表面吸附两个步骤

不包括颗粒内微孔扩散。吸附速率由大到小的顺序为Morwet D-425、GYD-1252、LG-3.通过XPS测定不同温度下分散剂吸附层厚度可知Morwet D-425在吡虫啉颗粒表面的吸附致密

吸附层厚度较低但随温度升高变化很小;GYD-1252和LG-3在吡虫啉颗粒表面吸附疏松

低温下吸附层厚度较高但随温度升高明显降低。

Abstract

The adsorption thermodynamics and kinetics of three dispersants(Morwet D-425

GYD-1252 and LG-3)onto pesticide imidacloprid particle surface were studied in order to compare adsorption properties.Adsorption data of three dispersants onto imidacloprid were fitted with Langmuir and Freundlich isotherm equations

and the former fitted better.The thermodynamic parameters:ΔH<0

ΔG<0

ΔS>0

indicated that the adsorption was a spontaneous exothermic process.Theoretically

higher temperature was not beneficial to adsorption process

|ΔH|<40 kJ·mol-1 indicated that the adsorption process was physical adsorption.The conclusion obtained by comparing adsorption properties showed that Morwet D-425 had higher adsorption stability and was not susceptible to temperature effects

LG-3 had lower adsorption stability and was susceptible to temperature effects

adsorption stability of GYD-1252 was in between.The adsorption process followed the pseudo-second-order with a good correlation coefficient.The step of adsorption process included the external diffusion and adsorption onto particle surface

without intraparticle diffusion.Descending order of adsorption rate was Morwet D-425

GYD-1252 and LG-3.The result of adsorption layer thickness by XPS showed that Morwet D-425 had smaller adsorbed layer thickness which changed little with increasing temperature due to higher adsorption stability. GYD-1252 and LG-3 had larger adsorbed layer thickness which decreased significantly with increasing temperature due to weak adsorption stability.

关键词

Keywords

references

Views

315

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Mechanisms of action between Bacillus subtilis and uranium(Ⅵ) in water

Adsorption of polycarboxylate dispersant onto imidacloprid particle surfaces

Influence of solution environment on the dispersion stability of nanoparticle liquid system

Effect of hollow structure on the acetone adsorption property of tungsten-substituted MFI zeolite

Adsorption properties of naphthalenesulfonate dispersant onto different crystal pyraclostrobin particle surfaces

Related Author

HUANG Rong

NIE Xiaoqin

DONG Faqin

ZHANG Dong

KANG Wu

YANG Jie

MA Jialin

ZHOU Xian

Related Institution

Fundamental Science on Nuclear Wastes and Environmental Safety Laboratory, Southwest University of Science and Technology

Institute of Nuclear Physics and Chemistry, China Academy of Engineering Physics

Shanxi Key Laboratory of Chemical Product Engineering, College of Chemical Engineering and Technology, Taiyuan University of Technology

College of Chemical Engineering and Technology, Xi’an Jiaotong University

Hangzhou Oxygen Plant Group Co., Ltd.

⁰