Influence of port angle on performance of gas wave ejector and prediction for optimal angle

赵文静

doi:10.3969/j.issn.0438-1157.2012.02.033

您当前的位置：

首页 >

文章列表页 >

Influence of port angle on performance of gas wave ejector and prediction for optimal angle

更新时间：2025-12-10

- Influence of port angle on performance of gas wave ejector and prediction for optimal angle
- CIESC Journal Issue 2, Pages: 572-577(2012)
- 作者机构：
  
  大连理工大学化工机械学院,辽宁,大连
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2012.02.033
  CLC： E934
- Online First：05 February 2012，
  
  Published：05 February 2012
- 稿件说明：
移动端阅览
赵文静. Influence of port angle on performance of gas wave ejector and prediction for optimal angle[J]. CIESC Journal, 2012, (2): 572-577.
DOI：

赵文静. Influence of port angle on performance of gas wave ejector and prediction for optimal angle[J]. CIESC Journal, 2012, (2): 572-577. DOI： 10.3969/j.issn.0438-1157.2012.02.033.

摘要

端口夹角是影响气波引射器性能的重要结构参数。本文通过数值模拟和实验研究探讨了端口夹角对气波引射器性能的影响机理，并得出了装置最佳端口夹角的预测方法。气波引射器存在一个最佳的端口夹角ψopt：当端口夹角大于该值时，等熵效率明显下降；若端口夹角小于最佳值，中压压力小于极值中压压力时，等熵效率随夹角的减小稍有降低，中压压力大于极值中压压力时，等熵效率急剧下降。数值模型的计算结果与实验值相一致，本文所建数值模型可准确预测最佳端口夹角。入口气体状态恒定时，最佳端口夹角不随中压压力的变化而改变，随转速的增大而线性增大。上述结论对气波引射器的设计和性能优化具有指导意义。

Abstract

The angle between high pressure port and middle pressure port is one of the most important structure parameters for gas wave ejector. In this study

the influence of this angle on the performance of gas wave ejector is analyzed by numerical simulation and experiment. The prediction method for the optimal angle is proposed. For any given conditions

there is an optimal angle ψopt. When the angle is greater than the optimal one

a reflected shock wave is generated and the isentropic efficiency of gas wave ejector decreases significantly; While the angle is less than the optimal one

the efficiency declines slightly for the case of lower middle pressure. However

if the middle pressure is higher than pM-extra

the pressure inside the channel after a cycle is lower than that at the middle pressure outlet. A compression wave is produced when the channel is exposed to the outlet

so the efficiency drops sharply as the port angle decreases. The calculation results agree well with the experiment data

so the model could predict the optimal angel effectively. When the temperature and pressure of the inflows are constant

the optimal angels at different middle pressure are almost the same

but increase linearly with the rotation speed. The above conclusions provide guidance for gas wave ejector design and optimization.

关键词

Keywords

references

Views

474

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Thermal enhanced air sparging for oil contamination remediation in shallow groundwater of cold regions

Characterization and modeling of limestone calcination and sulfation in oxy-fuel combustion atmosphere

Numerical study of Ar-He cryoprobe

Analyses on flow and heat transfer performance and entropy generation of heat exchanger with continuous helical baffles

Dynamic measurement of thermophysical properties of molten salt and error correction method

Related Author

CHU Tong

YANG Yuesuo

LU Ying

WU Yuhui

CHEN Yu

DU Xinqiang

GUO Taicheng

CHEN Liang

Related Institution

Key Laboratory of Groundwater Resources and Environment of Ministry of Education, Jilin University

Key Laboratory of Eco-restoration of Regional Contaminated Environment of Ministry of Education, Shenyang University

School of Energy Power and Mechanical Engineering, North China Electric Power University

Institute of Refrigeration and Cryogenics, Zhejiang University

山东大学热科学与工程研究中心

⁰