Effect of surface wettability on heat transfer performance of oscillating heat pipe

JI Yulong; YU Chunrong; ZHANG Qingzhen; SUN Da

doi:10.11949/j.issn.0438-1157.20170665

您当前的位置：

首页 >

文章列表页 >

Effect of surface wettability on heat transfer performance of oscillating heat pipe

更新时间：2025-12-10

- Effect of surface wettability on heat transfer performance of oscillating heat pipe
- CIESC Journal Issue S1, Pages: 141-149(2017)
- 作者机构：
  
  大连海事大学轮机工程学院,辽宁,大连,116026
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170665
  CLC： K124
- Online First：31 August 2017，
  
  Published：31 August 2017
- 稿件说明：
移动端阅览
JI Yulong, YU Chunrong, ZHANG Qingzhen, et al. Effect of surface wettability on heat transfer performance of oscillating heat pipe[J]. CIESC Journal, 2017, (S1): 141-149.
DOI：

JI Yulong, YU Chunrong, ZHANG Qingzhen, et al. Effect of surface wettability on heat transfer performance of oscillating heat pipe[J]. CIESC Journal, 2017, (S1): 141-149. DOI： 10.11949/j.issn.0438-1157.20170665.

摘要

为了深入理解表面浸润性对脉动热管传热性能的影响，利用碱性辅助表面氧化技术，通过控制氢氧化钠和过硫酸铵溶液与铜表面反应浓度的变化，制备了具有不同浸润程度表面的脉动热管，其表面接触角分别为0°、33.9°、55.7°、84.3°。通过实验研究了表面浸润程度对脉动热管传热性能的影响。结果显示，随着脉动热管内部浸润性的增强，其脉动频率及幅度增加，脉动热管热阻及温差降低，传热性能得到强化。

Abstract

Experiments were performed to understand the influence of surface wettability on heat transfer performance of an oscillating heat pipe (OHP)

the alkali assistant surface oxidation technique was used to fabricate the surfaces. The surfaces with different wettability were obtained by control the concentration of the reaction solution of sodium hydroxide and ammonium persulfate. Different OHPs were obtained with the surface contact angles(CA) of 0°、33.9°、55.7°、84.3°

respectively. The effect of different degrees of surface wettability on heat transfer performance of oscillating heat pipe was investigated experimentally. The results show that the oscillating frequency and amplitude of the working fluid in the OHP increases as the CA increases. The thermal resistance and temperature difference of OHP decreases as the CA increases. Therefore

heat transfer performance of the OHP was enhanced as the CA increases.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Synergistic heat transfer enhancement characteristics due to electric field and macro-structured surface during thin film boiling

Heat transfer characteristics of topology optimized channel flat-plate pulsating heat pipe under local multiple heat sources

Experimental study on performance of new type of pulsating heat pipe for battery cooling

Experimental study on enhancement of flow boiling through degassing with copper foam

Research progress on optimizing two-phase refrigerant distribution and boiling heat transfer in microchannel evaporators

Related Author

HE Changqiu

TIAN Jiameng

CHEN Yiqi

ZHU Yuchen

LIU Xin

WANG Hai

WANG Zhentao

WANG Junfeng

Related Institution

School of Energy and Power Engineering, Jiangsu University

School of Energy and Power Engineering, Chongqing University

State Key Laboratory of Multiphase Flow in Power Engineering, Xi’an Jiaotong University

School of Energy and Power Engineering, Shandong University

School of Environmental Science and Engineering, Donghua University

⁰