Heat requirement for regeneration of a CO<sub>2</sub> capture system using amine solutions

LI Xiaofei; WANG Shujuan; CHEN Changhe

doi:10.3969/j.issn.0438-1157.2013.09.037

您当前的位置：

首页 >

文章列表页 >

Heat requirement for regeneration of a CO₂ capture system using amine solutions

更新时间：2025-12-10

- Heat requirement for regeneration of a CO₂ capture system using amine solutions
- CIESC Journal Issue 9, Pages: 3348-3355(2013)
- 作者机构：
  
  热科学与动力工程教育部重点实验室, 二氧化碳资源化利用与减排技术北京市重点实验室, 清华大学热能工程系,北京,100084
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2013.09.037
  CLC： K09
- Online First：05 September 2013，
  
  Published：05 September 2013
- 稿件说明：
移动端阅览
LI Xiaofei, WANG Shujuan, CHEN Changhe. Heat requirement for regeneration of a CO₂ capture system using amine solutions[J]. CIESC Journal, 2013, (9): 3348-3355. DOI: 10.3969/j.issn.0438-1157.2013.09.037.
DOI：

LI Xiaofei, WANG Shujuan, CHEN Changhe. Heat requirement for regeneration of a CO₂ capture system using amine solutions[J]. CIESC Journal, 2013, (9): 3348-3355. DOI: 10.3969/j.issn.0438-1157.2013.09.037. DOI：

摘要

胺法脱碳系统最大的缺陷是再生能耗高

流程参数优化是降低再生能耗的有效途径。为了解再生操作参数对再生能耗的影响

通过再生塔实验台对醇胺吸收剂在不同再生工艺参数下的再生特性进行实验研究。实验内容包括富液CO2担载量、富液进料温度、再沸器温度、再生压强及胺的种类因素对再生能耗及再生速率的影响

并分析了显热、潜热的变化规律。应用Aspen Plus 基于速率模型对再生过程进行了模拟研究。研究结果表明:提高富液CO2担载量和富液进料温度能有效降低再生能耗。增大再沸器温度及再生压强反而增大再生能耗。一乙醇胺(MEA)再生能耗较高

混入甲基二乙醇胺(MDEA)能够显著降低能耗。提高富液CO2担载量和再沸器的温度可以加快CO2再生速率。

Abstract

The main drawback of amine-based CO2 capture system is high heat requirement for the solvent regeneration.The optimization of the process parameters is an effective way to break this limitation.In this paper

the experiments are carried out to investigate the stripper performance under diverse parameters of regeneration process

including the effects of CO2 loading and feeding temperature of rich-solutions

reboiler temperature

regeneration pressure and alkanolamine type.The changes of sensible heat and heat of vaporization were analyzed.A rate-based model in Aspen Plus simulator was used to simulate the regeneration process.The results show that the heat requirement for the regeneration can be reduced by using higher CO2 loading and feeding temperature of rich-solutions

while the heat requirement for regeneration increased with increasing reboiler temperature and regeneration pressure.The regeneration heat of monoethanolamine(MEA)is quite high

and can be reduced by blending methyldiethanolamine(MDEA).The CO2 desorption rate increased with the CO2 loading of rich solution and reboiler temperature.

关键词

Keywords

references

Views

339

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

CO2/N2 separation performance of supported ionic liquid membrane fabricated by [Choline][Pro]/RTILs

Solubility and volumetric mass transfer coefficient of CO2 in 1-pentanol

Preparation and performance of Pr3+: Y2SiO5/TiO2 composites deposited on activated carbon fiber

Comparison of regeneration mechanism of Fe2+ in modified Fenton system

Effect of morphology and exposed facets of Ag3PO4 on photocatalytic reduction of CO2 to CH3OH over Ag/Ag3PO4 plasmonic photocatalysts

Related Author

LU Xiaohua

FENG Xin

LIU Chang

ZHANG Suoying

XIE Wenlong

FAN Tengteng

ZHAO Yankai

BAI Lihang

Related Institution

State Key Laboratory of Materials-Oriented Chemical Engineering, Nanjing Tech University

Feymer Membrane Technology Co

Hengtong Optical Material Co

MOE Key Laboratory of Thermo-Fluid Science and Engineering, Xi'an Jiaotong University

School of Physical Science and Technology, Xinjiang University

⁰

Heat requirement for regeneration of a CO2 capture system using amine solutions

DOI：10.3969/j.issn.0438-1157.2013.09.037

摘要

Abstract

关键词

Keywords

references

Heat requirement for regeneration of a CO₂ capture system using amine solutions