Application analysis of low temperature heat pump heating during heat pump drying

ZHOU Pengfei; ZHANG Zhentao; ZHANG Xuelai; YANG Luwei; WEI Juan; LIU Pengpeng

doi:10.11949/j.issn.0438-1157.20171125

您当前的位置：

首页 >

文章列表页 >

Application analysis of low temperature heat pump heating during heat pump drying

更新时间：2025-12-10

- Application analysis of low temperature heat pump heating during heat pump drying
- CIESC Journal Issue 5, Pages: 2032-2039(2018)
- 作者机构：
  
  1. 中国科学院理化技术研究所,北京,100190
  2. 上海海事大学蓄冷技术研究所,上海,201306
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171125
  CLC： K173
- Online First：05 May 2018，
  
  Published：05 May 2018
- 稿件说明：
移动端阅览
ZHOU Pengfei, ZHANG Zhentao, ZHANG Xuelai, et al. Application analysis of low temperature heat pump heating during heat pump drying[J]. CIESC Journal, 2018, (5): 2032-2039.
DOI：

ZHOU Pengfei, ZHANG Zhentao, ZHANG Xuelai, et al. Application analysis of low temperature heat pump heating during heat pump drying[J]. CIESC Journal, 2018, (5): 2032-2039. DOI： 10.11949/j.issn.0438-1157.20171125.

摘要

针对木材干燥中的不利工况，提高干燥系统的可靠性，根据两级压缩制冷循环原理，提出了低温热泵和干燥热泵的耦合应用方案。使用能量的（火用）损失模型，分别对干燥系统进行热量、干燥介质的质扩散和除湿过程的（火用）损失进行分析。在低温热泵20、22、24、26、28、30℃以及关闭低温热泵的供热情况下分别测试计算了干燥热泵压缩机的排气温度与能耗、热泵性能系数（COP）以及热力完善度，同时测得木材含水率下降1%，系统的干燥用时和能耗。结果表明：相比于关闭低温热泵，开启低温热泵后干燥热泵的排气温度最多减少了16℃，COP皆有所提高。由于主机室温度升高后，系统循环的不可逆程度增加，热力完善度随着供热温度增加逐渐降低。开启低温热泵后干燥热泵的供热量和用时比关闭低温热泵最大分别增加44%，减少46%。

Abstract

Pointing at the unfavorable conditions and improving the reliability of the drying system

a coupled application scheme of low-temperature heat pump(LTHP) and dry heat pump(DHP) is proposed

according to the principle of two stage compression refrigeration cycle. By using the exergy analysis model

the exergy loss of the heat

the mass diffusion of the drying medium and the dehumidification process were analyzed respectively to the drying system. With the LTHP at 20

30℃ and closed

the experiment tests and calculates the exhaust temperature and energy consumption of the compressor of DHP

coefficient of performance and the thermodynamic perfect degrees. The drying time and energy consumption of the system were measured when the water content of wood was decreased by 1%

at different heating temperatures. The results show that:compared with shutting down the LTHP

the exhaust temperature of the drying heat pump is reduced by 16℃ at most

and all the performance coefficient of the heat pump is improved. By the increase of the temperature of the machine hall

the irreversibility of the system cycle increases

and the thermodynamic perfect degrees decreases gradually. After opening the LTHP

the maximum amount of heating load and the drying time of the DHP increases by 44% and decreases by 46%

respectively.

关键词

Keywords

references

Views

131

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Drying characteristics and mathematical model of CaO-conditioned oil sludge

Theoretical study and performance comparison of different heat pump cycles using water as working fluid

Transcritical CO2 heat pump system with an ejector

Characteristics of outdoor air dehumidifier combined with heat pump system and solid desiccant plates

Simulation of cabbage seeds with heat pump drying

Related Author

LIU Chunyu

ZHOU Huanyu

MA Yue

YUE Changtao

Di WU

Bin HU

Ruzhu WANG

Jingjing YU

Related Institution

State Key Laboratory of Heavy Oil Processing, China University of Petroleum

Key Laboratory of Optical Detection Technology for Oil and Gas, China University of Petroleum

Shanghai Jiao Tong University Institute of Refrigeration and Cryogenic

Shanghai Hanbell Precise Machinery Co. Ltd.

Laboratory of Advanced Energy Systems, CAS Key Laboratory of Renewable Energy, Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences

⁰