Formation and manipulation of ferrofluid droplets in Y-shaped flow-focusing microchannel

MA Rui; FU Taotao; ZHANG Qindan; LIU Cai; ZHU Chunying; MA Youguang

doi:10.11949/j.issn.0438-1157.20170938

您当前的位置：

首页 >

文章列表页 >

Formation and manipulation of ferrofluid droplets in Y-shaped flow-focusing microchannel

更新时间：2025-12-10

- Formation and manipulation of ferrofluid droplets in Y-shaped flow-focusing microchannel
- CIESC Journal Issue 2, Pages: 602-610(2018)
- 作者机构：
  
  化学工程联合国家重点实验室, 天津大学化工学院, 天津大学化工协同创新中心,天津,300072
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170938
  CLC： Q021.4
- Online First：05 February 2018，
  
  Published：05 February 2018
- 稿件说明：
移动端阅览
MA Rui, FU Taotao, ZHANG Qindan, et al. Formation and manipulation of ferrofluid droplets in Y-shaped flow-focusing microchannel[J]. CIESC Journal, 2018, (2): 602-610.
DOI：

MA Rui, FU Taotao, ZHANG Qindan, et al. Formation and manipulation of ferrofluid droplets in Y-shaped flow-focusing microchannel[J]. CIESC Journal, 2018, (2): 602-610. DOI： 10.11949/j.issn.0438-1157.20170938.

摘要

利用高速摄像仪研究了截面为400 μm×400 μm Y聚焦型微通道内磁流体液滴在矿物油中的生成过程。以水基磁流体EMG 807为分散相，含4%表面活性剂Span-20的矿物油为连续相。实验观察到了3种流型：弹状流、滴状流和喷射流。分别考察了两相流量、连续相毛细数及磁感应强度对液滴尺寸及生成过程的影响。结果表明：可通过改变两相流量及磁场调控液滴尺寸。当分散相流量不变时，液滴尺寸随着两相流量比的增加而减小。液滴尺寸随着连续相毛细数及磁感应强度的增加而减小，随着分散相流量的增加而增加。以两相流量比、连续相毛细数和磁Bond数为参数提出了一个液滴尺寸的关联式，预测值与实验值吻合良好。

Abstract

With high-speed camera

formation of ferrofluid droplets in mineral oil was studied in a Y-shaped microchannel with cross section of 400 μm×400 μm. In the system of water-based ferrofluid (EMG 807) as dispersed phase and mineral oil with 4%(mass) surfactant sorbitan lauric acid ester (Span-20) as continuous phase

three types of flow regimes were observed

i.e.

slug

dripping and jetting flows. Study of two-phase flow rates

capillary number of continuous phase and magnetic flux density on droplet size and formation process showed that both two-phase flow rates and magnetic field could regulate droplet size. At constant flow rate of the dispersed phase

droplet size decreased with increasing ratio of two-phase flow rates. The droplet size decreased with the increase of capillary number of continuous phase and magnetic flux density

but increased along with the increase of flow rate of the dispersed phase. A correlation of droplet size was proposed on parameters of two-phase flow rates

capillary number of continuous phase

and magnetic Bond number

which offered accurate prediction with experimental data.

关键词

Keywords

references

Views

224

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Review of research on liquid cooling technology for data centers

Synergistic mechanism in open microchannel and jet impingement hybrid cooling system

Liquid-liquid mixing characteristics of Bunsen reaction products in microchannels

Two-phase flow of emulsion flooding and its influencing factors in porous media

Experimental investigation of droplet formation in microchannel device with an embedded microsieve

Related Author

YANG Lei

YANG Hui

XU Jingfang

ZHU Xiujuan

LI Yifei

GUO Yuming

ZHAO Liang

ZHANG Ke

Related Institution

School of Environmental and Energy Engineering, Beijing University of Civil Engineering and Architecture

Digital Infrastructure Institute, Shanghai Posts Telecommunications Design Consulting Institute Company Limited

National Engineering Research Center for Residential Buildings and the Living Environment, China Architecture Design and Research Group

State Key Laboratory of Multiphase Flow in Power Engineering, Xi’an Jiaotong University

Automotive New Technology Research Institute, BYD Company Limited

⁰