Visualized investigation of subcooled boiling in variable cross-section fin channels

LI Juan; ZHU Zhangyu; PENG Hao; LI Jia; LING Xiang

doi:10.11949/j.issn.0438-1157.20171249

您当前的位置：

首页 >

文章列表页 >

Visualized investigation of subcooled boiling in variable cross-section fin channels

更新时间：2025-12-10

- Visualized investigation of subcooled boiling in variable cross-section fin channels
- CIESC Journal Issue 6, Pages: 2404-2409(2018)
- 作者机构：
  
  1. 南京林业大学机械电子工程学院,江苏,南京,210037
  2. 南京工业大学机械与动力工程学院,江苏,南京,211816
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171249
  CLC： K172
- Online First：05 June 2018，
  
  Published：05 June 2018
- 稿件说明：
移动端阅览
LI Juan, ZHU Zhangyu, PENG Hao, et al. Visualized investigation of subcooled boiling in variable cross-section fin channels[J]. CIESC Journal, 2018, (6): 2404-2409.
DOI：

LI Juan, ZHU Zhangyu, PENG Hao, et al. Visualized investigation of subcooled boiling in variable cross-section fin channels[J]. CIESC Journal, 2018, (6): 2404-2409. DOI： 10.11949/j.issn.0438-1157.20171249.

摘要

以水为介质，对三角多孔翅片（TP）和横排锯齿翅片（TDS）两种变截面翅片通道的过冷沸腾进行了可视化试验。研究了体积流量、过冷度与热通量对过冷沸腾起始位置的影响，通过观察变截面翅片流道内单个气泡形成、生长与合并或脱离的过程，对比分析两种变截面翅片对流沸腾传热强化机理。试验结果表明：TDS翅片通道内气泡从出现到消失的平均周期约为TP翅片的一半；过冷沸腾起始位置随着体积流量的增大，逐渐向流道出口处移动；而随着热通量的增大和过冷度的减小逐渐靠近流道入口处；过冷度对过冷沸腾起始位置的影响比热通量对其的影响更大。

Abstract

The subcooled boiling of the two kinds of variable cross-section fin channels of triangular porous (TP) fin and transverse direction serrated(TDS) fin was visualized by water as working medium. The effects of volume flow

inlet subcooling degree and heat flux on the onset of the nucleate boiling were investigated. By observing the process of single bubble formation

growth and merging or disengagement in the variable cross-section fin channel

the boiling heat transfer enhancement mechanism was analyzed. The results show that the average cycle of bubbles from the appearance to disappearance in the TDS fin channel is around half of the TP fins; the onset of the nucleate boiling position gradually moves toward the outlet of the flow channel as the volume flow increases. By contrast

it gradually close to the inlet of the channel when the heat flux density increases and the inlet subcooling degree decreases. Furthermore

the effect of the inlet subcooling degree on the onset of the nucleate boiling is greater than that of the heat flux.

关键词

Keywords

references

Views

198

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Composite model of heat transfer and phase transition with high gas and liquid density ratio

Multi objective optimization of flow and heat transfer characteristics of modified manifold microchannel heat sink based on machine learning

Experimental study of heat transfer enhancement by pressure waves in cross flow tube bundles

Research on the characteristics and heat transfer of nucleate boiling bubbles on curved surfaces

Heat transfer characteristics of oblique droplet impact on liquid film

Related Author

LIU Bingbing

WANG Mingyu

GAO Hongtao

ZHANG Shaojun

TANG Songzhen

ZHANG Feiyang

YAN Ji

ZHANG Muqiao

Related Institution

College of Naval Architecture and Marine Engineering, Shandong Jiaotong University

Institute of Marine Engineering, Dalian Maritime University

School of Mechanical and Power Engineering, Zhengzhou University

BK21 FOUR ERICA-ACE Center, Hanyang University

School of Chemical Engineering and Technology, Xi’an Jiaotong University

⁰