Viscous dissipation effects of polymer melts in micro-channels

YU Tongmin; YONG Heng; BEI Haixin; JIAO Xu

doi:10.3969/j.issn.0438-1157.2013.08.011

您当前的位置：

首页 >

文章列表页 >

Viscous dissipation effects of polymer melts in micro-channels

更新时间：2025-12-10

- Viscous dissipation effects of polymer melts in micro-channels
- CIESC Journal Issue 8, Pages: 2781-2787(2013)
- 作者机构：
  
  大连理工大学机械工程学院,辽宁,大连,116024
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2013.08.011
  CLC： Q311TG76
- Online First：05 August 2013，
  
  Published：05 August 2013
- 稿件说明：
移动端阅览
YU Tongmin, YONG Heng, BEI Haixin, et al. Viscous dissipation effects of polymer melts in micro-channels[J]. CIESC Journal, 2013, (8): 2781-2787.
DOI：

YU Tongmin, YONG Heng, BEI Haixin, et al. Viscous dissipation effects of polymer melts in micro-channels[J]. CIESC Journal, 2013, (8): 2781-2787. DOI： 10.3969/j.issn.0438-1157.2013.08.011.

摘要

以双料筒毛细管流变仪和自行研制的黏性耗散测量装置为实验平台

通过对聚甲醛(POM)和聚苯乙烯(PS)两种聚合物熔体在不同剪切速率下

流经长径比相同的直径/当量直径分别为350 μm和500 μm的圆形及矩形截面微通道出口熔体温升的测量

研究了微尺度通道中聚合物熔体流动时的黏性耗散效应及其对熔体流变行为的影响。结果表明

两种截面微通道中的熔体黏性耗散效应均随剪切速率和微道直径/当量直径的增大而明显增强

其中矩形截面微通道中熔体的黏性耗散作用尤为强烈;且在相同实验条件下

结晶性的POM熔体因黏性耗散效应引起的微通道出口熔体温升值

高于非晶性的PS熔体。

Abstract

The temperature increase of polyformaldehyde(POM)and polystyrene(PS)melts at the outlet of circular and rectangular micro-channels with the same aspect ratio and diameter/equivalent diameter of 350 and 500 μm was measured at different shear rates using two-cylinder capillary rheometer and self-developed viscous dissipation measurement device.The viscous dissipation and its effect on flow behavior of polymer melt in micro-channels were investigated.The results show that the viscous dissipation is enhanced obviously with the increase of shear rate and diameters/equivalent diameter value in the micro-channels.The viscous dissipation in the rectangular channel is much stronger than that in the circular one.Under the same experimental conditions

the temperature increase at the outlet of crystalline POM melt is larger than that of amorphous PS melt due to viscous dissipation.

关键词

Keywords

references

Views

261

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Viscous dissipation effect of polymer melt in a rectangular cross section micro mold channel

Heat transfer performance of liquid flow in multi-port micro-channel tubes

Exothermic characteristics of energy carrier for calcium looping thermo-chemical energy storage

Research on the characterization of the molecular weight and its distribution of perfluoropolyether

A two-stage dual-channel deep learning model for chemical fault classification

Related Author

ZHANG Zhengkai

ZOU Dejian

LI Minxia

YU Wenfang

SUN Han

DAI Baomin

DANG Chaobin

Related Institution

Key Laboratory of Efficient Utilization of Low and Medium Grade Energy, Ministry of Education, School of Mechanical Engineering, Tianjin University

School of Environmental and Energy Engineering, Beijing University of Technology

Department of Human and Engineered Environmental Studies, University of Tokyo

⁰