Flow and back-mixing characteristics in three dimensional up-flow reactor

WANG Weijie; YONG Yumei; YANG Chao; YU Kang

doi:10.11949/j.issn.0438-1157.20171270

您当前的位置：

首页 >

文章列表页 >

Flow and back-mixing characteristics in three dimensional up-flow reactor

更新时间：2025-12-10

- Flow and back-mixing characteristics in three dimensional up-flow reactor
- CIESC Journal Issue 1, Pages: 381-388(2018)
- 作者机构：
  
  1. 中国科学院过程工程研究所, 中国科学院绿色过程与工程重点实验室,北京,100190
  2. 中国科学院大学,北京,100049
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171270
  CLC： Q021.4
- Online First：05 January 2018，
  
  Published：05 January 2018
- 稿件说明：
移动端阅览
WANG Weijie, YONG Yumei, YANG Chao, et al. Flow and back-mixing characteristics in three dimensional up-flow reactor[J]. CIESC Journal, 2018, (1): 381-388.
DOI：

WANG Weijie, YONG Yumei, YANG Chao, et al. Flow and back-mixing characteristics in three dimensional up-flow reactor[J]. CIESC Journal, 2018, (1): 381-388. DOI： 10.11949/j.issn.0438-1157.20171270.

摘要

采用内径为280 mm的上流式反应器，以空气模拟气相、甘油和水混合溶液模拟渣油。用3种不同粒径的氧化铝球形工业催化剂颗粒为填充颗粒，考察了不同模拟物系的颗粒粒径、颗粒密度、液相黏度、不同床层的高径比和不同操作条件对上流式反应器内床层压降及其波动、床层轴向返混的影响规律。得到模拟工业运行物系和操作条件的上流式反应器床层总压降关联式，相对误差在12%以内。床层总压降均随床层高径比、颗粒密度和液相黏度增加而增大，但随颗粒粒径的增大而减小，床层压降波动随表观气速增加而增大。填充颗粒粒径越小、颗粒密度越小、高径比越大，床层内轴向返混越严重；床层内压降和轴向返混均随表观气速的增加而增大。

Abstract

Using an up-flow reactor with inner diameter of 280 mm

the industrial gas phase with air and the residual oil with the mixture of glycerol and water are simulated. The effects of particle size

particle density

liquid viscosity and the ratio of bed height to diameter under different operating conditions on the total bed pressure drop and its fluctuation

and the axial back-mixing were investigated in an up-flow reactor packed by alumina spherical catalyst particles. A correlation of pressure drop is obtained with the relative error below 12% which is suitable for gas-liquid-solid systems simulated industrial operating system and operating conditions in an up-flow reactor. The total pressure drop decreases with the increase of particle size

the ratio of height to diameter

particle density and liquid viscosity. The pressure fluctuation becomes stronger when the superficial gas velocity increases. The axial back-mixing in the reactor packed by smaller size and smaller density particles with the larger ratio of height to diameter is more serious. Both bed pressure drop and axial back-mixing increase with the increasing superficial gas velocity.

关键词

Keywords

references

Views

176

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Multi objective optimization of flow and heat transfer characteristics of modified manifold microchannel heat sink based on machine learning

Experimental study of heat transfer enhancement by pressure waves in cross flow tube bundles

Construction of a multi-physics coupling model for lithium-ion batteries based on strain response

Heat transfer characteristics of oblique droplet impact on liquid film

Flow characteristics and pigging performance degradation of high-concentration ice slurry in pipelines

Related Author

TANG Songzhen

ZHANG Feiyang

YAN Ji

ZHANG Muqiao

GUO Ming

ZHAO Linkun

GUO Xijian

DENG Jianqiang

Related Institution

School of Mechanical and Power Engineering, Zhengzhou University

BK21 FOUR ERICA-ACE Center, Hanyang University

School of Chemical Engineering and Technology, Xi’an Jiaotong University

Shaanxi Key Laboratory of Energy Chemical Process Intensification

School of Chemical Engineering, Sichuan University

⁰