Heat transfer and flow characteristics in asymmetrical outward convex corrugated tubes

HAN Huaizhi; LI Bingxi; HE Yurong; BIE Rushan

doi:10.3969/j.issn.0438-1157.2013.06.004

您当前的位置：

首页 >

文章列表页 >

Heat transfer and flow characteristics in asymmetrical outward convex corrugated tubes

更新时间：2025-12-10

- Heat transfer and flow characteristics in asymmetrical outward convex corrugated tubes
- CIESC Journal Issue 6, Pages: 1916-1924(2013)
- 作者机构：
  
  哈尔滨工业大学能源学院,黑龙江,哈尔滨,150001
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2013.06.004
  CLC： Q028.8
- Online First：05 June 2013，
  
  Published：05 June 2013
- 稿件说明：
移动端阅览
HAN Huaizhi, LI Bingxi, HE Yurong, et al. Heat transfer and flow characteristics in asymmetrical outward convex corrugated tubes[J]. CIESC Journal, 2013, (6): 1916-1924.
DOI：

HAN Huaizhi, LI Bingxi, HE Yurong, et al. Heat transfer and flow characteristics in asymmetrical outward convex corrugated tubes[J]. CIESC Journal, 2013, (6): 1916-1924. DOI： 10.3969/j.issn.0438-1157.2013.06.004.

摘要

针对一种新型的非对称外凸式波节管(ACT)换热元件

基于三维RST模型对其进行了数值模拟研究。通过与传统的对称型外凸式波节管(SCT)分析比较

考察了两者流动及传热特性的区别。为了验证雷诺应力模型(RST)在研究波节管结构时的可靠性

比较了现有波纹壁面中直接数值模拟(DNS)与RST模型在同一条件下的计算结果。通过对比发现

RST模型得出的包括速度场、压力系数等计算结果与DNS所得出的结果基本吻合。随后对外凸型的流动及传热机理进行了深入探讨。结果表明

与传统的SCT相比

ACT提高综合传热性能最多能够提高32.3%。

Abstract

A new style asymmetrical outward convex corrugated tube (ACT) was studied with numerical simulation based on the three-dimensional Reynolds stress transport (RST) model.The ACT is compared with the traditional symmetrical corrugated tube (SCT) to investigate their difference in flow and heat transfer characteristics.The calculation results from existing direct numerical simulation (DNS) are compared to those from RST model under the same condition to check the reliability of RST model for the corrugation tube.The calculation results for velocity and pressure coefficient at different profiles from RST and DNS are in good agreement.The fluid flow and heat transfer mechanism are investigated in the outward convex corrugated tube.Compared to SCT

ACT presents up to 32.3% higher overall heat transfer.

关键词

Keywords

references

Views

339

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Direct numerical simulation of two-phase turbulence in a square duct under different interphase interactions

A review on direct numerical simulation of gas-liquid-solid fluidized bed

Experimental study on flow boiling in silicon-based microchannels with micropillar cluster arrays

Numerical study on flow and heat transfer characteristics in corrugated tube with loose-fit twisted tape insert

Analysis on compound heat transfer enhancement performance in outward convex corrugated tube with twisted insert

Related Author

HE Meng

CHEN Sheng

ZHAO Yanlin

YAO Jun

SHANG Haiyang

MA Yongli

AN Shu

YANG Jie

Related Institution

Technology Innovation Center of Risk Prevention and Control of Refining and Chemical Equipment, State Administration for Market Regulation, China Special Equipment Inspection and Research Institute

International Joint Laboratory on Clean Energy Science and Technology, Beijing Key Laboratory of Process Fluid Filtration and Separation, College of Mechanical and Transportation Engineering, China University of Petroleum-Beijing

State Key Laboratory of Chemical Engineering and Low-carbon Technology(Tianjin University)

School of Chemical Engineering and Technology, Tianjin University

School of Mechanical Engineering, Beijing Institute of Petrochemical Technology

⁰