Adsorption characteristics of sodium lignosulfonate on TiO<sub>2</sub>/water interface

YANG Dongjie; WU Xiaolei; BAI Mengxian; YAN Mingfang; QIU Xueqing

doi:10.3969/j.issn.0438-1157.2013.04.031

您当前的位置：

首页 >

文章列表页 >

Adsorption characteristics of sodium lignosulfonate on TiO₂/water interface

更新时间：2025-12-10

- Adsorption characteristics of sodium lignosulfonate on TiO₂/water interface
- CIESC Journal Issue 4, Pages: 1351-1358(2013)
- 作者机构：
  
  1. 华南理工大学制浆造纸工程国家重点实验室,化学与化工学院,广东,广州,510640
  2. 广东药学院医药化工学院,广东,广州,510006
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2013.04.031
  CLC： 647.32O647.31+1
- Online First：05 April 2013，
  
  Published：05 April 2013
- 稿件说明：
移动端阅览
YANG Dongjie, WU Xiaolei, BAI Mengxian, et al. Adsorption characteristics of sodium lignosulfonate on TiO₂/water interface[J]. CIESC Journal, 2013, (4): 1351-1358. DOI: 10.3969/j.issn.0438-1157.2013.04.031.
DOI：

YANG Dongjie, WU Xiaolei, BAI Mengxian, et al. Adsorption characteristics of sodium lignosulfonate on TiO₂/water interface[J]. CIESC Journal, 2013, (4): 1351-1358. DOI: 10.3969/j.issn.0438-1157.2013.04.031. DOI：

摘要

木质素磺酸钠在固体表面的吸附特性决定了其应用性能

利用红外和紫外分光光度仪

采用剩余质量分数法研究了温度、pH值、无机盐和氢键破坏剂脲对木质素磺酸钠在TiO2/水界面吸附动力学和等温吸附性能的影响

初步探讨了其在固液界面的吸附作用机理。结果表明

该吸附为单层多点式吸附

随着温度升高和pH值减小

木质素磺酸钠在TiO2/水界面的吸附速率常数和饱和吸附量均增大

而离子强度的增大和脲的加入却使吸附速率常数减小;木质素磺酸钠在TiO2/水界面的吸附驱动力为静电、疏水和氢键作用

疏水作用力可显著增加其吸附量。

Abstract

The performance of sodium lignosulfonate (SL) in industrial applications is strongly related to its adsorption characteristics on surface of solid particles.To study its adsorption mechanisms on TiO2/water interface

the effect of temperature

pH value

ionic strength and urea on its adsorption equilibrium and kinetics were systematically investigated using residual mass fraction method.The results show that the mechanism of SL adsorption on TiO2/water interface is surface adsorption with mono-molecular layer. Its adsorption rate constant and saturation adsorption capacity increase with rising temperature or lowering pH value

in contrast

the increase of ionic strength and adding urea reduce adsorption rate constant.The main driving force for SL adsorption on TiO2/water interface is considered as synergistic effect of electrostatic and hydrophobic interactions as well as hydrogen bonding

and the hydrophobic interaction can significantly improve its adsorption performance.

关键词

Keywords

references

Views

881

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Investigation on adsorption characteristics of perfluoroalkyl surfactants

Preparation of TiO2/attapulgite composite photocatalyst by supercritical fluid drying method

Study on formation of polymeric TiO2-ZrO2 sols by small angle X-ray scattering

Recycling and reuse of TiO2 carrier from waste SCR catalysts used in coal-fired power plants

Study on controlled hydrolysis of titanium isopropoxide by small angle X-ray scattering

Related Author

GONG Zhiming

WANG Ruixiang

XING Meibo

ZHEN Wenyuan

LI Qing

DU Qianqian

GU Jinghua

MO Guang

Related Institution

Beijing Engineering Research Centre of Sustainable Energy and Buildings, School of Environment and Energy Engineering, Beijing University of Civil Engineering and Architecture

School of Material Science and Engineering, Beijing Institute of Fashion Technology

Institute of High Energy Physics, Chinese Academy of Sciences

School of Materials Science and Engineering, Beihang University

Sino-Danish Center for Education and Research

⁰

Adsorption characteristics of sodium lignosulfonate on TiO2/water interface

DOI：10.3969/j.issn.0438-1157.2013.04.031

摘要

Abstract

关键词

Keywords

references

Adsorption characteristics of sodium lignosulfonate on TiO₂/water interface