Preparation and application of PEDOT/MWCNTs composite anode for MFC

LIU Xingqian; WANG Xuyun; GUO Qingjie

doi:10.3969/j.issn.0438-1157.2013.05.037

您当前的位置：

首页 >

文章列表页 >

Preparation and application of PEDOT/MWCNTs composite anode for MFC

更新时间：2025-12-10

- Preparation and application of PEDOT/MWCNTs composite anode for MFC
- CIESC Journal Issue 5, Pages: 1773-1779(2013)
- 作者机构：
  
  青岛科技大学化工学院, 清洁化工过程山东省高校重点实验室,山东,青岛,266042
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2013.05.037
  CLC： 646X382X703
- Online First：05 May 2013，
  
  Published：05 May 2013
- 稿件说明：
移动端阅览
LIU Xingqian, WANG Xuyun, GUO Qingjie. Preparation and application of PEDOT/MWCNTs composite anode for MFC[J]. CIESC Journal, 2013, (5): 1773-1779.
DOI：

LIU Xingqian, WANG Xuyun, GUO Qingjie. Preparation and application of PEDOT/MWCNTs composite anode for MFC[J]. CIESC Journal, 2013, (5): 1773-1779. DOI： 10.3969/j.issn.0438-1157.2013.05.037.

摘要

采用循环伏安法制备聚3

4-乙烯二氧噻吩/多壁碳纳米管(PEDOT/MWCNTs)导电复合物修饰石墨棒阳极

并应用于厌氧流化床微生物燃料电池(AFBMFC)中以考察其产电性能。采用场发射扫描电镜(FESEM)观察复合阳极的表面形貌及断面结构

并用循环伏安法(CV)和交流阻抗法(EIS)测试了碳纳米管加入前后修饰电极的电化学性能变化。结果表明

复合阳极在MFC中运行时

其最大输出功率密度达到217 mW·m-2

比未加碳纳米管的PEDOT修饰电极提高30%;相应的开路电压为837.8 mV

运行3 d后污水COD去除率达到96.4%

说明在液固流化床对传质的强化作用下

复合阳极在AFBMFC中具有良好的产电性能和污水处理效果

其中碳纳米管的加入在一定程度上提高了复合阳极的导电性及改善了微生物的附着情况。

Abstract

A poly(3

4-ethylenedioxythiophene)/multi-walled carbon nanotubes(PEDOT/MWCNTs)composite anode was prepared and used for modification of graphite rod via cyclic voltammetry

and applied in anaerobic fluidized bed microbial fuel cell(AFBMFC)to investigate its electricity generation performance.Field emission scanning electron microscopy(FESEM)was employed to characterize the surface morphology and cross-section structure of PEDOT/MWCNTs composite anode.The electrochemical behavior of the modified anodes with or without MWCNTs was studied by means of cyclic voltammetry(CV)and electrochemical impedance spectroscopy(EIS).The results showed that the performance of the composite anode was superior and its maximum output power density up to 217 mW穖-2

which was 30% higher than that of modified anode by PEDOT; The open circuit voltage was up to 837.8 mV.The COD removal rate reached 96.4% after MFC run 3 days.The results illustrated that the composite anode possessed good electricity generation performance and sewage treatment efficiency in the AFBMFC under the condition of mass transfer reinforcement depending on liquid-solid fluidized bed.In addition

the adding of carbon nanotubes improved the conductivity of composite anode and the state of microbial adhesion.

关键词

Keywords

references

Views

353

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Preparation and application of GO/PEDOT composite anode for MFC

Study on direct methanol fuel cell performance modification based on foam carbon diffusion layer

Power generation characteristics of central pulse gas-liquid-solid circulating fluidized bed microbial fuel cell

Investigation on the heating performance of the tube-free-evaporation based sorption thermal battery

Degradation characteristics of Cu-EDTA by coupling of photocatalysis and microbial fuel cell

Related Author

HUO Qingcheng

HUANG Renliang

QI Wei

SU Rongxin

HE Zhimin

ZHAO Zhengang

ZHOU Mengyao

JIN Dian

Related Institution

State Key Laboratory of Chemical Engineering, Tianjin University

School of Environmental Science and Engineering, Tianjin University

Chemical Engineering Research Institute, School of Chemical Engineering and Technology, Tianjin University

Faculty of Information Engineering and Automation, Kunming University of Science and Technology

Yunnan Key Laboratory of Green Energy, Electric Power Measurement Digitalization, Control and Protection

⁰