Effect of SCR on particulate matter emissions from a coal-fired boiler

LIU Fangqi; YU Dunxi; WU Jianqun; LEI Yu; WEN Chang; XU Minghou

doi:10.11949/j.issn.0438-1157.20180303

您当前的位置：

首页 >

文章列表页 >

Effect of SCR on particulate matter emissions from a coal-fired boiler

更新时间：2025-12-10

- Effect of SCR on particulate matter emissions from a coal-fired boiler
- CIESC Journal Issue 9, Pages: 4051-4057(2018)
- 作者机构：
  
  华中科技大学煤燃烧国家重点实验室,湖北,武汉,430074
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20180303
  CLC： 513
- Online First：05 September 2018，
  
  Published：05 September 2018
- 稿件说明：
移动端阅览
LIU Fangqi, YU Dunxi, WU Jianqun, et al. Effect of SCR on particulate matter emissions from a coal-fired boiler[J]. CIESC Journal, 2018, (9): 4051-4057.
DOI：

LIU Fangqi, YU Dunxi, WU Jianqun, et al. Effect of SCR on particulate matter emissions from a coal-fired boiler[J]. CIESC Journal, 2018, (9): 4051-4057. DOI： 10.11949/j.issn.0438-1157.20180303.

摘要

我国电厂多数采用选择性催化还原（SCR）脱硝技术降低电厂NOx排放，目前关于电厂中SCR对颗粒物排放特性的影响研究十分匮乏。本研究对一热电联产锅炉SCR前后颗粒物和飞灰进行取样，分析颗粒物质量粒径分布以及化学成分。采用计算机控制扫描电镜（CCSEM）对飞灰进行分析，获得颗粒物单颗粒成分。结果表明SCR前后PM10均呈双峰分布。经过SCR后，PM0.21浓度降低约62%（质量），而PM0.21-1浓度升高19%（质量）；PM1中SO2相对含量增加约6%（质量），SiO2和Al2O3相对含量降低，而CaO相对含量没有明显变化；经过SCR后，PM1-10浓度降低约17%（质量），成分基本没有变化，但是颗粒成分变得更均一，说明经过SCR后，PM1-10发生交互作用。因此经过SCR后PM1-10浓度降低不仅由于颗粒物在SCR中发生沉积，更有可能是颗粒物之间交互作用导致。

Abstract

Selective catalytic reduction (SCR) technology is usually used in coal combustion power plant to reduce NOx emission. The effects of SCR DeNOx on PM emission are still unclear. In this work

PM and fly ash before and after SCR was sampled. Particle size distribution (PSD) and chemical composition of PM was analyzed. Computer-controlled scanning electron microscope (CCSEM) was used to analyze the fly ash and obtain the composition distribution property of individual PM particles. The effect of SCR DeNOx on PM emission characteristic and its mechanism was investigated. The results show that PM is bimodal distribution before and after SCR. After the flue gas flows through the SCR

PM0.21 decreases 62%(mass) and PM0.21-1 increases 19%(mass). The relative amount of SO2 in PM1 increases 6%(mass) and SiO2 and Al2O3 decrease

while the variation of CaO is insignificant after SCR. The amount of PM1-10 decreases 17%(mass) after SCR. Insignificant change of its chemical composition is observed after SCR. However

the chemical composition distribution of individual PM1-10 particle becomes more homogeneous after SCR. It suggests that significant interaction between PM10 has happened in or after SCR. Therefore

decrease of PM1-10 after SCR is not only because of PM10 deposition in the SCR

but also because of particle interaction.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effects of Xinjiang high calcium coal co-firing on melting characteristics of Ca-bearing minerals in ash

Impacts of typical mineral matter in Zhundong coal on formation of particulate matter

Mineral transformation during Zhundong coal combustion by CCSEM

Contrastive analysis of reducing ultrafine particulate matters emission by two modified kaolin

Influence of O2/CO2 combustion on interaction of Ca and Fe in Shenhua coal

Related Author

Sheng CHEN

Dunxi YU

Jianqun WU

Yimin XIA

Yueming WANG

Minghou XU

XU Yishu

LIU Xiaowei

Related Institution

State Key Laboratory of Coal Combustion, Huazhong University of Science and Technology

Southern Research, National Carbon Capture Center (NCCC), Wilsonville

Department of Chemical Engineering and Institute for Clean and Secure Energy, University of Utah

School of Materials Science and Engineering, Jingdezhen Ceramic Institute

Electric Power Research Institute of Guangdong Grid Corporation

⁰