Interfacial disturbance wave velocity of gas-liquid two-phase annular flow in vertical pipe

ZHAO Ning; WANG Peipei; GUO Suna; FANG Lide; WANG Dongxing; CHEN Xue

doi:10.11949/j.issn.0438-1157.20171574

您当前的位置：

首页 >

文章列表页 >

Interfacial disturbance wave velocity of gas-liquid two-phase annular flow in vertical pipe

更新时间：2025-12-10

- Interfacial disturbance wave velocity of gas-liquid two-phase annular flow in vertical pipe
- CIESC Journal Issue 7, (2018)
- 作者机构：
  
  河北大学质量技术监督学院,河北,保定,071002
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171574
  CLC： 359+.1TE645
- Online First：05 July 2018，
  
  Published：05 July 2018
- 稿件说明：
移动端阅览
ZHAO Ning, WANG Peipei, GUO Suna, et al. Interfacial disturbance wave velocity of gas-liquid two-phase annular flow in vertical pipe[J]. CIESC Journal, 2018, (7).
DOI：

ZHAO Ning, WANG Peipei, GUO Suna, et al. Interfacial disturbance wave velocity of gas-liquid two-phase annular flow in vertical pipe[J]. CIESC Journal, 2018, (7). DOI： 10.11949/j.issn.0438-1157.20171574.

摘要

在气液两相环状流中，界面波是两相间质量、动量和能量转移的重要载体，对其特性参数（波速、波频和波幅）的研究具有重要意义。首先根据气液两相流界面波分类，对其特征进行了定性描述。针对现有的界面剪切力推导了界面扰动波速度预测模型，考虑了气核中夹带液滴引起的密度增量及气核与液膜表面相对速度的影响，得到了改进的垂直管环状流扰动波速预测模型。针对工业现场工况压力较高现状，设计了基于近红外吸收衰减技术和互相关原理的界面波波速测量传感器，在五种压力（0.2～0.9 MPa） 154个界面波波动速度条件下进行了实验。结果表明，改进后模型预测效果良好，相对误差在±10%左右，在不同系统压力条件下具有一定外推性。

Abstract

In two-phase annular flow

interfacial waves play a crucial role in mass

momentum and energy transfers between two phases. It is important to study characteristic parameters of the interfacial waves (wave velocity

wave frequency and amplitude). First

interfacial waves were classified and qualitatively described characteristics of every wave type. Then

interfacial wave velocity prediction model was developed on the basis of interfacial shear stress. With consideration of density increment of gas core caused by entrained droplets and effect of relative velocities between gas core and liquid film surface

a modified disturbance wave velocity prediction model was obtained for vertical two-phase annular flow. Interfacial wave velocity measurement sensor based on near infrared (NIR) absorption attenuation technology and cross-correlation principle was designed for high operating pressure in industrial process. Measurements of 154 different interfacial wave velocities under five system pressures of 0.2-0.9 MPa showed that the modified model had good prediction results with less than ±10% relative standard deviations and some extrapolation capability for different system pressure conditions.

关键词

Keywords

references

Views

217

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Water quality prediction in wastewater treatment based on data decomposition and dung beetle optimized TCN-BiGRU/BiLSTM

Multi-objective optimization of amine-based desulfurization regeneration system integrated with heat pump technology

Mass transfer study of CO2 absorption by TETA/DEEA biphasic absorbent in the microchannel

Prediction of COD concentration in wastewater treatment plant effluent based on secondary decomposition and BiLSTM

Gas-liquid two-phase flow regimes and transformation mechanism in horizontal tube under fluctuating vibration

Related Author

FENG Xugang

TANG Lei

AN Shuo

YANG Ke

WANG Lu

TANG Dezhi

WANG Zhengbing

LIU Chuanwu

Related Institution

School of Electrical and Information Engineering, Anhui University of Technology, Ma’anshan

Anhui Province Key Laboratory of Special Heavy Load Robot, Ma’anshan

Engineering Research Institute, Anhui University of Technology, Ma’anshan

Ma’anshan Technical College, Ma’anshan

School of Chemistry and Chemical Engineering, Southwest Petroleum University

⁰