Condensation heat transfer characteristic and flow pattern of steam in rectangular tube with different aspect ratio

YAN Yan; DONG Jixian

doi:10.11949/j.issn.0438-1157.20180253

您当前的位置：

首页 >

文章列表页 >

Condensation heat transfer characteristic and flow pattern of steam in rectangular tube with different aspect ratio

更新时间：2025-12-10

- Condensation heat transfer characteristic and flow pattern of steam in rectangular tube with different aspect ratio
- CIESC Journal Issue 9, Pages: 3851-3858(2018)
- 作者机构：
  
  1. 西安工程大学机电学院,陕西,西安,710048
  2. 陕西科技大学机电学院,陕西,西安,710021
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20180253
  CLC： S734TK124
- Online First：05 September 2018，
  
  Published：05 September 2018
- 稿件说明：
移动端阅览
YAN Yan, DONG Jixian. Condensation heat transfer characteristic and flow pattern of steam in rectangular tube with different aspect ratio[J]. CIESC Journal, 2018, (9): 3851-3858.
DOI：

YAN Yan, DONG Jixian. Condensation heat transfer characteristic and flow pattern of steam in rectangular tube with different aspect ratio[J]. CIESC Journal, 2018, (9): 3851-3858. DOI： 10.11949/j.issn.0438-1157.20180253.

摘要

通过可视化流型观测及实验测量，研究了单边换热矩形小通道的高宽比对两相流型、平均冷凝传热系数及两相流动阻力的影响，采用高速摄像机拍摄了环状流、环波状流、波状流、弹状流、塞状流及泡状流6种典型流型。研究表明，高宽比为1：2及1：3的通道内出现流型种类较为全面，而在高宽比为1：5通道内基本无弹状流、塞状流及泡状流。1：5通道内环状流所占区域较1：2及1：3通道大，随入口蒸汽质量流速的增加，差值逐步减小。随着通道高宽比的减小，平均冷凝传热系数逐渐增大；不同高宽比通道中平均冷凝传热系数间的差值随入口蒸汽质量流速的增加而减小；蒸汽质量流速足够高时，高宽比对传热系数基本无影响。通道内两相流压降随通道高宽比的减小而增大；随着入口蒸汽质量流速的增加，不同比例通道内的两相流动压降差距逐渐增大。

Abstract

An investigation on single side condensation of vapor inside a horizontal rectangular tube was performed. The influences of tube aspect ratio on flow pattern

heat transfer coefficient and pressure drop were analyzed. Annular flow

annular-wave flow

wave flow

slug flow

plug flow and bubbly flow are observed. Flow pattern appearing in larger aspect ratio tube was more comprehensive than in small one. The area occupied by the annular flow increased with the decrease of the aspect ratio

but the difference gradually decreases with the increase of mass flow rates. Heat transfer coefficient and pressure drop increased with aspect ratio decreased while mass flow rate was small. With the mass flow rate increased

the difference for heat transfer coefficient decreased while for pressure drop increased.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Film condensation heat transfer characteristics of R1234ze(E) on a horizontal three-dimensional finned tube

Numerical simulation of two-phase steam ejector applied in novel loop heat pipe

Flue gas dehumidification through air cooling enhanced by hydrophobic ceramic membranes

Experimental research on influence of abnormal shape on heat transfer performance of copper-water heat pipe

Characteristic of condensation heat transfer of hybrid wettable patterned copper surfaces

Related Author

TIAN Haochen

MA Zhixian

WANG Zhihao

ZHOU Yao

YANG Xiaoping

NI Yicheng

LIU Jiping

WEI Jinjia

Related Institution

Institute of Building Energy, Dalian University of Technology

Key Laboratory of Thermo-Fluid Science and Engineering, Ministry of Education, Xi’an Jiaotong University

School of Chemical Engineering and Technology, Xi’an Jiaotong University

State Key Laboratory of Multiphase Flow in Power Engineering, Xi’an Jiaotong University

College of Chemical Engineering, Nanjing Tech University

⁰