Preparation of TiO<sub>2</sub>/attapulgite composite photocatalyst by supercritical fluid drying method

ZHEN Wenyuan; LI Qing

doi:10.11949/j.issn.0438-1157.20171153

您当前的位置：

首页 >

文章列表页 >

Preparation of TiO₂/attapulgite composite photocatalyst by supercritical fluid drying method

更新时间：2025-12-10

- Preparation of TiO₂/attapulgite composite photocatalyst by supercritical fluid drying method
- CIESC Journal Issue 5, Pages: 2290-2298(2018)
- 作者机构：
  
  北京服装学院材料科学与工程学院,北京,100029
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171153
  CLC： 643
- Online First：05 May 2018，
  
  Published：05 May 2018
- 稿件说明：
移动端阅览
ZHEN Wenyuan, LI Qing. Preparation of TiO₂/attapulgite composite photocatalyst by supercritical fluid drying method[J]. CIESC Journal, 2018, (5): 2290-2298. DOI: 10.11949/j.issn.0438-1157.20171153.
DOI：

ZHEN Wenyuan, LI Qing. Preparation of TiO₂/attapulgite composite photocatalyst by supercritical fluid drying method[J]. CIESC Journal, 2018, (5): 2290-2298. DOI: 10.11949/j.issn.0438-1157.20171153. DOI：

摘要

以凹凸棒为载体，四氯化钛为钛源，通过溶胶-凝胶法结合超临界干燥法制备TiO2/凹凸棒复合光催化材料。采用XRD、SEM、TEM、BET、XPS等方法对材料的结构、形貌及催化性能进行表征。研究结果表明：超临界干燥可增大复合材料的比表面积，抑制TiO2发生晶型转变。凹凸棒吸附特性良好，增加了材料表面的活性位点，显著提高催化剂的光催化活性。不同煅烧温度下的TiO2均为锐钛矿型，粒径约为20 nm，呈不规则短棒状，成功负载于凹凸棒上。在400℃煅烧2 h条件下，催化剂3 h后对亚甲基蓝的降解率可达98.4%。

Abstract

TiO2/attapulgite nanocomposites were synthesized by the sol-gel method and supercritical fluid drying (SCFD) method using attapulgite as support and the aqueous solution of TiCl4 as raw material. The composition

morphological properties and catalytic performance of catalysts were characterized by X-ray diffraction (XRD)

scanning electron microscopy (SEM)

transmission electron microscopy (TEM)

X-ray photoelectron spectroscopy(XPS)

and nitrogen adsorption-desorption measurements. The results show that there are no phase transformation from anatase to rutile about samples

the specific surface area of materials was increased. The adsorption property of attapulgite is excellent

the quantity of active adsorption sites on the surface of the materials were increased. TiO2 calcined at different temperatures are all anatase

they have smaller particle size and short clavite structure. The photoactivity of the samples under UV light was evaluated by photocatalytic degradation of methylene blue in aqueous solution. The maximum photodegradation rate was obtained in the samples calcined at 400℃

it can reach 98.4% under the irradiation of ultraviolet light for 3 h.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Construction of transition metal-based nitrogen-doped carbon and their desulfurization performance

Characterization and oxygen evolution reaction performance of La2Ti2O7 synthesized by emulsion explosive detonation

Research progress on structural modulation and functionalized preparation of phenolic resin-based carbon microspheres

Preparation of hollow sulfur spheres-MoS2/rGO composite and its application in lithium-sulfur batteries

Progress in modified preparation and catalytic mechanism of nanocatalysts for hydrogen production from hydrous hydrazine

Related Author

JIN Changzhou

YIN Mengyang

WANG Haochen

SONG Jia

WANG Jingzhen

MA Shuanglong

HUANG Yan

WANG Quan

Related Institution

College of Resources and Environment, Henan Agricultural University

School of Chemical Engineering and Blasting, Anhui University of Science and Technology

School of Safety Science and Engineering, Anhui University of Science and Technology

Science and Technology on Advanced Ceramic Fibers and Composites Laboratory, College of Aerospace Science and Engineering, National University of Defense Technology

Beijing Key Laboratory for Chemical Power Source and Green Catalysis, Beijing Institute of Technology

⁰

Preparation of TiO2/attapulgite composite photocatalyst by supercritical fluid drying method

DOI：10.11949/j.issn.0438-1157.20171153

摘要

Abstract

关键词

Keywords

references

Preparation of TiO₂/attapulgite composite photocatalyst by supercritical fluid drying method