Mode identification of pool boiling of water by acoustic emission

ZHANG Qing; DONG Kezeng; HUANG Zhengliang; WANG Jingdai; YANG Yongrong

doi:10.3969/j.issn.0438-1157.2013.10.006

您当前的位置：

首页 >

文章列表页 >

Mode identification of pool boiling of water by acoustic emission

更新时间：2025-12-10

- Mode identification of pool boiling of water by acoustic emission
- CIESC Journal Issue 10, Pages: 3527-3533(2013)
- 作者机构：
  
  浙江大学化学工程与生物工程学系, 化学工程联合国家重点实验室(浙江大学),浙江,杭州,310027
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2013.10.006
  CLC： Q026.4
- Online First：05 October 2013，
  
  Published：05 October 2013
- 稿件说明：
移动端阅览
ZHANG Qing, DONG Kezeng, HUANG Zhengliang, et al. Mode identification of pool boiling of water by acoustic emission[J]. CIESC Journal, 2013, (10): 3527-3533.
DOI：

ZHANG Qing, DONG Kezeng, HUANG Zhengliang, et al. Mode identification of pool boiling of water by acoustic emission[J]. CIESC Journal, 2013, (10): 3527-3533. DOI： 10.3969/j.issn.0438-1157.2013.10.006.

摘要

采用声发射技术

结合频域和时域分析手段

研究了池内水沸腾过程中声信号变化与沸腾状态转变的对应关系。结果表明

当过热度为5℃时

沸腾由自然对流状态转变为核态沸腾状态

此时声信号能量、标准偏差和平均绝对偏差值均达到极值点;当过热度为30℃时

沸腾由核态沸腾状态转变为过渡沸腾状态

此时声信号能量、标准偏差和平均绝对偏差值开始出现剧烈的波动。与此同时

随过热度的增加

沸腾过程中声信号主频出现两次明显的阶跃性下降

分别对应于沸腾状态转变为核态沸腾和过渡沸腾。因此

声信号主频的阶跃性变化可作为沸腾状态转变的判据。与该领域的其他工作相比

不仅考察了自然对流状态和核态沸腾状态

还考察了核态沸腾向过渡沸腾的转变过程

同时提出了沸腾状态转变的判据。与传统方法相比

该法相对简单准确

具有灵敏度高、非侵入式、实时在线的优点。

Abstract

Based on acoustic emission technique

the acoustic signals during pool boiling of water were measured and the relationship between boiling modes and acoustic signal characteristics was investigated by time-domain and frequency-domain analysis.The results showed that the values of acoustic energy

standard deviation(STD)and average absolute deviation(AAD)indicated extreme points when the boiling mode changed from natural convection to nucleate boiling at an excess temperature of 5℃.After transition boiling began at excess temperature of 30℃

the values of acoustic energy

STD and AAD changed irregularly.As excess temperature increased

the dominant frequency of acoustic signals showed two step decreases

at which excess temperatures were the turning points from natural convection to nucleate boiling and from nucleate boiling to transition boiling

respectively.Therefore

the step change of dominant frequency could be used as a criterion to identify the emergences of nucleate boiling and transition boiling.In comparison with the work published before

this work investigated transition boiling as well as natural convection and nucleate boiling.The criterion to determine boiling mode transition is proposed. Compared with conventional methods

this method was relatively fast

sensitive

accurate

non-intrusive and real-time online.

关键词

Keywords

references

Views

327

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Synergistic heat transfer enhancement characteristics due to electric field and macro-structured surface during thin film boiling

Characteristics of gas-liquid two-phase heat transfer in a confined vapor chamber

Experimental study on performance of new type of pulsating heat pipe for battery cooling

Experimental study on enhancement of flow boiling through degassing with copper foam

Research progress on optimizing two-phase refrigerant distribution and boiling heat transfer in microchannel evaporators

Related Author

HE Changqiu

TIAN Jiameng

CHEN Yiqi

ZHU Yuchen

LIU Xin

WANG Hai

WANG Zhentao

WANG Junfeng

Related Institution

School of Energy and Power Engineering, Jiangsu University

School of Energy and Power Engineering, Chongqing University

State Key Laboratory of Multiphase Flow in Power Engineering, Xi’an Jiaotong University

School of Human Settlements and Civil Engineering, Xi’an Jiaotong University

Shenzhen Envicool Technology Co. Ltd.

⁰