Critical heat flux characteristics during flow boiling in a micro channel with micro pin fins

DU Baozhou; KONG Lingjian; GUO Baocang; LI Huijun; LIU Zhigang; LÜ Mingming

doi:10.11949/j.issn.0438-1157.20171013

您当前的位置：

首页 >

文章列表页 >

Critical heat flux characteristics during flow boiling in a micro channel with micro pin fins

更新时间：2025-12-10

- Critical heat flux characteristics during flow boiling in a micro channel with micro pin fins
- CIESC Journal Issue 5, Pages: 1989-1998(2018)
- 作者机构：
  
  1. 山东省科学院能源研究所,山东,济南,250014
  2. 华北电力大学能源动力与机械工程学院,河北,保定,071003
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20171013
  CLC： K124
- Online First：05 May 2018，
  
  Published：05 May 2018
- 稿件说明：
移动端阅览
DU Baozhou, KONG Lingjian, GUO Baocang, et al. Critical heat flux characteristics during flow boiling in a micro channel with micro pin fins[J]. CIESC Journal, 2018, (5): 1989-1998.
DOI：

DU Baozhou, KONG Lingjian, GUO Baocang, et al. Critical heat flux characteristics during flow boiling in a micro channel with micro pin fins[J]. CIESC Journal, 2018, (5): 1989-1998. DOI： 10.11949/j.issn.0438-1157.20171013.

摘要

以去离子水为工质，在质量流速G为96～224 kg·m-2·s-1，入口过冷度为20～50℃，有效热通量为10～240 W·cm-2的范围内，对圆形、菱形、椭圆形微肋阵通道内流动沸腾临界热通量（critical heat flux，CHF）特性进行了实验研究。临界热通量是通道出口壁面干涸造成的，而出口壁面的干涸是由于流动沸腾向通道上游的反向流动。出口壁温的剧增和两相压降的剧减标志着CHF的发生。此外研究发现质量流速、入口过冷度、微肋形状等实验参数对CHF也有着很大的影响。实验结果表明：在相同的实验工况条件下，微肋片的存在大大减小了沸腾的反向流动和流动沸腾的不稳定性，微肋阵通道的CHF比光滑微通道更高，且椭圆形微肋阵的CHF最大，菱形微肋阵次之，圆形微肋阵最小；CHF随着质量流速和入口过冷度的增大而增大，但随着出口干度的增大而减小。最后将实验数据文献中的关联式进行了比较验证，结果表明该实验数据与关联式吻合良好。

Abstract

Experiments were carried out to investigate the critical heat flux characteristics during flow boiling of deionized water in a micro channel with micro pin fins in the shape of circular

diamond

and ellipse

respectively. In the experiments

the mass flux ranges from 96 to 224 kg·m-2·s-1

the inlet subcooling ranges from 20 to 50℃

and the effective heat flux ranges from 10 to 240 W·cm-2. CHF is caused by dryout at the wall near the outlet of the microchannels

which in turn is attributed to the flow reversal upstream of the microchannels. The occurrence of CHF is marked by an abrupt increase in wall temperature near the outlet and an abrupt decrease in pressure drop across the microchannels. In addition

it is found that the experimental parameters such as mass flux

inlet subcooling

and the shape of micro fins also have a great influence on CHF. The experimental results show that the critical heat flux with micro channel of micro pin fins is higher than that of a smooth channel and the existence of micro fin greatly reduces flow reversal and subsequent instabilities in flow boiling. The CHF of the elliptical micro pin fins is the largest

and the circular micro pin fins is the smallest. The CHF increases with the increase of mass flux and inlet subcooling

but decreases with the increase of outlet quality. The experimental data are compared with the correlation proposed by Kosar et al. The results show that the experimental data are in good agreement with the correlation.

关键词

Keywords

references

Views

121

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental investigation on characteristics of R290 boiling heat transfer in horizontal micro-fin tubes with small diameter

Flow boiling heat transfer and pressure drop characteristics in micro channel with micro pin fins

Study on boiling characteristics of liquid crystal elastomer surfaces with thermally adaptive wettability

Simulation research on the boiling heat transfer characteristics of liquid sodium under microgravity

Study on two-phase flow heat transfer characteristics driven by microchannel bubble pump

Related Author

Lele WANG

Yuande DAI

Siyao TIAN

Qinhan LIN

GUO Baocang

CHEN Shuai

HU Yanwei

LIU Zihe

Related Institution

School of Mechanical and Electrical Engineering,Nanchang University

School of Energy Science Engineering, Harbin Institute of Technology

Suzhou Research Institute, Harbin Institute of Technology

School of Energy Science and Engineering, Harbin Institute of Technology

Heilongjiang Key Laboratory of New Energy Storage Materials and Processes

⁰