Heat transfer characteristics of salt-bath structure heat exchanger in ascension pipe of coke oven

WU Daodong; LI Juxiang

doi:10.11949/j.issn.0438-1157.20171667

您当前的位置：

首页 >

文章列表页 >

Heat transfer characteristics of salt-bath structure heat exchanger in ascension pipe of coke oven

更新时间：2025-12-10

- Heat transfer characteristics of salt-bath structure heat exchanger in ascension pipe of coke oven
- CIESC Journal Issue 7, Pages: 2869-2877(2018)
- 作者机构：
  
  南京工业大学能源科学与工程学院,江苏,南京,211816
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171667
  CLC： K124
- Online First：05 July 2018，
  
  Published：05 July 2018
- 稿件说明：
移动端阅览
WU Daodong, LI Juxiang. Heat transfer characteristics of salt-bath structure heat exchanger in ascension pipe of coke oven[J]. CIESC Journal, 2018, (7): 2869-2877.
DOI：

WU Daodong, LI Juxiang. Heat transfer characteristics of salt-bath structure heat exchanger in ascension pipe of coke oven[J]. CIESC Journal, 2018, (7): 2869-2877. DOI： 10.11949/j.issn.0438-1157.20171667.

摘要

通过数值模拟及实际动态试验，研究了盐浴结构焦炉上升管换热器内的温度场和荒煤气流场，得到了换热器内温度和荒煤气速度的变化规律。研究结果表明，上升管换热器内荒煤气的流动处于层流入口段状态；沿上升管换热器径向，荒煤气温度在内筒壁及其扩展的直翅片附近迅速下降，在中心处的变化较小；直翅片的温度场呈现下部高、上部低、翅顶高、翅根低的趋势；整个炼焦周期内，上升管换热器的内筒壁温可控，可避免荒煤气中焦油蒸气的大量凝结。

Abstract

The flow and temperature distributions of coke oven gas (COG) in the salt-bath structure heat exchanger were investigated by numerical simulation and actual dynamic test. The variations of the temperature in the heat exchanger and the velocity of COG were obtained. The results showed that the COG was in the entrance region of laminar flow. The temperature of COG decreased sharply near the inner cylinder wall and the straight fins which welded on the wall

and the temperature gradient was small in the center of the heat exchanger along the radial direction. The temperature of the straight fins presented the higher tendency at the bottom and lower at the upper part along the axial direction

higher at the fin-top and lower at the fin-root along the radial direction at the same height. The temperature of inner cylinder wall in the heat exchanger could be controlled during the test

which could avoid a large amount of condensation from tar vapor in COG.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Comparative analysis of laminar flow and heat transfer characteristics in a circular tube with different shape vortex generators

Investigations of axial conduction effect on local heat transfer performance in PCHE

A multiscale approach for the thermo-mechanical coupling analysis of parallel-flow PCHE core

Simulation research on the boiling heat transfer characteristics of liquid sodium under microgravity

Improvement and numerical validation of quasi-steady-state frosting model based on thermal and mass transfer effect

Related Author

Yonghe WU

Zhimin LIN

Shushan LIU

Yongheng ZHANG

Liangbi WANG

Haiyan ZHANG

Jiangfeng GUO

Xiulan HUAI

Related Institution

School of Mechanical Engineering, Lanzhou Jiaotong University

Key Laboratory of Railway Vehicle Thermal Engineering, Ministry of Education

Institute of Engineering Thermophysics, Chinese Academy of Sciences

School of Engineering Science, University of Chinese Academy of Sciences

School of Science, Wuhan University of Science and Technology

⁰