Radial differential pressure used in multiphase flow metering based on phase-isolation

WANG Shuai; WANG Dong; DONG Baoguang; LI Ruihua

doi:10.11949/j.issn.0438-1157.20180493

您当前的位置：

首页 >

文章列表页 >

Radial differential pressure used in multiphase flow metering based on phase-isolation

更新时间：2025-12-10

- Radial differential pressure used in multiphase flow metering based on phase-isolation
- CIESC Journal Issue 12, Pages: 5049-5055(2018)
- 作者机构：
  
  1. 中煤能源研究院有限责任公司,陕西,西安,710054
  2. 西安交通大学动力工程多相流国家重点实验室,陕西,西安,710049
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20180493
  CLC： 359
- Online First：05 December 2018，
  
  Published：05 December 2018
- 稿件说明：
移动端阅览
WANG Shuai, WANG Dong, DONG Baoguang, et al. Radial differential pressure used in multiphase flow metering based on phase-isolation[J]. CIESC Journal, 2018, (12): 5049-5055.
DOI：

WANG Shuai, WANG Dong, DONG Baoguang, et al. Radial differential pressure used in multiphase flow metering based on phase-isolation[J]. CIESC Journal, 2018, (12): 5049-5055. DOI： 10.11949/j.issn.0438-1157.20180493.

摘要

在管内相分隔技术产生的径向压差应用在单相流测量的基础上，以油水两相流为例，系统地研究了基于管内相分隔产生的径向压差在多相流测量的理论机理，并进行了实验验证。理论分析表明，在管内相分隔状态下，旋流器下游某截面壁面和管中心的径向压差与油水两相流的总质量流量和体积含油率呈一定函数关系，当测量出旋流器下游某截面壁面和管中心的径向压差后，若油水两相流的总质量流量和体积含油率中的任一参数已知，就可以求出另一参数。实验结果显示，在旋流器下游0.075 m和0.115 m的截面上，体积含油率的实验值与理论值的相对误差均在±8.02%以内，此时油水两相流总质量流量的实验值与理论值的相对误差均在±1.44%以内。

Abstract

The phase-isolation technology of multiphase flow in-pipe is widely used in scientific research and engineering area. Based on the application of the phase-isolation technology on single-phase flow measurement

the mechanism of radial differential pressure used in multiphase flow measurement was studied by taking oil-water two-phase flow as an example

and the experimental verification was carried out. The theoretical analysis showed that the radial differential pressure between the pipe wall and pipe center of a cross section downstream of the swirler has a functional relationship between the mass flowrate and oil cut. Once measuring the radial differential pressure between the pipe wall and pipe center of a cross section downstream of the swirler

the mass flowrate and oil cut can be determined if either of the two parameters was known. The experimental results showed that the relative error of oil cut was less than 8.02% for the cross section of 0.075 m or 0.115 m downstream of the swirler

and mass flowrate was less than 1.44%

which provides a theoretical basis for further study of the two-parameter measurement of multiphase flow.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Dual differential pressure used in multiphase flow double-parameter metering based on phase-isolation

Study on enhanced pool boiling heat transfer based on self-driven jet device

Study on breakup characteristics of charged ethanol-biodiesel droplets during combustion

Numerical study on heat and mass transfer characteristics of particle coating in a spray fluidized bed with draft plates

Study on flow mechanism of binary particles with large differences in draft tube fluidized beds

Related Author

Shuai WANG

Qingzhi LI

Jianying CHEN

Dong WANG

Pengman NIU

Baoguang DONG

SU Zeshi

GAO Ming

Related Institution

Xi’an Thermal Power Research Institute Co., Ltd.

State Key Laboratory of Multiphase Flow in Power Engineering, Xi’an Jiaotong University

School of Energy and Power Engineering, University of Shanghai for Science and Technology

School of Energy and Power, Jiangsu University of Science and Technology

School of Energy and Power Engineering, Jiangsu University

⁰