Analysis on inertia effect of carbon dioxide dry gas seal at high speed and pressure under laminar condition

XU Hengjie; SONG Pengyun; MAO Wenyuan; DENG Qiangguo; SUN Xuejian

doi:10.11949/j.issn.0438-1157.20180418

您当前的位置：

首页 >

文章列表页 >

Analysis on inertia effect of carbon dioxide dry gas seal at high speed and pressure under laminar condition

更新时间：2025-12-10

- Analysis on inertia effect of carbon dioxide dry gas seal at high speed and pressure under laminar condition
- CIESC Journal Issue 10, Pages: 4311-4323(2018)
- 作者机构：
  
  1. 昆明理工大学环境科学与工程学院,云南,昆明,650500
  2. 昆明理工大学化学工程学院,云南,昆明,650500
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20180418
  CLC： 277.9TH136
- Online First：05 October 2018，
  
  Published：05 October 2018
- 稿件说明：
移动端阅览
XU Hengjie, SONG Pengyun, MAO Wenyuan, et al. Analysis on inertia effect of carbon dioxide dry gas seal at high speed and pressure under laminar condition[J]. CIESC Journal, 2018, (10): 4311-4323.
DOI：

XU Hengjie, SONG Pengyun, MAO Wenyuan, et al. Analysis on inertia effect of carbon dioxide dry gas seal at high speed and pressure under laminar condition[J]. CIESC Journal, 2018, (10): 4311-4323. DOI： 10.11949/j.issn.0438-1157.20180418.

摘要

借鉴考虑惯性效应的气体止推轴承理论，以维里三项截断式描述二氧化碳的实际气体行为，同时考虑阻塞流效应和密封端面间气膜的黏度变化，采用有限差分法分别分析了层流状态下惯性效应对泵入式、泵出式螺旋槽干气密封稳态性能的影响规律，并与理想气体无惯性假设模型的计算结果进行了对比。结果表明：与理想气体相比，惯性效应对二氧化碳实际气体干气密封性能的影响程度更高。惯性效应使泵入式螺旋槽干气密封泄漏率和开启力均减小，而对泵出式螺旋槽干气密封的影响程度恰好相反。以泵入式螺旋槽干气密封为例，惯性效应对二氧化碳干气密封性能（泄漏率、开启力）的影响分别随密封压力和转速的增大而增强，随气膜厚度的增大而减小，密封压力为10 MPa，气膜厚度为3 μm，转速为20000 r·min-1时，惯性效应使泄漏率降低62.21%，开启力降低35.03%，使二氧化碳泵入式螺旋槽干气密封发生阻塞流动的临界进口压力提高。此外，二氧化碳的温度越接近其临界温度，惯性效应表现得越明显。

Abstract

The real gas property of carbon dioxide was expressed by third term virial equation

both the choked flow effect and the variation of gas viscosity were taken into account

the influence of inertia effect on the steady characteristics of pumping-inward and pumping-outward spiral groove dry gas seal (S-DGS) under laminar condition have been numerically investigated by referencing the theory of gas thrust bearing which considering inertia effect. Compared with the assumptions of ideal gas and inertialess

the results show that inertia effect induce a stronger influence on carbon dioxide real gas S-DGS. Inertia effect reduced leakage rate and opening force of pumping-inward S-DGS but the opposite was obtained for pumping-outward S-DGS. Taken pumping-inward S-DGS as example

the influence of inertia effect on the steady characteristics of carbon dioxide S-DGS (i.e. leakage rate and opening force) gradually enhanced with the increase of sealed gas pressure and rotational speed

while it being weaken with increased gas film thickness. The relative deviations of leakage rate and opening force caused by the inertia effect are 62.21% and 35.03% when sealed gas pressure is 10 MPa

gas film thickness is 3μm and rotational speed is 20000 r·min-1

and the critical entrance pressure which causes a choked flow at exit is improved. In addition

the closer the temperature of carbon dioxide is to its critical temperature

the more obvious the inertial effect is.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effects of the real-gas characteristics of carbon dioxide with impurities on the dry gas seal performance

Dynamic characteristics of spiral groove dry gas seals with consideration of hydrogen real gas and choked flow effects

Analysis of performance of spiral groove dry gas seal considered effects of both real gas and slip flow

Effect of real gas on dynamic performance of T-groove dry gas seal

Zn-doped PdO/ZrO2 with rich oxygen vacancies for the synthesis of diphenyl carbonate from CO2 and phenol

Related Author

Wei CHEN

Pengyun SONG

Hengjie XU

Xuejian SUN

SONG Pengyun

ZHANG Shuai

XU Hengjie

HU Xiaopeng

Related Institution

Faculty of Mechanical and Electrical Engineering, Kunming University of Science and Technology

State Key Laboratory of Heavy Oil Processing, China University of Petroleum

College of Mechanical and Electical Engineering, China Jiliang University

AECC Changjiang Engine Co., Ltd.

College of Mechanical Engineering, Zhejiang University of Technology

⁰