Flow boiling pressure drop characteristics of CO<sub>2</sub> in horizontal micro tube

JIANG Linlin; LIU Jianhua; ZHANG Liang; ZHAO Yue

doi:10.11949/j.issn.0438-1157.20170613

您当前的位置：

首页 >

文章列表页 >

Flow boiling pressure drop characteristics of CO₂ in horizontal micro tube

更新时间：2025-12-10

- Flow boiling pressure drop characteristics of CO₂ in horizontal micro tube
- CIESC Journal Issue 12, Pages: 4576-4584(2017)
- 作者机构：
  
  1. 上海理工大学制冷技术研究所,上海,200093
  2. 上海市计量测试技术研究院,上海,200093
- 作者简介：
- 基金信息：
- DOI：10.11949/j.issn.0438-1157.20170613
  CLC： K121TB61+2
- Online First：05 December 2017，
  
  Published：05 December 2017
- 稿件说明：
移动端阅览
JIANG Linlin, LIU Jianhua, ZHANG Liang, et al. Flow boiling pressure drop characteristics of CO₂ in horizontal micro tube[J]. CIESC Journal, 2017, (12): 4576-4584. DOI: 10.11949/j.issn.0438-1157.20170613.
DOI：

JIANG Linlin, LIU Jianhua, ZHANG Liang, et al. Flow boiling pressure drop characteristics of CO₂ in horizontal micro tube[J]. CIESC Journal, 2017, (12): 4576-4584. DOI: 10.11949/j.issn.0438-1157.20170613. DOI：

摘要

对CO2在内径1.5 mm水平微细管内流动沸腾换热摩擦压降特性进行了实验研究。实验工况：热通量（7.5～30 kW·m-2）、质量流率（300～600 kg·m-2·s-1）、饱和温度（-40～0℃）。实验结果表明：热通量的增加对摩擦压降影响很小，几乎为零；质量流率是影响摩擦压降的最主要因素；随着饱和温度的升高摩擦压降减小；干度对摩擦压降影响主要由管内流型变化导致。将实测摩擦压降变化趋势绘制于CO2流态图中，比较发现理论预测摩擦压降最大值落在环状流末端区域。实验过程中对各个工况管内流态进行可视化研究，理论分析所采用的流态形式与实际CO2在微细通道内所具有的流态类型基本一致。

Abstract

The study on flow boiling frictional pressure drop characteristics of CO2 in horizontal micro tube which internal diameter is 1.5mm was made. Experimental conditions:heat flux(7.5-30 kW·m-2)

mass flow rate(300-600 kg·m-2·s-1)

and saturation temperature(-40~0℃). Experimental results show:The increase of heat flux makes little effect on frictional pressure drop

almost zero; mass flow rate is the main factor that affects frictional pressure drop; the frictional pressure drop decreases as the saturation temperature increases; the effect of vapor quality on the frictional pressure drop is mainly caused by the change of the flow pattern in the tube. The trend of the experimental measured frictional pressure drop is plotted in CO2 flow regime chart and it is found that the theoretical prediction of the maximum value of the frictional pressure drop falls in the end of the annular flow region. Making visible study on flow regime change in each working condition during the experiment process and the theoretical pattern is consistent with the flow pattern of the actual CO2 in the micro tube in general.

关键词

Keywords

references

Views

152

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Effect of sulfolane on CO2 absorption and desorption by monoethanolamine aqueous solution

Mechanism of nitric oxides reduction by carbon monoxide over cobalt oxides supported by CeO2 nanorod

Process intensification by coupling reaction and extraction for CO2 mineralization in Ca2+-rich solution

Molecular dynamics simulation for hydration effect on CO2 diffusion#br# in carbonic anhydrase

Influence of CO2 fraction on micro interfacial properties of miscible(CO2+n-hexane)/NaCl interface

Related Author

GUO Dongfang

GAO Shiwang

LUO Weiliang

CHEN Jian

CHENG Xingxing

ZHANG Xingyu

MA Chunyuan

WANG Luyuan

Related Institution

Huaneng Clean Energy Research Institute

State Key Laboratory of Chemical Engineering, Department of Chemical Engineering, Tsinghua University

School of Energy and Power Engineering, Shandong University

四川大学化学工程学院, 多相流传质与化学反应工程重点实验室

四川大学新能源与低碳技术研究院

⁰

Flow boiling pressure drop characteristics of CO2 in horizontal micro tube

DOI：10.11949/j.issn.0438-1157.20170613

摘要

Abstract

关键词

Keywords

references

Flow boiling pressure drop characteristics of CO₂ in horizontal micro tube