Numerical calculation and analysis of pressure drop of a single fiber under dust-loaded conditions

ZHU Hui; FU Haiming; KANG Yanming

doi:10.3969/j.issn.0438-1157.2012.12.027

您当前的位置：

首页 >

文章列表页 >

Numerical calculation and analysis of pressure drop of a single fiber under dust-loaded conditions

更新时间：2025-12-10

- Numerical calculation and analysis of pressure drop of a single fiber under dust-loaded conditions
- CIESC Journal Issue 12, Pages: 3927-3936(2012)
- 作者机构：
  
  1. 桂林航天工业学院汽车与动力工程系,广西,桂林,541004
  2. 东华大学环境科学与工程学院,上海,201620
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2012.12.027
  CLC： Q021TU834X701.2
- Online First：26 June 2012，
  
  Published：26 June 2012
- 稿件说明：
移动端阅览
ZHU Hui, FU Haiming, KANG Yanming. Numerical calculation and analysis of pressure drop of a single fiber under dust-loaded conditions[J]. CIESC Journal, 2012, (12): 3927-3936.
DOI：

ZHU Hui, FU Haiming, KANG Yanming. Numerical calculation and analysis of pressure drop of a single fiber under dust-loaded conditions[J]. CIESC Journal, 2012, (12): 3927-3936. DOI： 10.3969/j.issn.0438-1157.2012.12.027.

摘要

采用Monte Carlo法和Kuwabara单元模型

模拟了单纤维表面粉尘树枝结构的生长过程。在此基础上

考虑邻近粒子对粉尘树枝中单粒子阻力的影响

给出了荷尘状态单纤维过滤压降模拟模型。结果指出

对所有过滤情形

荷尘单纤维过滤压降随沉积量变化呈现两个阶段性特征;过滤风速、粒子大小和粉尘树枝形态结构对荷尘单纤维过滤压降影响显著;而纤维直径对荷尘单纤维过滤压降影响不明显。在获得单纤维过滤压降随沉积量变化关系后

求解了粒子在模型过滤器中的质量分布

建立了荷尘纤维过滤器过滤压降预测模型

并将模型计算结果与实验结果作了对比。结果表明

过滤风速在0.01~0.3 m·s-1范围内时

计算值与实验结果吻合较好

模型可适用于荷尘纤维过滤器的压降预测。

Abstract

The growth of particle dendrites on a single fiber during fibrous filtration was simulated by the Monte Carlo stochastic simulation and Kuwabara cell model.With the interactions between particles in the dendrites considered

the drag force contribution from each individual particle was calculated and analyzed.The results indicate that two steps may be distinguished in evolution of the pressure drop with deposit aspect for all filtration conditions studied.The variation of pressure drop is strongly depended upon filtration velocity

particle size and particle dendrite structure.However

in the range of fiber diameter concerned

there is no influence on the evolution of pressure drop.A new theoretical model for estimation of the pressure drop across the fibrous filter during clogging was developed with the understanding of the evolution of pressure drop for a dust-loaded fiber with deposit aspect.The model test shows that the calculated values are in good agreement with the experimental data for the filtration velocity from 0.01 m穝-1 to 0.3 m穝-1.It can be used for the prediction of pressure drop during fibrous filter clogging.

关键词

Keywords

references

Views

505

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Thermodynamic study of germanium-impurity competitive deposition in GeCl4-MxCly-H2 system

Performance study of gas-liquid vortex separators under low cross-sectional gas velocity

Mechanism and regulation of supercooling behavior in imidazolium-based ionic liquids

The impact of novel flow channel structure with sudden-expansion ratio on seawater-activated battery

Thermo-gas-elastic coupling performance analysis of high-speed and high-temperature foil face seals

Related Author

No data

Related Institution

No data

⁰