Effect of combination method of double-twisted blades on turbulent convective heat transfer

张静

doi:10.3969/j.issn.0438-1157.2011.z2.009

您当前的位置：

首页 >

文章列表页 >

Effect of combination method of double-twisted blades on turbulent convective heat transfer

更新时间：2025-12-10

- Effect of combination method of double-twisted blades on turbulent convective heat transfer
- CIESC Journal Issue S2, Pages: 52-60(2011)
- 作者机构：
  
  沈阳化工大学机械工程学院
- 作者简介：
- 基金信息：
- DOI：10.3969/j.issn.0438-1157.2011.z2.009
  CLC： K124
- Online First：20 December 2011，
  
  Published：20 December 2011
- 稿件说明：
移动端阅览
张静. Effect of combination method of double-twisted blades on turbulent convective heat transfer[J]. CIESC Journal, 2011, (S2): 52-60.
DOI：

张静. Effect of combination method of double-twisted blades on turbulent convective heat transfer[J]. CIESC Journal, 2011, (S2): 52-60. DOI： 10.3969/j.issn.0438-1157.2011.z2.009.

摘要

在圆管内一个截面上安装两个扭旋叶片的组合形式会产生多个纵向涡，纵向涡的形式与强弱受相邻两组叶片旋向和错位角的综合影响。为探究各种组合形式对湍流换热性能的影响，研究了6种不同组合形式某一截面上速度与温度梯度和压力梯度的协同程度，得出结论：错位角对Nu和压力降的影响明显大于叶片旋向的改变。在近壁区，增加错位角可以提高速度与温度梯度的协同程度，而且相邻两组叶片旋向相反形式优于旋向相同的形式；但旋向相同形式的速度与压力梯度的协同程度优于旋向相反形式，然而这种差距会随着错位角的增加而减小，当错位角为90°时，在y/R<0.75时协同程度非常接近。

Abstract

Multiple longitudinal vortex was made in a tube by double-twist elements incorporated in a section. Longitudinal vortex form and strength were affected by two adjacent twist elements rotate direction and dislocation angle. The effect of dislocation angle on Nusselt number and pressure drop was more significant than on the elements rotate direction. To study the influence of different combinations of twisted element on turbulent heat exchange performance

the coordination between velocity

temperature gradient and pressure gradient were studied using six different combinations of twisted element in a section. The results show that in the near wall region

increasing dislocation angle can improve the coordination between velocity and temperature gradient and two adjacent twist elements in opposite rotate direction are better than that in the same each other. For the coordination between velocity and pressure gradient

two adjacent twist elements in the same rotate direction are superior to that in opposite each other

but the difference decreases with the increasing dislocation angle. When the dislocation angle is 90°

the difference is minimal in the range of y/R < 0.75.

关键词

Keywords

references

Views

348

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Flow boiling heat transfer of phase separation structure microchannels under pulsating pressure

Preparation and heat transfer enhancement of phase change slurry with multi-phase change temperature

Research progress on heat transfer enhancement mechanism of spray cooling technology

Heat transfer and flow characteristics of nanofluids in microchannels

Investigation of enhanced boiling heat transfer on porous structural surfaces by high voltage electric field

Related Author

LUO Xiaoping

XIAO Lan

ZHANG Jiayu

FAN Jiayuan

ZENG Wenhui

REN Zhichao

ZHANG Wentao

LYU Shuang

Related Institution

School of Mechanical and Automotive Engineering, South China University of Technology

State Grid Sichuan Electric Power Company Economic and Technological Research Institute

School of Energy and Power Engineering, Jiangsu University

School of Mechatronics Engineering, Anhui University of Science and Technology

State Key Laboratory of Fine Chemicals, Liaoning Key Laboratory of Clean Utilization of Chemical Resources, School of Chemical Engineering, Dalian University of Technology

⁰