Synchronous thickness measurements of flowing liquid film on horizontal surface by ultrasonic pulse-echo and laser absorption spectroscopy methods

SU Mingxu; MUHAMMAD Abdul Ahad; JIANG Yong; WU Wei; YANG Huinan

doi:10.11949/j.issn.0438-1157.20171251

您当前的位置：

首页 >

文章列表页 >

Synchronous thickness measurements of flowing liquid film on horizontal surface by ultrasonic pulse-echo and laser absorption spectroscopy methods

更新时间：2025-12-10

- Synchronous thickness measurements of flowing liquid film on horizontal surface by ultrasonic pulse-echo and laser absorption spectroscopy methods
- CIESC Journal Issue 7, Pages: 2972-2978(2018)
- 作者机构：
  
  上海理工大学能源与动力工程学院,上海,200093
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171251
  CLC： K31
- Online First：05 July 2018，
  
  Published：05 July 2018
- 稿件说明：
移动端阅览
SU Mingxu, MUHAMMAD Abdul Ahad, JIANG Yong, et al. Synchronous thickness measurements of flowing liquid film on horizontal surface by ultrasonic pulse-echo and laser absorption spectroscopy methods[J]. CIESC Journal, 2018, (7): 2972-2978.
DOI：

SU Mingxu, MUHAMMAD Abdul Ahad, JIANG Yong, et al. Synchronous thickness measurements of flowing liquid film on horizontal surface by ultrasonic pulse-echo and laser absorption spectroscopy methods[J]. CIESC Journal, 2018, (7): 2972-2978. DOI： 10.11949/j.issn.0438-1157.20171251.

摘要

液膜流动现象在工业过程中广泛存在，对流动液膜厚度测量方法的测量研究至关重要。首先利用已知液膜厚度的标准具（100～1000 μm）对超声脉冲反射法和激光吸收光谱法精度进行验证；结果表明，超声脉冲反射法测量液膜厚度的平均测量误差为1.07%，激光吸收光谱法测量液膜厚度的平均测量误差为1.29%。同时结合两种方法对流动液膜进行研究，结果表明，当液膜在低速/中速/高速流动时，两种方法测量流动液膜的平均厚度吻合良好，平均厚度差值分别为16.59、16.26、13.36 μm，流动液膜厚度的标准方差的相对偏差分别为0.29%、7.71%、25.37%，且在三种不同速度下两种方法测得在1s的周期内液膜波动次数一致。

Abstract

Because of common existence of liquid film flow in industrial processes

it's crucial to study methods for measuring thickness of moving liquid film. Measurement accuracy of both ultrasonic pulse-echo and laser absorption spectroscopy methods was validated by calibration standards of known film thicknesses (100-1000 μm). The coefficient of variation was 1.07% for ultrasonic pulse-echo method and 1.29% for laser absorption spectroscopy method. Then

thickness of flowing liquid film was measured by these two methods. The average film thicknesses were in good agreement for two methods when liquid film flow was at low/medium/high velocity. At three corresponding velocities

the difference of average film thicknesses between these two methods were 16.59

16.26 and 13.36 μm

and the relative standard deviation of film thickness was 0.29%

7.71% and 25.37%

respectively. Furthermore

both methods detected same number of fluctuations of liquid film within 1 s cycle at three different velocities.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experiment of thin film thermal sensor based on vacuum coating technology

Simultaneous measurement of film thickness and concentration of urea-water solution by laser spectroscopy

Research on the total heat recovery characteristics of fresh air based on modified PVDF membranes

Corrosion mechanisms of X65 steel welded joints in supercritical CO2 and H2O-rich phases

NOx emission prediction method of CFB unit based on 1D mechanism model dynamicly corrected with LSTM

Related Author

Xiao LUO

Hang GUO

Fang YE

Chongfang MA

YANG Huinan

GUO Xiaolong

YANG Bin

SU Mingxu

Related Institution

MOE Key Laboratory of Enhanced Heat Transfer and Energy Conservation, Beijing Key Laboratory of Heat Transfer and Energy Conversion, College of Environmental and Energy Engineering, Beijing University of Technology

School of Energy and Power Engineering, Shanghai Key Laboratory of Multiphase Flow and Heat Transfer in Power Engineering, University of Shanghai for Science and Technology

School of Thermal Engineering, Shandong Jianzhu University

College of Mechanical and Transportation Engineering, China University of Petroleum

College of Life Science & Biotechnology, Mianyang Teachers’ College

⁰