Resistance and cooling performance of ceiling cooling panel of capillary porosity wick

胡鹏

doi:10.3969/j.issn.0438-1157.2012.01.008

您当前的位置：

首页 >

文章列表页 >

Resistance and cooling performance of ceiling cooling panel of capillary porosity wick

更新时间：2025-12-10

- Resistance and cooling performance of ceiling cooling panel of capillary porosity wick
- CIESC Journal Issue 1, Pages: 59-63(2012)
- 作者机构：
  
  重庆大学低品位能源利用技术及系统教育部重点实验室
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2012.01.008
  CLC： K124
- Online First：05 January 2012，
  
  Published：05 January 2012
- 稿件说明：
移动端阅览
胡鹏. Resistance and cooling performance of ceiling cooling panel of capillary porosity wick[J]. CIESC Journal, 2012, (1): 59-63.
DOI：

胡鹏. Resistance and cooling performance of ceiling cooling panel of capillary porosity wick[J]. CIESC Journal, 2012, (1): 59-63. DOI： 10.3969/j.issn.0438-1157.2012.01.008.

摘要

基于现有空调系统耗能高，舒适性不够均匀，提出了多孔介质柠檬酸钾-石膏配制而成的毛细吸液芯辐射-冷却顶板，在用水作冷却介质时毛细吸液芯辐射-冷却顶板就成了一块内含多孔介质的均布流道。对以多孔介质孔隙率为55.3%的毛细吸液芯为例，水作为载冷剂流过毛细吸液芯冷却顶板进行了实验研究。介绍了毛细吸液芯冷却顶板的结构和内部配置，并通过搭建实验模型在维持室内温度（26±1）℃分布的情况下对其换热量进行了测试

分析了不同流量条件下流量与阻力的关系。结果表明，在冷水进口温度为10～16℃的条件下，相比常规蛇形辐射管，制冷量提高了36.6%～57.7%，当水流量从4 L·h-1变化到28 L·h-1时，黏性力减弱，摩擦因子逐渐减小，渗透率逐渐增大，但当流量从28 L·h-1变化到40 L·h-1时，渗透率开始减小。

Abstract

Since conventional air-conditioning consumes more energy and the temperature in a room is non-uniform

a new ceiling cooling panel of capillary porosity wick(CCPCPW)

which is configured by porous media of potassium citrate-gypsum

is used when water is the cooling medium.The CCPCPW with porosity of 55.3% was studied experimentally.The structure and different configurations of CCPCPW were presented and the cooling performance was tested when maintaining the indoor temperature distribution at （26±1）℃

and the relationship of flow rate and resistance was analyzed.The results show that the cooling capacity of the CCPCPW is increased by 36.6%—57.7% when the inlet temperature of cooling water is 10—16℃.The viscous force and friction factor gradually decrease and the permeability increases when the flow rate of cooling water is within 4—28 L·h-1

but the permeability is decreased when the flow rate is within 28—40 L·h-1

which indicates that the local resistance of curve part of pore channel is increased because of higher flow velocity.

关键词

Keywords

references

Views

453

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Permeability measurement method of crushed tight porous medium

Flow and clogging characteristics of oil-water droplet clusters in a dual-porous medium with both fractures and matrix

Promoting industrial application of MOF: scale-up preparation and shaping

Preparation of anti-biofouling reverse osmosis membrane by surface modification with quorum sensing inhibitor

Pore scale numerical simulations for wicking performance of metallic woven mesh

Related Author

ZHOU Bo

XU Ruina

JIANG Peixue

CHEN Nan

LI Yushuang

WANG Weiyi

WEN Boyao

LUO Zhengyuan

Related Institution

热科学与动力工程教育部重点实验室, 北京市二氧化碳资源利用与减排技术重点实验室, 清华大学热能工程系

State Key Laboratory of Multiphase Flow in Power Engineer, Xi’an Jiaotong University

Department of Chemical Engineering, College of Materials Science and Engineering, Beijing University of Technology

School of Chemical Engineering, Northeast Electric Power University

School of Chemical Engineering and Technology, Tianjin University

⁰