Crystallization behaviors of molten ash slag under different temperatures and cooling rates

WANG Da; WANG Qian; ZHANG Jiansheng

doi:10.11949/j.issn.0438-1157.20171157

您当前的位置：

首页 >

文章列表页 >

Crystallization behaviors of molten ash slag under different temperatures and cooling rates

更新时间：2025-12-10

- Crystallization behaviors of molten ash slag under different temperatures and cooling rates
- CIESC Journal Issue 5, Pages: 2183-2190(2018)
- 作者机构：
  
  1. 清华大学热能工程系,北京,100084
  2. 清华大学山西清洁能源研究院,山西,太原,030032
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171157
  CLC： Q028.8
- Online First：05 May 2018，
  
  Published：05 May 2018
- 稿件说明：
移动端阅览
WANG Da, WANG Qian, ZHANG Jiansheng. Crystallization behaviors of molten ash slag under different temperatures and cooling rates[J]. CIESC Journal, 2018, (5): 2183-2190.
DOI：

WANG Da, WANG Qian, ZHANG Jiansheng. Crystallization behaviors of molten ash slag under different temperatures and cooling rates[J]. CIESC Journal, 2018, (5): 2183-2190. DOI： 10.11949/j.issn.0438-1157.20171157.

摘要

采用单热电偶在线观察系统（SHTT）、图像分析程序等研究等温过程中温度和连续冷却过程中冷却速率对于人工配制灰渣结晶行为的影响，通过计算结晶动力学参数分析其析晶机理，并采用FactSage软件预测晶体类型。实验结果表明，等温过程中，温度降低，结晶所需时间先减小后增大，晶体尺寸减小，结晶比例先增大再稳定最后减小，不同温度区间生成晶体类型不同，导致结晶比例在某些温度出现较大的变化。连续冷却过程中，冷却速率增大，初始结晶温度降低，晶体由块状向颗粒状转变，结晶比例先稳定后减小，由于析出的晶体类型不同，结晶比例出现多个稳定区间，达到临界冷却速率后熔渣全部凝固为玻璃态，无晶体析出。由DSC得到的熔渣结晶放热曲线与SHTT得到的结果吻合较好。

Abstract

The single hot thermocouple technique (SHTT) and image analysis program were applied to study synthetic slag's crystallization behaviors under different temperatures and cooling rates. In order to get crystallization mechanism

the crystallization kinetics parameters in isothermal process were calculated. Crystalline phases also were predicted by FactSage. In isothermal process

as temperature decreases

crystallization time decreases at first and increases later

and the crystals get smaller. At the same time

crystallization proportion increases at first

keeps stable later and decreases finally. There is saltation of crystallization proportion because of different crystalline phases at different temperature ranges. With increase of cooling rates

initial crystallization temperature declines and crystal turn from bulks to grains. Crystallization proportion remains unchanged

then decreases. Several stable areas of crystallization proportion appear owing to different crystalline phases under changing cooling rates. There is no crystal when cooling rate is large enough

and slag is totally solidified in glassy state. The heat curve of slag's crystallization measured by DSC fits well with the result of SHTT.

关键词

Keywords

references

Views

175

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Recent advances in machine learning for modeling and control of crystallization processes

Pharmaceutical polymorph control by supramolecular gel

Mechanochemical strategy for controlling solid-solid phase transition of α, ω-alkanedicarboxylic acids

Intelligent monitoring of crystallization processes based on in situ imaging and image analysis

Dynamic prediction method of particle size distribution in ternary precursor crystallization process based on population balance equations

Related Author

YAN Yihang

MA Yuan

LIU Chenglin

YU Jianguo

ZHANG Qi

ZHANG Xiangyang

LIN Jiawei

ZHUO Zhi’ao

Related Institution

National Engineering Research Center for Integrated Utilization of Salt Lake Resources, East China University of Science and Technology

Engineering Research Center of Resource Process Engineering, Ministry of Education, East China University of Science and Technology

State Key Laboratory of Chemical Engineering and Low-carbon Technology, East China University of Science andTechnology

School of Chemical Engineering and Technology, State Key Laboratory of Chemical Engineering and Low-Carbon Technology, Tianjin University

Beijing Key Laboratory of Enze Biomass Fine Chemicals, College of New Materials and Chemical Engineering, Beijing Institute of Petrochemical Technology

⁰